The largely adopted reversed-phase HPLC analysis of the molecular species of isothiocyanates (ITCs) was performed and showed losses during the chromatographic run with eight ITCs. These losses, which obviously impact the accuracy of quantitative determinations, were due to precipitation in the chromatographic system. At 22°C, they ranged from 5.4% for sulforaphane (SFN) to 11.0% for benzyl-ITC when ITCs were injected at 80 μg mL(-1) , but they were up to three times higher at 1 mg mL(-1) reaching 31.9% for benzyl-ITC. The water solubility of the ITCs was a key determinant of the extent of the measured loss. When the column was heated at 60°C, losses in injected ITCs were reduced, in comparison with 22, 40, and 50°C, by two to ten times depending on the ITC considered. A reversed-phase HPLC method based on column heating was suggested and its quantitative performance was determined. It was then applied to the separation of methylene chloride extracts of various cruciferous vegetables. Ally-ITC, SFN, and iberin in cabbage; SFN and iberin in cauliflower; and allyl-ITC and phenylethyl-ITC in horseradish could be identified and quantified. The obtained results cast doubt on quantitative determinations of ITCs that are carried out at room temperature using reversed-phase HPLC.

Numerous isothiocyanates (ITCs) are poorly soluble in water which causes their precipitation in aqueous mobile phases used in reversed phase liquid chromatography (RP-LC), thus impacting the accuracy of the quantification. By comparing the amounts of ITCs injected and released from the column, losses could be estimated at 5–32% depending on polarities and concentrations. Results could be dramatically improved in terms of separation and quantification using RP-LC with a mercaptoethanol precolumn derivatization aimed at avoiding ITCs precipitation. The cancer chemoprotective allyl-ITC and sulforaphane were found in cabbage extracts at 1.2 and 2.7 μg g−1 fresh weight, respectively.

Several SPE sorbents were investigated for the extraction of a group of chemically diverse isothiocyanates (ITCs). They included bonded silica, carbon-based, and polymer-based sorbents with various functional groups. Results showed large differences in the ability of these sorbents to simultaneously extract ITCs from standard solutions. Recovery rates were on average the highest with divinylbenzene (DVB) based polymeric sorbents, especially with a DVB/N-vinylpyrrolidone copolymer that had recovery rates ranging between 86.7 and 95.6%. These sorbents achieved the most balanced extraction efficiency between aliphatic and aromatic, polar, and nonpolar ITCs. With graphitized carbon, C(18)-bonded silica, and amide-containing sorbent, recovery levels were higher for the two least polar aromatic ITCs (benzyl ITC and phenylethyl ITC), whereas for the polar aliphatic ITCs levels were the lowest. The least retained one, was methyl ITC that is the most polar with recoveries between 0 and 31.5%. The presence of amide groups, especially in a polyamide sorbent, appeared to be particularly unsuitable for the extraction of aliphatic ITCs. A copolymer made up of DVB and N-vinylpyrrolidone was therefore shown to be the most suited for the extraction of both aliphatic and aromatic ITCs.