No abstract

Microwave sintering has emerged in recent years as a novel method for sintering a variety of materials that have shown significant advantages against conventional sintering procedures. This work involved an investigation of microwave hybrid fast firing of alumina-zirconia nanocomposites using commercial alumina powder and monoclinic nanometric zirconia. The suspensions were prepared separately in order to obtain 5, 10 and 15 vol.% of ZrO 2 in the alumina matrix. The samples were sintered in a 2 monomode microwave furnace at 2.45 GHz in air at different temperatures in the range 1200-1400 ºC with 10 min of dwelling time and 200 ºC/min of heating rate. The effect of sintering temperature in densification, mechanical properties and microstructure behaviour of the composites was investigated.Higher density, hardness and Young's modulus, excellent fracture toughness properties and homogeneous microstructure were achieved by microwave sintering in comparison to conventional heating. Microstructure analysis showed that the alumina grains had not grown significantly, indicating that the zirconia particles provided a hindering effect on the grain growth of alumina.

No abstract

No abstract

The objective of this study is to evaluate the influence of different chemical surface treatments (H 3 PO 4 , HNO 3 , and NaOH) in the formation of calcium phosphate phases on the surface of Al 2 O 3 /ZrO 2 (5 vol%) nanocomposite. For this purpose, Al 2 O 3 /ZrO 2 samples were shaped, calcined at 400°C, sintered at 1500°C, subjected to different chemical treatments, and biomimetically coated from 14 to 21 days. Surface characterization was performed by scanning electron microscopy, atomic force microscopy, confocal microscopy, X-ray diffraction, and infrared spectroscopy. It was observed that the preliminary chemical treatment favored the formation of particular calcium phosphate phases of interest, such as α-TCP (alpha-tricalcium phosphate), β-TCP (betatricalcium phosphate), and HA (hydroxyapatite). The differences among the percentages of the phases formed affected the homogeneity of calcium phosphate distribution within the nanocomposites as well as the roughness of the formed layer, effectively contributing to adhesion, proliferation, and desired cell biofixation on bone implant.