In the present paper we study the reactivity of model Pt nanoparticles supported on glassy carbon. The particle size effect is rationalized for CO monolayer oxidation exploring electrochemical methods (stripping voltammetry and chronoamperometry) and modelling. Significant size effects are observed in the particle size interval from ca. 1 to 4 nm, including the positive shift of the CO stripping peak with decreasing particle size and a pronounced asymmetry of the current transients at constant potential. The latter go through a maximum at low COads conversion and exhibit tailing, which is the longer the smaller the particle size. Neither mean field nor nucleation & growth models give a coherent explanation of these experimental findings. We, therefore, suggest a basic model employing the active site concept. With a number of reasonable simplifications a full analytical solution is obtained, which allows a straightforward comparison of the theory with the experimental data. A good correspondence between experiment and theory is demonstrated. The model suggests restricted COads mobility at Pt nanoparticles below ca. 2 nm size, with the diffusion coefficient strongly dependent on the particle size, and indicates a transition towards fast diffusion when the particle size exceeds ca. 3 nm. Estimates of relevant kinetic parameters, including diffusion coefficient, reaction constant etc. are obtained and compared to the literature data for extended Pt surfaces.

International audienceFuel cell electrocatalysts usually feature high noble metal contents, and these favour particle agglomeration. In this paper a variety of synthetic approaches (wet chemical deposition, electrodeposition and electrodeposition on chemically preformed Pt nuclei) is employed to shed light on the influence of nanoparticle agglomeration on their electrocatalytic properties. Pt loading on model glassy carbon (GC) support is increased systematically from 1.8 to 10.6 µg Pt cm^–2 and changes in the catalyst structure are followed by transmission electron microscopy. At low metal loadings (≤5.4 µg Pt cm^–2) isolated single crystalline Pt nanoparticles are formed on the support surface by wet chemical deposition from H₂PtCl₄ precursor. An increase in the metal loading results, first, in a systematic increase of the average diameter of isolated Pt nanoparticles and, second, in coalescence of nanoparticles and formation of particle agglomerates. This behaviour is in line with the previous observations on carbon-supported noble metal fuel cell electrocatalysts. The catalytic activity of Pt/GC electrodes is tested in CO monolayer oxidation. In agreement with the previous studies (F. Maillard, M. Eikerling, O. V. Cherstiouk, S. Schreier, E. Savinova and U. Stimming, Faraday Discuss., 2004, 125, 357), we find that the reaction is strongly size sensitive, exhibiting an increase of the reaction overpotential as the particle size decreases below ca. 3 nm. At larger particle sizes the dependence levels off, the catalytic activity of particles with diameters above 3 nm approaching that of polycrystalline Pt. Meanwhile, Pt agglomerates show remarkably enhanced catalytic activity in comparison to either isolated Pt nanopraticles or polycrystalline Pt foil, catalysing CO monolayer oxidation at ca. 90 mV lower overpotential. Enhanced catalytic activity of Pt agglomerates is ascribed to high concentration of surface defects. CO stripping voltammograms from Pt/GC electrodes, comprising Pt agglomerates along with isolated single crystalline Pt nanoparticles from 2 to 6 nm size, feature double voltammetric peaks, the more negative corresponding to CO oxidation on Pt agglomerates, while the more positive to CO oxidation on isolated Pt nanoparticles. It is shown that CO stripping voltammetry provides a fingerprint of the particle size distribution and the extent of particle agglomeration in carbon-supported Pt catalysts

No abstract

No abstract

Progress in the development of proton exchange membrane (PEM) water electrolysis technology requires decreasing the anode overpotential, where the sluggish multistep oxygen evolution reaction (OER) occurs. This calls for an understanding of the nature of the active OER sites and reaction intermediates, which are still being debated. In this work, we apply synchrotron radiation-based near-ambient pressure X-ray photoelectron and absorption spectroscopies under operando conditions in order to unveil the nature of the reaction intermediates and shed light on the OER mechanism on electrocatalysts most widely used in PEM electrolyzers-electrochemical and thermal iridium oxides. Analysis of the O K-edge and Ir 4f spectra backed by density functional calculations reveals a universal oxygen anion red-ox mechanism regardless of the nature (electrochemical or thermal) of the iridium oxide. The formation of molecular oxygen is considered to occur through a chemical step from the electrophilic O species, which itself is formed in an electrochemical step.

In this paper, we use Fourier transform infrared (FTIR) spectroscopy and stripping voltammetry at saturation and submonolayer CO coverages to shed light on the influence of size on the CO adsorption and electro-oxidation on Pt nanoparticles. Pt nanoparticles supported on low surface area (∼1 m2 g-1) carbon (Sibunit) are used throughout the study. The vibrational spectra of adsorbed CO are dominated by interparticle heterogeneity (contribution of particles of different size in the range from 0.5 to 5 nm) rather than intraparticle heterogeneity (contribution of different adsorption sites). CO stripping voltammetry exhibits two peaks separated by approximately 0.25 V (at 0.02 V s-1), which are attributed to the CO oxidation from “large” (∼3.6 nm) and “small” (∼1.7 nm) Pt nanoparticles. Using stepwise oxidation, we were able to separate the contributions of “large” and “small” nanoparticles and obtain their infrared and voltammetric “fingerprints”. Considerable differences are observed between “large” and “small” nanoparticles in terms of (i) the vibrational frequencies of adsorbed CO molecules (ii) their vibrational coupling, and (iii) CO oxidation overpotential.

No abstract

This work is part of a continued research aimed at the understanding of the promoting role of Se in the enhancement of the electrocatalytic activity of Ru in the oxygen reduction reaction. The objective of this paper is to systematically investigate the transformation of Ru nanoparticles upon their modification with the increasing amounts of Se. The Se-modified Ru/C samples with Se:Ru ratio from 0 to 1 were prepared by reacting carbon-supported Ru nanoparticles with SeO2 followed by reductive annealing and characterized using high-resolution transmission electron microscopy, energy-dispersive X-ray, X-ray diffraction analysis, X-ray photoelectron spectroscopy, and extended X-ray absorption fine structure. The results suggest that Se strongly interacts with Ru, resulting in the chemical bond between Ru and Se and formation of Ru selenide clusters whose core at low Se content can be described as Ru2Se2O0.5. At Se:Ru = 1, high-resolution electron microscopy shows evidence of formation of core-shell particles, comprising a hexagonally packed Ru core and a Ru selenide shell with lamellar morphology. Modification of Ru nanoparticles with Se enhances their electrocatalytic activity in the oxygen reduction reaction, which is explained by the role of Se in inhibiting surface oxidation.