This paper presents the synthesis of combinatorial libraries performed on a single-channel glass micro reactor under hydrodynamic flow control. The experiments were carried out in a non-well based micro chip and consisted of the preparation of libraries of pyrazoles by means of a Knorr reaction of 1,3-dicarbonyl compounds with hydrazines. The aim of this work is to investigate the capabilities of an automated micro reactor based system to synthesise sequentially multiple analogue reactions. Small slugs of reactants were introduced automatically by an autosampler in a serpentine-etched glass chip. The mobility of the reagents and products was achieved using hydrodynamic driven flow. Reaction slug dilution and UV slug detection took place at the outlet. A sample of the slug was analysed by using an on-line LC-UV-MS system. The degree of conversion was quantified using the UV signal and comparing with standards of starting materials and final products. After the LC-UV-MS analysis, the automated system proceeds to inject the slugs to carry out the next reaction programmed. The results suggest that the micro reactor system is capable of repeating the process of injection, mixing and reaction in an automated manner as many times as required.

This paper presents the first example known to the authors of a heated organic reaction performed on a glass microreactor under electro-osmotic flow control. The experiments consisted of the preparation of a series of 2-aminothiazoles by means of a Hantzsch reaction of ring-substituted 2-bromoacetophenones and 1-substituted-2-thioureas carried out in microchannels, with the aim of investigating the generic utility of the reactor in carrying out analogue reactions. The reactions were performed on T-design microchips etched into a thin borosilicate glass plate and sealed over with a thick borosilicate top plate containing reservoirs. The mobility of the reagents and products was achieved using electro-osmotic flow (EOF), with the driving voltages being generated by a computer-controlled power supply. During the experiments the T-shaped chip was heated at 70 C using a Peltier heater, aligned with the channels and the heat generated by this device was applied to the lower plate. The degree of conversion was quantified by LC-MS using UV detection by comparison with standard calibration curves for starting materials and final products. In all cases, conversions were found to be similar or greater than those found for equivalent macro scale batch syntheses, thus illustrating the potential of this heated microreactor system to generate a series of compounds which contain biologically active molecules.

Treatment of primary amines with tetramethylphenylguanidine (PhTMG) and a cyanophosphonate at -10 degrees Celsius under an atmosphere of carbon dioxide provides cyanoformamides in very high to excellent yields. The reaction proceeds efficiently within a short time. By-products were not detected in most runs and epimerization was not found when optically pure alpha-aminoesters were used as substrates. As an example, the reaction was applied to the synthesis of the marine natural product ceratinamine.

Treatment of amines under a carbon dioxide atmosphere with tetramethylphenylguanidine (PhTMG) and diphenylphosphoryl azide (DPPA) in acetonitrile below 0 degrees C provides carbamoyl azides in high to excellent yields. In addition, epimerization is not observed when optically pure alpha-amino esters are used as substrates.

No abstract