The feasibility of manufacturing sintered ceramic tiles containing a high proportion of pulverised fuel ash (PFA) using conventional ceramic tile processing methods has been investigated at pilot plant scale. From earlier laboratory experiments, a composition containing 92?0 wt-%PFA, 5?0 wt-% sodium bentonite and 3?0 wt-% talc produced good quality small disc samples. The scale-up trials reported here used this same composition and involved deflocculant addition, wet milling, spray drying, pressing and firing, with the behaviour during each processing stage being characterised. Although there were no substantial technical problems associated with forming green tiles, the composition selected needed high levels of deflocculant and produced pressed samples with low green densities, resulting in high shrinkage during firing. The high dependence of shrinkage on temperature caused excessive tile distortion. In addition, sintered samples with less than 2% water absorption exhibited a bloating effect, resulting in poor surface quality. Possible solutions to the problems encountered during the pilot scale trials are considered and the potential commercial viability of high PFA content ceramic products is discussed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.