The emergence of multidrug resistant bacteria compounded by the depleting arsenal of antibiotics has accelerated efforts toward development of antibiotics with novel mechanisms of action. In this report, we present a series of small molecular antibacterial peptoid mimics which exhibit high in vitro potency against a variety of Gram-positive and Gram-negative bacteria, including drug-resistant species such as methicillin-resistant Staphylococcus aureus and vancomycin-resistant Enterococcus faecium. The highlight of these compounds is their superior activity against the major nosocomial pathogen Pseudomonas aeruginosa. Nontoxic toward mammalian cells, these rapidly bactericidal compounds primarily act by permeabilization and depolarization of bacterial membrane. Synthetically simple and selectively antibacterial, these compounds can be developed into a newer class of therapeutic agents against multidrug resistant bacterial species.

The development of novel antimicrobial agents having high selectivity toward bacterial cells over mammalian cells is urgently required to curb the widespread emergence of infectious diseases caused by pathogenic bacteria. Toward this end, we have developed a set of cationic dimeric amphiphiles (bearing cleavable amide linkages between the headgroup and the hydrocarbon tail with different methylene spacers) that showed high antibacterial activity against human pathogenic bacteria (Escherichia coli and Staphylococcus aureus) and low cytotoxicity. The Minimum Inhibitory Concentrations (MIC) were found to be very low for the dimeric amphiphiles and were lower or comparable to the monomeric counterpart. In the case of dimeric amphiphiles, MIC was found to decrease with the increase in the spacer chain length (n = 2 to 6) and again to increase at higher spacer length (n > 6). It was found that the compound with six methylene spacers was the most active among all of the amphiphiles (MICs = 10-13 μM). By fluorescence spectroscopy, fluorescence microscopy, and field-emission scanning electron microscopy (FESEM), it was revealed that these cationic amphiphiles interact with the negatively charged bacterial cell membrane and disrupt the membrane integrity, thus killing the bacteria. All of the cationic amphiphiles showed low hemolytic activity (HC(50)) and high selectivity against both gram-positive and gram-negative bacteria. The most active amphiphile (n = 6) had a 10-13-fold higher HC(50) than did the MIC. Also, this amphiphile did not show any cytotoxicity against mammalian cells (HeLa cells) even at a concentration above the MIC (20 μM). The critical micellar concentration (CMC) values of gemini surfactants were found to be very low (CMC = 0.30-0.11 mM) and were 10-27 times smaller than the corresponding monomeric analogue (CMC = 2.9 mM). Chemical hydrolysis and thermogravimetric analysis (TGA) proved that these amphiphiles are quite stable under both acidic and thermal conditions. Collectively, these properties make the newly synthesized amphiphiles potentially superior disinfectants and antiseptics for various biomedical and biotechnological applications.

Quaternized polymers mimicking the antimicrobial peptides were created by tuning the side-chain amphiphilicity using a first-time approach of post-functionalization. They displayed excellent efficacy against pathogenic bacteria even in human plasma and membrane disruptive mode of action. The optimized polymers and degraded products were non-hemolytic.

Microbial attachment and subsequent colonization onto surfaces lead to the spread of deadly community-acquired and hospital-acquired (nosocomial) infections. Noncovalent immobilization of water insoluble and organo-soluble cationic polymers onto a surface is a facile approach to prevent microbial contamination. In the present study, we described the synthesis of water insoluble and organo-soluble polymeric materials and demonstrated their structure-activity relationship against various human pathogenic bacteria including drug-resistant strains such as methicillin-resistant Staphylococcus aureus (MRSA), vancomycin-resistant enterococci (VRE), and beta lactam-resistant Klebsiella pneumoniae as well as pathogenic fungi such as Candida spp. and Cryptococcus spp. The polymer coated surfaces completely inactivated both bacteria and fungi upon contact (5 log reduction with respect to control). Linear polymers were more active and found to have a higher killing rate than the branched polymers. The polymer coated surfaces also exhibited significant activity in various complex mammalian fluids such as serum, plasma, and blood and showed negligible hemolysis at an amount much higher than minimum inhibitory amounts (MIAs). These polymers were found to have excellent compatibility with other medically relevant polymers (polylactic acid, PLA) and commercial paint. The cationic hydrophobic polymer coatings disrupted the lipid membrane of both bacteria and fungi and thus showed a membrane-active mode of action. Further, bacteria did not develop resistance against these membrane-active polymers in sharp contrast to conventional antibiotics and lipopeptides, thus the polymers hold great promise to be used as coating materials for developing permanent antimicrobial paint.

