The phase transition between LiFePO4 and FePO4 during nonequilibrium battery operation was tracked in real time using time-resolved X-ray diffraction. In conjunction with increasing current density, a metastable crystal phase appears in addition to the thermodynamically stable LiFePO4 and FePO4 phases. The metastable phase gradually diminishes under open-circuit conditions following electrochemical cycling. We propose a phase transition path that passes through the metastable phase and posit the new phase's role in decreasing the nucleation energy, accounting for the excellent rate capability of LiFePO4. This study is the first to report the measurement of a metastable crystal phase during the electrochemical phase transition of LixFePO4.

No abstract

On the basis of the similarity between spinel and rocksalt structures, it is shown that some spinel oxides (e.g., MgCo2O4, etc) can be cathode materials for Mg rechargeable batteries around 150 °C. The Mg insertion into spinel lattices occurs via “intercalation and push‐out” process to form a rocksalt phase in the spinel mother phase. For example, by utilizing the valence change from Co(III) to Co(II) in MgCo2O4, Mg insertion occurs at a considerably high potential of about 2.9 V vs. Mg2+/Mg, and similarly it occurs around 2.3 V vs. Mg2+/Mg with the valence change from Mn(III) to Mn(II) in MgMn2O4, being comparable to the ab initio calculation. The feasibility of Mg insertion would depend on the phase stability of the counterpart rocksalt XO of MgO in Mg2X2O4 or MgX3O4 (X = Co, Fe, Mn, and Cr). In addition, the normal spinel MgMn2O4 and MgCr2O4 can be demagnesiated to some extent owing to the robust host structure of Mg1−xX2O4, where the Mg extraction/insertion potentials for MgMn2O4 and MgCr2O4 are both about 3.4 V vs. Mg2+/Mg. Especially, the former “intercalation and push‐out” process would provide a safe and stable design of cathode materials for polyvalent cations.

By utilizing ultrasonic annealing at a temperature below (or near) the glass transition temperature Tg, we revealed a microstructural pattern of a partially crystallized Pd-based metallic glass with a high-resolution electron microscopy. On the basis of the observed microstructure, we inferred a plausible microstructural model of fragile metallic glasses composed of strongly bonded regions surrounded by weakly bonded regions (WBRs). The crystallization in WBRs at such a low temperature under the ultrasonic vibrations is caused by accumulation of atomic jumps associated with the beta relaxation being resonant with the ultrasonic strains. This microstructural model successfully illustrates a marked increase of elasticity after crystallization with a small density change and a correlation between the fragility of the liquid and the Poisson ratio of the solid.

Pure Ti (99.4 pct) is processed by high-pressure torsion (HPT) at applied pressures in a wide range of 1.2 to 40 giga-pascals (GPa) for equivalent strain up to~200. X-ray diffraction (XRD) analysis clearly reveals that a pressure-induced phase transformation occurs from a phase to x phase during HPT processing when the applied pressure is more than~4 GPa and the straining facilitates this phase transformation. The hardness and the tensile strength increase, but the ductility decreases by the phase transformation. Hardness measurements demonstrate that all values obtained at each pressure fall on a single curve when they are plotted as a function of equivalent strain. The hardness increases with an increase in the equivalent strain at an early stage of straining and saturates to a constant level, where the hardness remains unchanged with further straining. It is shown that the saturation level as well as the onset of the saturation depends on the applied pressure.

No abstract

No abstract

Transient states of phase transition in LiFePO 4 /FePO 4 for lithium ion battery positive electrodes are investigated by timeresolved measurements. To directly detect changes in electronic and crystal structures under battery operation, in situ time-resolved X-ray absorption and diffraction measurements are performed, respectively. The phase fraction change estimated by the iron valence change is similar to the electrochemically expected change. The transient change of lattice constant during two phase reaction is clearly observed by the time-resolved X-ray diffraction measurement. The nonequilibrium lithium extraction behavior deviates from the thermodynamic diagram of the two phase system, resulting in continuous phase transition during electrochemical reactions.