Results from the Fourth AIAA Drag Prediction Workshop (DPW-IV) are summarized. The workshop focused on the prediction of both absolute and differential drag levels for wing-body and wing-body-horizontal-tail configurations that are representative of transonic transport aircraft. Numerical calculations are performed using industry-relevant test cases that include liftspecific flight conditions, trimmed drag polars, downwash variations, dragrises and Reynoldsnumber effects. Drag, lift and pitching moment predictions from numerous Reynolds-Averaged Navier-Stokes computational fluid dynamics methods are presented. Solutions are performed on structured, unstructured and hybrid grid systems. The structured-grid sets include pointmatched multi-block meshes and over-set grid systems. The unstructured and hybrid grid sets are comprised of tetrahedral, pyramid, prismatic, and hexahedral elements. Effort is made to provide a high-quality and parametrically consistent family of grids for each grid type about each configuration under study. The wing-body-horizontal families are comprised of a coarse, medium and fine grid; an optional extra-fine grid augments several of the grid families. These mesh sequences are utilized to determine asymptotic grid-convergence characteristics of the solution sets, and to estimate grid-converged absolute drag levels of the wing-body-horizontal configuration using Richardson extrapolation.

No abstract

No abstract

No abstract

Results from the Fifth AIAA CFD Drag Prediction Workshop (DPW-V) are presented. As with past workshops, numerical calculations are performed using industry-relevant geometry, methodology, and test cases. This workshop focused on force/moment predictions for the NASA Common Research Model wing-body configuration, including a grid refinement study and an optional buffet study. The grid refinement study used a common grid sequence derived from a multiblock topology structured grid. Six levels of refinement were created resulting in grids ranging from 0.64x10 6 to 138x10 6 hexahedra -a much larger range than is typically seen. The grids were then transformed into structured overset and hexahedral, prismatic, tetrahedral, and hybrid unstructured formats all using the same basic cloud of points. This unique collection of grids was designed to isolate the effects of grid type and solution algorithm by using identical point distributions. This study showed reduced scatter and standard deviation from previous workshops. The second test case studied buffet onset at M=0.85 using the Medium grid (5.1x10 6 nodes) from the above described sequence. The prescribed alpha sweep used finely spaced intervals through the zone where wing separation was expected to begin. Some solutions exhibited a large side of body separation bubble that was not observed in the wind tunnel results. An optional third case used three sets of geometry, grids, and conditions from the Turbulence Model Resource website prepared by the Turbulence Model Benchmarking Working Group. These simple cases were intended to help identify potential differences in turbulence model implementation. Although a few outliers and issues affecting consistency were identified, the majority of participants produced consistent results.

No abstract

No abstract

Results from the Fourth AIAA Drag Prediction Workshop are summarized. The workshop focused on the prediction of both absolute and differential drag levels for wing-body and wing-body/horizontal-tail configurations of the NASA Common Research Model, which is representative of transonic transport aircraft. Numerical calculations are performed using industry-relevant test cases that include lift-specific flight conditions, trimmed drag polars, downwash variations, drag rises, and Reynolds-number effects. Drag, lift, and pitching moment predictions from numerous Reynolds-averaged Navier-Stokes computational fluid dynamics methods are presented. Solutions are performed on structured, unstructured, and hybrid grid systems. The structured-grid sets include point-matched multiblock meshes and overset grid systems. The unstructured and hybrid grid sets comprise tetrahedral, pyramid, prismatic, and hexahedral elements. Effort is made to provide a high-quality and parametrically consistent family of grids for each grid type about each configuration under study. The wing-body/horizontal families comprise coarse, medium, and fine grids; an optional extrafine grid augments several of the grid families. These mesh sequences are used to determine asymptotic grid-convergence characteristics of the solution sets and to estimate grid-converged absolute drag levels of the wing-body/horizontal configuration using Richardson extrapolation.