W połączeniach doczołowych dwuteowych elementów prętowych, w których śruby są sprężone, są powszechnie stosowane pełne blachy doczołowe. Naprężenia spawalnicze w tych blachach są przyczyną ich dużych deformacji w postaci braku płaskości ich powierzchni, co skutkuje najczęściej znacznym obniżeniem nośności i sztywności takiego styku. Poszukiwanie sposobu wyeliminowania niekorzystnych skutków braku płaskości pełnych blach doczołowych
w stykach sprężonych nie dało jak dotąd oczekiwanego rezultatu. W artykule przedstawiono nową koncepcję wykonywania doczołowych styków sprężonych i niesprężonych, w których dotychczas stosowane pełne blachy doczołowe zastąpi się króćcami teowymi, powstającymi poprzez przyspawanie głównie do półek belek blach o małych wymiarach. Omówiono zalety takiego rozwiązania oraz przedstawiono wstępne wyniki analiz numerycznych belek, w których zastosowano połączenia doczołowe z pełnymi blachami oraz z króćcami teowymi. Wyniki wstępnych badań doświadczalnych oraz numerycznych wskazują na to, że styki doczołowe z proponowanymi króćcami teowymi są dobrym rozwiązaniem problemów występujących w przypadkach stosowania pełnych blach doczołowych. Zaprezentowane innowacyjne rozwiązanie jest przedmiotem zgłoszenia patentowego o numerze P.431459.
The world’s first steel structures were built towards the end of the 19th century. Some of them are still in use today, whereas others are maintained as precious technical heritage. In both cases, there may be a need to assess their technical condition and carry out repairs and reinforcements, which requires an understanding of the properties of the steel used. The few studies that have been undertaken of such steel structures indicate that the properties depend on the history of use. This paper presents the results of metallographic tests of a steel tank in a water tower built in 1884 in Lower Silesia. The chemical composition was consistent with that of the puddled steel used in the 19th century. The carbon content showed significant segregation and ranged from 0.011% to 0.072% mass. As a consequence, a typical microstructure for low-carbon steels (ferritic) was observed, changing locally to ferritic-pearlitic. The tested steel contained a very high content of phosphorus and silicon. The microstructure with numerous slags favoured the formation of surface delamination caused by the corrosion processes. The degree of corrosion of the steel of the tank was also assessed, as well as the type of corrosion inside the tank. Corrosion was favoured by the oxygen concentration cell. The results of the research will be used to assess the potential for continuing tank use and the reinforcements that have been planned. The results presented will add to the somewhat limited research results available for steel dating back to the 19th century, which is still present in many building structures. Such a database is especially needed by those designing technical measures aimed at maintaining these historical structures in good technical condition.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.