No abstract

No abstract

Sensors based on proteins (GST-SmtA and MerR) with distinct binding sites for heavy metal ions were developed and characterized. A capacitive signal transducer was used to measure the conformational change following binding. The proteins were overexpressed in Escherichia coli, purified, and immobilized in different ways to a self-assembled thiol layer on a gold electrode placed as the working electrode in a potentiostatic arrangement in a flow analysis system. The selectivity and the sensitivity of the two protein-based biosensors were measured and compared for copper, cadmium, mercury, and zinc ions. The GST-SmtA electrodes displayed a broader selectivity (sensing all four heavy metal ions) compared with the MerR-based ones, which showed an accentuated selectivity for mercury ions. Metal ions could be detected with both electrode types down to femtomolar concentration. The upper measuring limits, presumably due to near saturation of the proteins' binding sites, were around 10(-10) M. Control electrodes similarly constructed but based on bovine serum albumin or urease did not yield any signals. The electrodes could be regenerated with EDTA and used for more than 2 weeks with about 40% reduction in sensitivity.

An apparent direct electron transfer between various electrode materials and peroxidases immobilized on the surface of the electrode has been reported in the last few years. An electrocatalytic reduction of hydrogen peroxide stars at about +600 mV versus a saturated calomel (reference) electrode (SCE) at neutral pH. The efficiency of the electrocatalytic current increases as the applied potential is made more negative and starts t o level off at about -200 mV versus SCE. Amperometric biosensors for hydrogen peroxide can be constructed with these types of peroxidase modified electrodes. By co-immobilizing a hydrogen peroxide-producing oxidase with the peroxidase, amperometric biosensors can be made that respond t o the substrate of the oxidase within a potential range essentially free of interfering electrochemical reactions. Examples of glucose, alcohol and amino acid sensors are shown.

It is reported for the first time that direct electron-transfer processes between a polypyrrole (PPY) entrapped quinohemoprotein alcohol dehydrogenase from Gluconobacter sp. 33 (QH-ADH) and a platinum electrode take place via the conducting-polymer network. The cooperative action of the enzyme-integrated prosthetic groups--pyrroloquinoline-quinone and hemes--is assumed to allow this electron-transfer pathway from the enzyme's active site to the conducting-polymer backbone. A hypothetical model of the electron transfer is proposed which is supported by the influence of various parameters, such as, e.g., ionic strength and nature of the buffer salts. This unusual electron-transfer pathway leads to an accentuated increase of the K M app value (102 mM) and hence to a significantly increased linear detection range of an ethanol sensor based on this enzyme.

No abstract

No abstract

No abstract