A series of graft copolymers consisting of either poly(N-isopropylacrylamide) (PNiPAAm) or poly(N,N-diethylacrylamide) (PDEAAm) as a thermo-responsive component in the polymer backbone and poly(ethyleneglycol) (PEG) were immobilized as thin films and cross-linked on a fluoropolymer substrate using low-pressure argon plasma treatment. The surface-immobilized hydrogels exhibit a transition from partially collapsed to completely swollen, which is in the range of 32-35 degrees C and corresponds to the lower critical solution temperature of the soluble polymers. The hydrogels were used as cell carriers in culture experiments with L929 mouse fibroblast cells to probe for cell adhesion, proliferation, and temperature-dependent detachment of cell layers. The fibroblast cells adhere, spread, and proliferate on the hydrogel layers at 37 degrees C and become completely detached after reducing the temperature by 3 K. The cell release characteristics were further correlated to the swelling and collapsing behavior of the hydrogel films and the polymer solutions as measured in PBS solution and RPMI cell cultivation medium. It could be shown that, long before the swelling has completed upon temperature reduction, the cells detach. This can be attributed to the large content of PEG present in the hydrogel, which weaken the cell adhesion strength to the hydrogel layers.
Thin films of graft copolymers consisting of poly(N-isopropylacrylamide) (PNiPAAm) or poly(N,N-diethylacrylamide) (PDEAAm) as polymer backbone and poly(ethyleneglycol) as side chains were cross-linked on fluoropolymer substrates by low-pressure plasma treatment. All immobilized polymers exhibit a lower critical solution temperature between 34 and 40 degrees C. The swelling and collapsing of the hydrogels was examined with temperature-dependent spectroscopic ellipsometry. Two time ranges of swelling were observed: a fast 'dynamic' and a slow 'equilibrium' swelling. The dynamic swelling occurs within minutes or less, whereas the equilibrium swelling needs several days to complete. The surface-bound hydrogels show a shift in the transition temperature toward lower temperatures compared with the behavior in solution. Full reversibility of the dynamic swelling/collapsing was found, but the temperature scan exhibits a hysteresis between heating and cooling cycles. The PNiPAAm-containing hydrogels show a sharper transition compared to the PDEAAm-containing hydrogels, which is almost linear over a wide temperature range.
New thermoresponsive graft copolymers were synthesized by the cationic ring-opening
polymerization of 2-methyl-2-oxazoline (MeOxa) or 2-ethyl-2-oxazoline (EtOxa), initiated by the random
copolymers of chloromethylstyrene (CMS) and N-isopropylacrylamide (NIPAAm) using the “grafting from”
method with a yield of 66−94%. The polymers were characterized by NMR, GPC, and DSC, and the
conformational transition (lower critical solution temperature, LCST) of macroinitiators and graft
copolymers was determined by the turbidity and DSC measurements. The transition temperature of the
graft copolymers could be fine-tuned through the composition of the macroinitiator and the graft copolymer.
An increasing quantity of the hydrophobic comonomer chloromethylstyrene in the macroinitiator lowered
its LCST, while in the graft copolymer an increasing content of the hydrophilic segment of poly(2-methyl-2-oxazoline) or poly(2-ethyl-2-oxazoline) raised the transition temperature. For graft copolymers with a
high content of long poly(2-alkyl-2-oxazoline) grafts, stabilized aggregates with a thermoresponsive core
can be formed at the LCST instead of precipitation of the material.
A hyperbranched polyester based on 3,5-dihydroxybenzoic acid was completely modified with dodecanoyl chloride to result in an amphiphilic, globular polymer, which has a polar core and a nonpolar outer sphere with the ability both to incorporate an organic dye and to interact with a nonpolar matrix. A series of blends were prepared using either polypropylene or polyethylene (HDPE) as the matrix. The content of the polyester as disperse phase was varied between 0.05 and 20 wt %. The blends with polyester contents up to 5% were prepared for colorization of polyolefins using the polyester as a dye carrier. The blends with higher polyester contents were prepared in order to investigate the influence of the hyperbranched material on the material properties. The blends exhibited a heterogeneous morphology with very small particle sizes even at high polyester concentrations. The melt rheology measurements resulted in a reduced complex viscosity for both polyolefins when the hyperbranched polyester was added. The observed melt viscosity of the i-PP blends deviated from the linear mixing rule, whereas the HDPE blends followed it. The use of amphiphilic hyperbranched polyesters as dye carriers allowed a homogeneous distribution of an organic dye in a polyolefin matrix with similar dynamic-mechanical behavior of the blends compared to the case of pure polyolefins. The dyed samples exhibited good stability in extraction experiments.
SUMMARY: New amphiphilic star polymers possessing a hyperbranched core and hydrophilic graft arms have been prepared. The synthetic strategy involved esterification of the 4,4-bis(49-hydroxyphenyl)valeric acid based hyperbranched polymer with 3-(chloromethyl)benzoyl chloride to obtain the hyperbranched macroinitiator followed by cationic ring-opening polymerization of 2-methyl-2-oxazoline to give amphiphilic polymers. Exchange of the chloride counter ion with trifluoromethanesulfonate (KCF 3 SO 3 or AgCF 3 SO 3 ) or iodide (KI) anions leads to higher polymerization rates. Phenyl 2-(chloromethyl)benzoate was used as a model initiator to study the effect of different coinitiators on the initiator efficiency. KI as a coinitiator yielded 56 -86% initiator conversion whereas only 30 -37% initiator conversion was achieved with KCF 3 SO 3 or AgCF 3 SO 3 as coinitiator after quantitative monomer consumption. Photon correlation spectroscopy (PCS) in methanol and chloroform for selected graft copolymers revealed the formation of single star molecules ranging from 22 to 50 nm in diameter.
The kinetics of reactions with nonuniform reaction rate constants leading to hyperbranched
polymers has been examined and discussed. A matrix notation was developed, which has then been applied
to the analysis of the kinetics of AB2, AB3, AB
n
, and ABB‘ systems. All differential equations have been
integrated numerically in order to obtain plots of the ratios of structural units as functions of the
conversion. Three general situations for AB2 systems and the kinetics of self-condensing vinyl polymerization as one example of an ABB‘ system are discussed. It was found that the influence of the first B
group on the reactivity of the second B group has the largest effect on ratio of structural units and final
composition. Thus, by varying the rate constants of these reaction steps in the model the resulting degree
of branching ranges between 15 and 89%. Furthermore, the diad formation of the AB2 system is analyzed.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.