Neutron reflectivity (NR) and small angle neutron scattering (SANS) have been used to investigate the equilibrium surface adsorption behavior and the solution microstructure of mixtures of the anionic surfactant sodium 6-dodecyl benzene-4 sulfonate (SDBS) with the nonionic surfactants monododecyl octaethylene glycol (C12EO8) and monododecyl triiscosaethylene glycol (C12EO23). In the SDBS/C12EO8 and SDBS/C12EO23 solutions, small globular mixed micelles are formed. However, the addition of Ca2+ ions to SDBS/C12EO8 results in a transition to a vesicle phase or a mixed vesicle/micellar phase for SDBS rich compositions. In contrast, this transition hardly exists for the SDBS/C12EO23 mixture, and occurs only in a narrow composition region which is rich in SDBS. The adsorption of the SDBS/C12EO8 mixture at the air-solution interface is in the form of a mixed monolayer, with a composition variation that is not consistent with ideal mixing. In water and in the presence of NaCl, the nonideality can be broadly accounted for by regular solution theory (RST). At solution compositions rich in SDBS, the addition of Ca2+ ions results in the formation of multilayer structures at the interface. The composition range over which multilayer formation exists depends upon the Ca2+ concentration added. In comparison, the addition of a simple monovalent electrolyte, NaCl, at the same ionic strength does not have the same impact upon the adsorption, and the surface structure remains as a monolayer. Correspondingly, in solution, the mixed surfactant aggregates remain as relatively small globular micelles. In the presence of Ca2+ counterions, the variation in surface composition with solution composition is not well described by RST over the entire composition range. Furthermore, the mixing behavior is not strongly correlated with variations in the solution microstructure, as observed in other related systems.

Partially fluorinated cationic surfactants of the form C(n)F(2n+1)C(m)H(2m)N(CH3)Br have been prepared, and their behavior at the air-water interface has been studied using surface tension measurements and neutron reflectometry. The degree of fluorination has been varied while keeping the overall chain lengths similar. The results are compared with those previously obtained for C16H33N(CH3)Br (C16TAB). The structural studies show a decrease in molecular orientation with increasing fluorination. The mean tilt away from the surface normal varies from 55 degrees for C16TAB to 25 degrees for C8F17C6H12N(CH3)Br. The interfacial layer roughness is observed to be lower than that expected for a pure fluorocarbon surfactant.