In this paper, the effects and optimization of machining parameters on surface roughness and roundness in turning by wire EDM process are investigated. Surface roughness and roundness, were chosen, as the machining parameters to verify the process. In addition, power, time-off, voltage, servo, wire speed, wire tension and rotational speed were adopted for evaluation by Taguchi method. A L18 (21 × 37) Taguchi standard orthogonal array is chosen for the design of experiments. The level of importance of the machining parameters on the surface roughness and roundness is determined by using analysis of variance (ANOVA). The optimum machining parameters combination was obtained by using the analysis of signal-to-noise (S/N) ratio. The variation of surface roughness and roundness with machining parameters is mathematically modeled by using regression analysis method. Finally, experimentation was carried out to identify the effectiveness of the proposed method. A good improvement was obtained.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.