Nearly three-quarters of the growth in global carbon emissions from the burning of fossil fuels and cement production between 2010 and 2012 occurred in China. Yet estimates of Chinese emissions remain subject to large uncertainty; inventories of China's total fossil fuel carbon emissions in 2008 differ by 0.3 gigatonnes of carbon, or 15 per cent. The primary sources of this uncertainty are conflicting estimates of energy consumption and emission factors, the latter being uncertain because of very few actual measurements representative of the mix of Chinese fuels. Here we re-evaluate China's carbon emissions using updated and harmonized energy consumption and clinker production data and two new and comprehensive sets of measured emission factors for Chinese coal. We find that total energy consumption in China was 10 per cent higher in 2000-2012 than the value reported by China's national statistics, that emission factors for Chinese coal are on average 40 per cent lower than the default values recommended by the Intergovernmental Panel on Climate Change, and that emissions from China's cement production are 45 per cent less than recent estimates. Altogether, our revised estimate of China's CO2 emissions from fossil fuel combustion and cement production is 2.49 gigatonnes of carbon (2 standard deviations = ±7.3 per cent) in 2013, which is 14 per cent lower than the emissions reported by other prominent inventories. Over the full period 2000 to 2013, our revised estimates are 2.9 gigatonnes of carbon less than previous estimates of China's cumulative carbon emissions. Our findings suggest that overestimation of China's emissions in 2000-2013 may be larger than China's estimated total forest sink in 1990-2007 (2.66 gigatonnes of carbon) or China's land carbon sink in 2000-2009 (2.6 gigatonnes of carbon)

Calcination of carbonate rocks during the manufacture of cement produced 5% of global CO2 emissions from all industrial process and fossil-fuel combustion in 20131, 2. Considerable attention has been paid to quantifying these industrial process emissions from cement production2, 3, but the natural reversal of the process—carbonation—has received little attention in carbon cycle studies. Here, we use new and existing data on cement materials during cement service life, demolition, and secondary use of concrete waste to estimate regional and global CO2 uptake between 1930 and 2013 using an analytical model describing carbonation chemistry. We find that carbonation of cement materials over their life cycle represents a large and growing net sink of CO2, increasing from 0.10 GtC yr−1 in 1998 to 0.25 GtC yr−1 in 2013. In total, we estimate that a cumulative amount of 4.5 GtC has been sequestered in carbonating cement materials from 1930 to 2013, offsetting 43% of the CO2 emissions from production of cement over the same period, not including emissions associated with fossil use during cement production. We conclude that carbonation of cement products represents a substantial carbon sink that is not currently considered in emissions inventories1, 3, 4

No abstract

No abstract

Environmentally extended multiregional input-output (MRIO) analysis can be used to investigate final production and consumption attributions of emissions. As the distinction between the two attributions has been brought to the attention of policy-makers, there is an ever greater need to understand how and why they differ, by analyzing the connections between production and consumption activities. Seeking to meet this need, we present an approach for mapping flows of embodied emissions through a Leontief production system. The approach, seen as an extension of Structural Path Analysis (SPA), provides an exhaustive map of supply chain linkages between final production and consumption attributions of emissions. Whereas SPA is traditionally used to extract and rank individual supply chains according to the emissions occurring at the end of each chain, the mapping approach considers emissions embodied in the flows of intermediate products linking different economic sectors along supply chains. Illustrative results are presented from a global MRIO model and CO(2) emissions for 2004. The emissions embodied in a sector's total output of products is also of interest: a method for calculating this is presented and shown to provide further insight into where in the production system a sector's overall emissions impact is concentrated.

Input-output analysis is frequently used in studies of large-scale weather-related (e.g., Hurricanes and flooding) disruption of a regional economy. The economy after a sudden catastrophe shows a multitude of imbalances with respect to demand and production and may take months or years to recover. However, there is no consensus about how the economy recovers. This article presents a theoretical route map for imbalanced economic recovery called dynamic inequalities. Subsequently, it is applied to a hypothetical postdisaster economic scenario of flooding in London around the year 2020 to assess the influence of future shocks to a regional economy and suggest adaptation measures. Economic projections are produced by a macro econometric model and used as baseline conditions. The results suggest that London's economy would recover over approximately 70 months by applying a proportional rationing scheme under the assumption of initial 50% labor loss (with full recovery in six months), 40% initial loss to service sectors, and 10-30% initial loss to other sectors. The results also suggest that imbalance will be the norm during the postdisaster period of economic recovery even though balance may occur temporarily. Model sensitivity analysis suggests that a proportional rationing scheme may be an effective strategy to apply during postdisaster economic reconstruction, and that policies in transportation recovery and in health care are essential for effective postdisaster economic recovery.

China's unprecedented change offers a unique opportunity for uncovering relationships between economic growth and environmental pressure. Here we show the trajectories of China's environmental pressure and reveal underlying socioeconomic drivers during 1992-2010. Mining and manufacturing industries are the main contributors to increasing environmental pressure from the producer perspective. Changes in urban household consumption, fixed capital formation, and exports are the main drivers from the consumer perspective. While absolute decoupling is not realized, China has in general achieved relative decoupling between economic growth and environmental pressure. China's decoupling performance has four distinguishable periods, closely aligning with nation-wide major policy adjustments, which indicates significant impact of China's national socioeconomic policies on its environmental pressure. Material intensity change is the main contributor to the mitigation of environmental pressure, except for ammonia nitrogen, solid wastes, aquatic Cu, and aquatic Zn. Production structure change is the largest contributor to mitigate ammonia nitrogen emissions, and final demand structure change is the largest contributor to mitigate emissions of solid wastes, aquatic Cu, and aquatic Zn. We observe materialization trends for China's production structure and final demand structure during 2002-2007. Environmental sustainability can only be achieved by timely technology innovation and changes of production structure and consumption pattern.

Previous studies concluded that there was no evidence that the 1979 nuclear accident at Three Mile Island (TMI) affected cancer incidence in the surrounding area; however, there were logical and methodological problems in earlier reports that led us to reconsider data previously collected. A 10-mile area around TMI was divided into 69 study tracts, which were assigned radiation dose estimates based on radiation reading and models of atmospheric dispersion. Incident cancers from 1975 to 1985 were ascertained from hospital records and assigned to study tracts. Associations between accident doses and incidence rates of leukemia, lung cancer, and all cancer were assessed using relative dose estimates calculated by the earlier investigators. Adjustments were made for age, sex, socioeconomic characteristics, and preaccident variation in incidence. Considering a 2-year latency, the estimated percent increase per dose unit +/- standard error was 0.020 +/- 0.012 for all cancer, 0.082 +/- 0.032 for lung cancer, and 0.116 +/- 0.067 for leukemia. Adjustment for socioeconomic variables increased the estimates to 0.034 +/- 0.013, 0.103 +/- 0.035, and 0.139 +/- 0.073 for all cancer, lung cancer, and leukemia, respectively. Associations were generally larger considering a 5-year latency, but were based on smaller numbers of cases. Results support the hypothesis that radiation doses are related to increased cancer incidence around TMI. The analysis avoids medical detection bias, but suffers from inaccurate dose classification; therefore, results may underestimate the magnitude of the association between radiation and cancer incidence. These associations would not be expected, based on previous estimates of near-background levels of radiation exposure following the accident.Imagesp52-a