No abstract

Crop drying, especially maize drying, occurs at low external air temperatures, which are lower than the extract air temperature. Therefore, using heat exchangers, to recover thermal energy from the extract air to preheat the cold and dry external air, results in a significant reduction in the primary energy demand for crop drying. The measurements of air parameters in the crop dryer, with a drying capacity of 19 Mg/h of maize, confirm the assumptions undertaken for the production of the heat recovery system. We apply the cross-counter-flow surface heat exchanger system to provide a significant improvement in the efficiency of crop drying. We perform the analysis of the thermal energy recovery system operation. Our results indicate the influence of the drying air set-point and the crop specific humidity on the efficiency of energy recovery from the exhaust air. We performed our measurements at different drying air temperature set-points and different crop relative humidity.

Abstract. In the rooms with dominant sensible heat load, volume airflow depends on many factors incl. pre-established temperature difference between exhaust and supply airflow. As the temperature difference is getting higher, airflow volume drops down, consequently, the cost of AHU is reduced. In high industrial halls with air exhaust grids located under the ceiling additional temperature gradient above working zone should be taken into consideration. In this regard, experimental research of the vertical air temperature gradient in high industrial halls were carried out for the case of mixing ventilation system The paper presents the results of air temperature distribution measurements in high technological hall (mechanically ventilated) under significant sensible heat load conditions. The supply airflow was delivered to the hall with the help of the swirl diffusers while exhaust grids were located under the hall ceiling. Basing on the air temperature distribution measurements performed on the seven pre-established levels, air temperature gradient in the area between 2.0 and 7.0 m above the floor was calculated and analysed.