The reaction catalyzed by the protein phosphatase-1 (PP1) has been examined by linear free energy relationships and kinetic isotope effects. With the substrate 4-nitrophenyl phosphate (4NPP), the reaction exhibits a bell-shaped pH-rate profile for k cat /K M indicative of catalysis by both acidic and basic residues, with kinetic pK a s of 6.0 and 7.2. The enzymatic hydrolysis of a series of aryl monoester substrates yields a Brønsted β lg of -0.32, considerably less negative than that of the uncatalyzed hydrolysis of monoester dianions (-1.23). Kinetic isotope effects in the leaving group with the substrate 4NPP are 18 (V/K) bridge = 1.0170 and 15 (V/K) = 1.0010 which, compared against other enzymatic KIEs with and without general acid catalysis, are consistent with a loose transition state with partial neutralization of the leaving group. PP1 also efficiently catalyzes the hydrolysis of 4-nitrophenyl methylphosphonate (4NPMP). The enzymatic hydrolysis of a series of aryl methylphosphonate substrates yields a Brønsted β lg of -0.30, smaller than the alkaline hydrolysis (-0.69) and similar to the β lg measured for monoester substrates, indicative of similar transition states. The KIEs and the β lg data point to a transition state for the alkaline hydrolysis of 4NPMP that is similar to that of diesters with the same leaving group. For the enzymatic reaction of 4NPMP, the KIEs are indicative of a transition state that is somewhat looser than the alkaline hydrolysis reaction, and similar to the PP1-catalyzed monoester reaction. The data cumulatively point to enzymatic transition states for aryl phosphate monoester and aryl methylphosphonate hydrolysis reactions that are much more similar to one another than the nonenzymatic hydrolysis reactions of the two substrates.

We investigate the synthesis of kesterite Cu 2 ZnSnS 4 (CZTS) polycrystalline thin films using cosputtering from binary sulfide targets followed by annealing in sulfur vapor at 500°C to 650°C. The films are the kesterite CZTS phase as indicated by x-ray diffraction, Raman scattering, and optical absorption measurements. The films exhibit (112) fiber texture and preferred low-angle and R3 grain boundary populations which have been demonstrated to reduce recombination in Cu(In,Ga)Se 2 and CdTe films. The grain growth kinetics are investigated as functions of temperature and the addition of Na. Significantly, lateral grain sizes above 1 lm are demonstrated for samples grown on Na-free glass, demonstrating the feasibility for CZTS growth on substrates other than soda lime glass.

Cu2ZnSn(S,Se)4 (CZTSSe) is an earth-abundant semiconductor with potential for economical photovoltaic power generation at terawatt scales. In this work, we use Raman scattering to investigate phase coexistence in combinatorial CZTS thin films grown at 325 or 470 °C. The surface of the samples grown at 325 °C is rough except for a prominent specularly reflective band near and along the ZnS-Cu2SnS3 (CTS) tie line in the Cu-Zn-Sn-S quaternary phase diagram. All structurally incoherent secondary phases (SnS2, CuS) exist only as surface phases or are embedded as separate grains, whereas the structurally coherent secondary phase CTS coexists with CZTS in the dense underlying film. In films grown at 325 °C, which are kinetically trapped by the low growth temperature, a change is observed in Cu and Sn site occupancy, evidenced by the shift from cubic-CTS in the Cu-rich region (Cu/Sn > 2) to more tetragonal-CTS in the Sn-rich region (Cu/Sn < 2). For CZTS samples grown at 470 °C, CTS is not observed and regions grown under excess Sn flux are more disordered than Cu-rich regions evidenced by broader CZTS A mode peaks. Therefore, increasing Sn chemical potential results in more CZTS lattice disorder, suggesting, with other evidence, the formation of Sn antisite defects. In contrast, the CZTS A mode breadth is insensitive to Zn richness suggesting that excess Zn does not induce significant disorder within the CZTS lattice. We postulate that initially growing CZTS films Cu-rich (Cu/Sn > 2) results in higher cation ordering meaning fewer antisite defects.

Cu2ZnSnS4 is a promising low-cost, nontoxic, earth-abundant absorber material for thin-film solar cell applications. In this study, combinatorial coevaporation was used to synthesize individual thin-film samples spanning a wide range of compositions at low (325 °C) and high (475 °C) temperatures. Film composition, grain morphology, crystalline-phase and photo-excitation information have been characterized by x-ray fluorescence, scanning electron microscopy, x-ray diffraction, Raman spectroscopy, and photoluminescence imaging and mapping. Highly textured columnar grain morphology is observed for film compositions along the ZnS-Cu2ZnSnS4-Cu2SnS3 tie line in the quasi-ternary Cu2S-ZnS-SnS2 phase system, and this effect is attributed to structural similarity between the Cu2ZnSnS4, Cu2SnS3, and ZnS crystalline phases. At 475 °C growth temperature, Sn-S phases cannot condense because of their high vapor pressures. As a result, regions that received excess Sn flux during growth produced compositions falling along the ZnS-Cu2ZnSnS4-Cu2SnS3 tie line. Room-temperature photoluminescence imaging reveals a strong correlation for these samples between film composition and photoluminescence intensity, where film regions with Cu/Sn ratios greater than ∼2 show strong photoluminescence intensity, in comparison with much weaker photoluminescence in regions that received excess Sn flux during growth or subsequent processing. The observed photoluminescence quenching in regions that received excess Sn flux is attributed to the effects of Sn-related native point defects in Cu2ZnSnS4 on non-radiative recombination processes. Implications for processing and performance of Cu2ZnSnS4 solar cells are discussed.