No abstract

The state of the art approaches for tailoring the degradation of chitosan scaffolds are based on altering the chemical structure of the polymer. Nevertheless, such alterations may lead to changes in other properties of scaffolds, such as the ability to promote cell adhesion. The aim of this study was to investigate the influence of physical parameters such as porosity and fibre diameter on the degradation of chitosan fibre-mesh scaffolds, as a possible way of tailoring the degradation of such scaffolds. Four sets of scaffolds with distinct fibre diameter and porosity were produced and their response to degradation and cell adhesion was studied. The degradation study was carried out at 37degrees C in a lysozyme solution for five weeks. The extent of degradation was expressed as percentage of weight loss of the dried scaffolds after lysozyme treatment. Cell adhesion was assessed by Confocal Microscopy. The results have shown that the scaffolds with higher porosity degrade faster and that, within the same range of porosity, the fibres with smaller diameter degrade slightly faster. Furthermore, the morphological differences between the scaffolds did not affect the degree of cell adhesion, and the cells were observed throughout the thickness of all four types of scaffolds.

No abstract

A number of bone tissue engineering strategies use porous three-dimensional scaffolds in combination with bioreactor regimes. The ability to understand cell behaviour relative to strain profile will allow for the effects of mechanical conditioning in bone tissue engineering to be realized and optimized. We have designed a model system to investigate the effects of strain profile on bone cell behaviour. This simplified model has been designed with a view to providing insight into the types of strain distribution occurring across a single pore of a scaffold subjected to perfusion-compression conditioning. Local strains were calculated at the surface of the pore model using finite-element analysis. Scanning electron microscopy was used in secondary electron mode to identify cell morphology within the pore relative to local strains, while backscattered electron detection in combination with X-ray microanalysis was used to identify calcium deposition. Morphology was altered according to the level of strain experienced by bone cells, where cells subjected to compressive strains (up to 0.61%) appeared extremely rounded while those experiencing zero and tensile strain (up to 0.81%) were well spread. Osteoid mineralization was similarly shown to be dose dependent with respect to substrate strain within the pore model, with the highest level of calcium deposition identified in the intermediate zones of tension/compression.

No abstract