No abstract

Cationic-amphiphilic antibacterial polymers with optimal amphiphilicity generally target the bacterial membranes instead of mammalian membranes. To date, this balance has been achieved by varying the cationic charge or side chain hydrophobicity in a variety of cationic-amphiphilic polymers. Optimal hydrophobicity of cationic-amphiphilic polymers has been considered as the governing factor for potent antibacterial activity yet minimal mammalian cell toxicity. However, the concomitant role of hydrogen bonding and hydrophobicity with constant cationic charge in the interactions of antibacterial polymers with bacterial membranes is not understood. Also, degradable polymers that result in nontoxic degradation byproducts offer promise as safe antibacterial agents. Here we show that amide- and ester (degradable)-bearing cationic-amphiphilic polymers with tunable side chain hydrophobicity can modulate antibacterial activity and cytotoxicity. Our results suggest that an amide polymer can be a potent antibacterial agent with lower hydrophobicity whereas the corresponding ester polymer needs a relatively higher hydrophobicity to be as effective as its amide counterpart. Our studies reveal that at higher hydrophobicities both amide and ester polymers have similar profiles of membrane-active antibacterial activity and mammalian cell toxicity. On the contrary, at lower hydrophobicities, amide and ester polymers are less cytotoxic, but the former have potent antibacterial and membrane activity compared to the latter. Incorporation of amide and ester moieties made these polymers side chain degradable, with amide polymers being more stable than the ester polymers. Further, the polymers are less toxic, and their degradation byproducts are nontoxic to mice. More importantly, the optimized amide polymer reduces the bacterial burden of burn wound infections in mice models. Our design introduces a new strategy of interplay between the hydrophobic and hydrogen bonding interactions keeping constant cationic charge density for developing potent membrane-active antibacterial polymers with minimal toxicity to mammalian cells.

The important role of hydrogen bonding in the interactions of cationic-amphiphilic polymers with bacterial membranes has been reported.

Synthetic polymers incorporating the cationic charge and hydrophobicity to mimic the function of antimicrobial peptides (AMPs) have been developed. These cationic-amphiphilic polymers bind to bacterial membranes that generally contain negatively charged phospholipids and cause membrane disintegration resulting in cell death; however, cationic-amphiphilic antibacterial polymers with endotoxin neutralization properties, to the best of our knowledge, have not been reported. Bacterial endotoxins such as lipopolysaccharide (LPS) cause sepsis that is responsible for a great amount of mortality worldwide. These cationic-amphiphilic polymers can also bind to negatively charged and hydrophobic LPS and cause detoxification. Hence, we envisaged that cationic-amphiphilic polymers can have both antibacterial as well as LPS binding properties. Here we report synthetic amphiphilic polymers with both antibacterial as well as endotoxin neutralizing properties. Levels of proinflammatory cytokines in human monocytes caused by LPS stimulation were inhibited by >80% when coincubated with these polymers. These reductions were found to be dependent on concentration and, more importantly, on the side-chain chemical structure due to variations in the hydrophobicity profiles of these polymers. These cationic-amphiphilic polymers bind and cause LPS neutralization and detoxification. Investigations of polymer interaction with LPS using fluorescence spectroscopy and dynamic light scattering (DLS) showed that these polymers bind but neither dissociate nor promote LPS aggregation. We show that polymer binding to LPS leads to sort of a pseudoaggregate formation resulting in LPS neutralization/detoxification. These findings provide an unusual mechanism of LPS neutralization using novel synthetic cationic-amphiphilic polymers.