Analysis and understanding of wall erosion, material transport and fuel retention are among the most important tasks for ITER and future devices, since these questions determine largely the lifetime and availability of the fusion reactor. These data are also of extreme value to improve the understanding and validate the models of the in vessel build-up of the T inventory in ITER and future D-T devices. So far, research in these areas is largely supported by post-mortem analysis of wall tiles. However, access to samples will be very much restricted in the next-generation devices (such as ITER, JT-60SA, W7-X, etc) with actively cooled plasma-facing components (PFC) and increasing duty cycle.This has motivated the development of methods to measure the deposition of material and retention of plasma fuel on the walls of fusion devices in situ, without removal of PFC samples. For this purpose, laser-based methods are the most promising candidates. Their feasibility has been assessed in a cooperative undertaking in various European associations under EFDA coordination. Different laser techniques have been explored both under laboratory and tokamak conditions with the emphasis to develop a conceptual design for a laser-based wall diagnostic which is integrated into an ITER port plug, aiming to characterize in situ relevant parts of the inner wall, the upper region of the inner divertor, part of the dome and the upper X-point region.
Eventhough 9 -12% Cr steels are mechanically designed for power plant applications up to 650 C, their effective use is limited by the corrosion resistance at this temperature. Therefore, the present paper addresses the development of diffusion coatings on 9% Cr ferritic-martensitic steels. The difficulty of coating these materials with conventional diffusion processes arises from the temperature limit above which the conversion of the martensite is accelerated and the mechanical properties would be deteriorated. Aluminide coatings consisting of Fe 2 Al 5 or FeAl phases were thus developed for deposition temperatures between 650 and 715 C by the conventional pack cementation technique. As the addition of boron was expected to improve the oxidation properties of the coating, the influence of B on the aluminide coating was investigated. The precedent diffusion of Cr as an interdiffusion barrier before switching to the Al diffusion step was also investigated. As a further technique, the fluidised bed chemical vapour deposition (FBCVD) method allowed the development of Fe 2 Al 5 coatings at 550 C. Furthermore, Si or codiffusion Al-Si coatings were developed at temperatures as low as 550 C.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.