Spectrally resolved scattering of ultrafast K-alpha x-rays has provided experimental validation of the modeling of the compression and heating of shocked matter. The elastic scattering component has characterized the evolution and coalescence of two shocks launched by a nanosecond laser pulse into lithium hydride with an unprecedented temporal resolution of 10 picoseconds. At shock coalescence, we observed rapid heating to temperatures of 25,000 kelvin when the scattering spectra show the collective plasmon oscillations that indicate the transition to the dense metallic plasma state. The plasmon frequency determines the material compression, which is found to be a factor of 3, thereby reaching conditions in the laboratory relevant for studying the physics of planetary formation.

A fully kinetic particle-in-cell (PIC) model is used to self-consistently determine the steady-state potential profile in a collisionless plasma that contacts a floating, absorbing boundary. To balance the flow of particles to the wall, a distributed source region is used to inject particles into the one-dimensional system. The effect of the particle source distribution function on the source region and collector sheath potential drops, and particle velocity distributions is investigated. The ion source functions proposed by Emmert et al. [Phys. Fluids 23, 803 (1980)] and Bissell and Johnson [Phys. Fluids 30, 779 (1987)] (and various combinations of these) are used for the injection of both ions and electrons. The values of the potential drops obtained from the PIC simulations are compared to those from the theories of Emmert et al., Bissell and Johnson, and Scheuer and Emmert [Phys. Fluids 31, 3645 (1988)], all of which assume that the electron density is related to the plasma potential via the Boltzmann relation. The values of the source region and total potential drop are found to depend on the choice of the electron source function, as well as the ion source function. The question of an infinite electric field at the plasma–sheath interface, which arises in the analyses of Bissell and Johnson and Scheuer and Emmert, is also addressed.

Au foils were irradiated with a 100-TW, 100-fs laser at intensities greater than 10(20) W/cm2 producing proton beams with a total yield of approximately 10(11) and maximum proton energy of >9 MeV. Removing contamination from the back surface of Au foils with an Ar-ion sputter gun reduced the total yield of accelerated protons to less than 1% of the yield observed without removing contamination. Removing contamination from the front surface (laser-interaction side) of the target had no observable effect on the proton beam. We present a one-dimensional particle-in-cell simulation that models the experiment. Both experimental and simulation results are consistent with the back-surface acceleration mechanism described in the text.

A beam of high energy ions and protons is observed from targets irradiated with intensities up to 5×1019 W/cm2. Maximum proton energy is shown to strongly correlate with laser-irradiance on target. Energy spectra from a magnetic spectrometer show a plateau region near the maximum energy cutoff and modulations in the spectrum at approximately 65% of the cutoff energy. Presented two-dimensional particle-in-cell simulations suggest that modulations in the proton spectrum are caused by the presence of multiple heavy-ion species in the expanding plasma.

We demonstrated a high-pulse energy, femtosecond-pulse source based on optical parametric chirped-pulse amplification. We successfully amplified 1-microm broadband oscillator pulses to 31 mJ and recompressed them to 310-fs pulse duration, at a 10-Hz repetition rate. The gain in our system is 6 x 10(7), achieved by the single passing of only 40 mm of gain material pumped by a commercial Q-switched Nd:YAG laser. This relatively simple system replaces a more complex Ti:sapphire regenerative-amplifier-based chirped-pulse amplification system. Numerous features in design and performance of optical parametric chirped-pulse amplifiers make them a preferred alternative to regenerative amplifiers based on Ti:sapphire in the front end of high-peak-power lasers.

We present the first ultrafast temporally, spectrally, and angularly resolved x-ray scattering measurements from shock-compressed matter. The experimental spectra yield the absolute elastic and inelastic scattering intensities from the measured density of free electrons. Laser-compressed lithium-hydride samples are well characterized by inelastic Compton and plasmon scattering of a K-alpha x-ray probe providing independent measurements of temperature and density. The data show excellent agreement with the total intensity and structure when using the two-species form factor and accounting for the screening of ion-ion interactions.

This is a preprint of a paper intended for publication in a journal or proceedings. Since changes may be made before publication, this preprint is made available with the understanding that it will not be cited or reproduced without the permission of the author. This report has been reproduced directly from the best available copy.

Direct analysis of internal magnetic field pitch angles measured using the motional Stark effect diagnostic shows m=n ¼ 2=1 neoclassical tearing modes exhibit stronger poloidal magnetic flux-pumping than typical hybrids containing m=n ¼ 3=2 modes. This flux-pumping causes the avoidance of sawteeth, and is present during partial electron cyclotron current drive suppression of the tearing mode. This finding could lead to hybrid discharges with higher normalized fusion performance at lower q 95 . The degree of edge localized mode-neoclassical tearing mode (ELM-NTM) coupling and the strength of flux-pumping increase with beta and the proximity of the modes to the ELMing pedestal. Flux-pumping appears independent of magnetic island width. Individual ELM-NTM coupling events show a rapid timescale drop in the island width followed by a resistive recovery that is successfully modeled using the modified Rutherford equation. The fast transient drop in island width increases with ELM size.