Here, a general experimental method to determine the energy ECT of intermolecular charge‐transfer (CT) states in electron donor–acceptor (D–A) blends from ground state absorption and electrochemical measurements is proposed. This CT energy is calibrated against the photon energy of maximum CT luminescence from selected D–A blends to correct for a constant Coulombic term. It is shown that ECT correlates linearly with the open‐circuit voltage (Voc) of photovoltaic devices in D–A blends via eVoc = ECT − 0.5 eV. Using the CT energy, it is found that photoinduced electron transfer (PET) from the lowest singlet excited state (S1 with energy Eg) in the blend to the CT state (S1 → CT) occurs when Eg − ECT > 0.1 eV. Additionally, it is shown that subsequent charge recombination from the CT state to the lowest triplet excited state (ET) of D or A (CT → T1) can occur when ECT − ET > 0.1 eV. From these relations, it is concluded that in D–A blends optimized for photovoltaic action: i) the maximum attainable Voc is ultimately set by the optical band gap (eVoc = Eg − 0.6 eV) and ii) the singlet–triplet energy gap should be ΔEST < 0.2 eV to prevent recombination to the triplet state. These favorable conditions have not yet been met in conjugated materials and set the stage for further developments in this area.

The electro-optical properties of thin films of electron donor-acceptor blends of a fluorene copolymer (PF10TBT) and a fullerene derivative (PCBM) were studied. Transmission electron microscopy shows that in these films nanocrystalline PCBM clusters are formed at high PCBM content. For all concentrations, a charge transfer (CT) transition is observed with absorption spectroscopy, photoluminescence, and electroluminescence. The CT emission is used as a probe to investigate the dissociation of CT excited states at the donor-acceptor interface in photovoltaic devices, as a function of an applied external electric field and PCBM concentration. We find that the maximum of the CT emission shifts to lower energy and decreases in intensity with higher PCBM content. We explain the red shift of the emission and the lowering of the open-circuit voltage (V(OC)) of photovoltaic devices prepared from these blends with the higher relative permittivity of PCBM (epsilon(r) = 4.0) compared to that of the polymer (epsilon(r) = 3.4), stabilizing the energy (E(CT)) of CT states and of the free charge carriers in blends with higher PCBM concentration. We show that the CT state has a short decay time (tau = ca. 4 ns) that is reduced by the application of an external electric field or with increasing PCBM content. The field-induced quenching can be explained quantitatively with the Onsager-Braun model for the dissociation of the CT states when including a high electron mobility in nanocrystalline PCBM clusters. Furthermore, photoinduced absorption spectroscopy shows that increasing the PCBM concentration reduces the yield of neutral triplet excitons forming via electron-hole recombination, and increases the lifetime of radical cations. The presence of nanocrystalline domains with high local carrier mobility of at least one of the two components in an organic heterojunction may explain efficient dissociation of CT states into free charge carriers.

A cofacially stacked perylenediimide (PDI) dimer with a xanthene linker was studied under a variety of conditions (solvent, temperature) and serves as a model for the molecular interactions occurring in solid films. Intrinsically, the PDI units have a fluorescence quantum yield (Phi F) close to unity, but Phi F is lowered by a factor of 6-50 at room temperature when two PDI moieties are held in a cofacial arrangement, while the decay time of the most emissive state is increased significantly (tau F = 27 ns in toluene) compared to a monomeric PDI molecule (tau F = 4 ns). Fluorescence measurements show a strong solvent and temperature dependence of the characteristics of the emissive excited state. In a glassy matrix of toluene (TOL) or 2-methyltetrahydrofuran (2-MeTHF), Phi F is high, and the decay time is long (tau F = approximately 50 ns). At higher temperature, both Phi F and tau F are reduced. Interestingly, at room temperature, Phi F and tau F are also reduced with increasing solvent polarity, revealing the presence of a polar transition state. Photoinduced absorption of the stacked molecules from the picosecond to the microsecond time scale shows that after photoexcitation reorganization occurs in the first nanoseconds, followed by intersystem crossing (ISC), producing the triplet excited state. Using singlet oxygen ( (1)Delta g) luminescence as a probe, a triplet quantum yield (Phi T) greater than 50% was obtained in air-saturated 2-Me-THF. Triplet formation is exceptional for PDI chromophores, and the enhanced ISC is explained by a decay involving a highly polar transition state.