Since the 1970s, a great deal of attention has been paid to the development of semiconductor-based biosensors because of the numerous advantages they offer, including high sensitivity, faster response time, miniaturization, and low-cost manufacturing for quick biospecific analysis with reusable features. Commercial biosensors have become highly desirable in the fields of medicine, food, and environmental monitoring as well as military applications, whereas increasing concerns about food safety and health issues have resulted in the introduction of novel legislative standards for these sensors. Numerous devices have been developed for monitoring biological processes such as nucleic acid hybridization, protein–protein interaction, antigen–antibody bonds, and substrate–enzyme reactions, just to name a few. Since the 1980s, scientific interest moved to the development of semiconductor-based devices, which also include integrated front-end electronics, such as the extended-gate field-effect transistor (EGFET) biosensor, one of the first miniaturized chemical sensors. This work is intended to be a review of the state of the art focused on the development of biosensors and chemosensors based on extended-gate field-effect transistor within the field of bioanalytical applications, which will highlight the most recent research reported in the literature. Moreover, a comparison among the diverse EGFET devices will be presented, giving particular attention to the materials and technologies.

No abstract

Increasing demand for self-powered wearable sensors has spurred an urgent need to develop energy harvesting systems that can reliably and sufficiently power these devices. Within the last decade, reverse electrowetting-on-dielectric (REWOD)-based mechanical motion energy harvesting has been developed, where an electrolyte is modulated (repeatedly squeezed) between two dissimilar electrodes under an externally applied mechanical force to generate an AC current. In this work, we explored various combinations of electrolyte concentrations, dielectrics, and dielectric thicknesses to generate maximum output power employing REWOD energy harvester. With the objective of implementing a fully self-powered wearable sensor, a “zero applied-bias-voltage” approach was adopted. Three different concentrations of sodium chloride aqueous solutions (NaCl-0.1 M, NaCl-0.5 M, and NaCl-1.0 M) were used as electrolytes. Likewise, electrodes were fabricated with three different dielectric thicknesses (100 nm, 150 nm, and 200 nm) of Al2O3 and SiO2 with an additional layer of CYTOP for surface hydrophobicity. The REWOD energy harvester and its electrode–electrolyte layers were modeled using lumped components that include a resistor, a capacitor, and a current source representing the harvester. Without using any external bias voltage, AC current generation with a power density of 53.3 nW/cm2 was demonstrated at an external excitation frequency of 3 Hz with an optimal external load. The experimental results were analytically verified using the derived theoretical model. Superior performance of the harvester in terms of the figure-of-merit comparing previously reported works is demonstrated. The novelty of this work lies in the combination of an analytical modeling method and experimental validation that together can be used to increase the REWOD harvested power extensively without requiring any external bias voltage.

Continuous sediment core samples and groundwater were collected in the northern part of Sonargaon, central Bangladesh, to document the hydrogeological constraints on As-contaminated aquifers. The study area spans the alluvial plain of the Old Brahmaputra River and a Pleistocene terrace, the Madhupur Tract. The Quaternary sequence comprises Plio-Pleistocene sand, Upper Pleistocene mud, and Holocene sand units. HighlyAs-contaminated groundwater ( 50 -1000 μg/L) is found in the upper aquifer corresponding to the Holocene sand unit that underlies the alluvial plain, and plausibly appears to be closely related to the distribution of lenses of silt to fine sand. As-free (< 1 μg/L) groundwater only occurs within sediments coarser than medium sand. Highly As contaminated groundwater is characterized by low concentrations of Cl -and SO 4 2-and high concentrations of NH 4 + , suggesting that the As is released in association with reduction of waters recharged during rainy season. The restricted occurrence of strongly As-contaminated (>100 μg/L) groundwater is associated with: 1) the intercalation of silt to fine sand lens in the Holocene sandy aquifer, 2) the stagnant condition of the aquifer along the buried valley, 3) the vertical infiltration of groundwater in close proximity to installed tubewells.3

Extended-gate field-effect transistor (EGFET) is an electronic interface originally developed as a substitute for an ion-sensitive field-effect transistor (ISFET). Although the literature shows that commercial off-the-shelf components are widely used for biosensor fabrication, studies on electronic interfaces are still scarce (e.g., noise processes, scaling). Therefore, the incorporation of a custom EGFET can lead to biosensors with optimized performance. In this paper, the design and characterization of a transistor association (TA)-based EGFET was investigated. Prototypes were manufactured using a 130 nm standard complementary metal-oxide semiconductor (CMOS) process and compared with devices presented in recent literature. A DC equivalence with the counterpart involving a single equivalent transistor was observed. Experimental results showed a power consumption of 24.99 mW at 1.2 V supply voltage with a minimum die area of 0.685 × 1.2 mm2. The higher aspect ratio devices required a proportionally increased die area and power consumption. Conversely, the input-referred noise showed an opposite trend with a minimum of 176.4 nVrms over the 0.1 to 10 Hz frequency band for a higher aspect ratio. EGFET as a pH sensor presented further validation of the design with an average voltage sensitivity of 50.3 mV/pH, a maximum current sensitivity of 15.71 mA1/2/pH, a linearity higher than 99.9%, and the possibility of operating at a lower noise level with a compact design and a low complexity.

Three-dimensional groundwater flow in Sonargaon, Bangladesh is numerically simulated in order to evaluate the flow paths of As-contaminated drinking groundwater in the Holocene aquifer of the Ganges-Blamaptra-Meghna delta plain over a recent thirty-year period. The model indicates that vertical infiltration of surface groundwater into the shallow Holocene aquifer occurs frequently in the Ganges-Blamaptra-Meghna delta plain. It predicts that the water recharged from ground surface moves approximately 10 m to 20 m vertically downward beneath the flood plain, with a gradually increasing horizontal flow, toward the underlying Pleistocene middle mud layer (aquitard). The model also predicts that groundwaters containing highest As concentrations (> 700 μg/L) are formed on the vertical groundwater flow paths where surface water recharges the Holocene aquifer and not on the horizontal flow paths. Combining with the groundwater chemistry, reducing groundwater condition is not essential for the As-contaminated groundwater of the studied area in the Ganges delta plain.*Manuscript Click here to download Manuscript: ORevice2-JH2010-Bangla-SN.doc Click here to view linked References

Background. The East Kolkata Wetlands in India (a Ramsar site) are sewage-fed, nutrient-rich water bodies successfully used for fish production. The vermiculated sailfin catfish, Pterygoplichthys disjunctivus (Weber, 1991), exotic to India, has invaded these wetlands. The management and control of this catfish has been hindered, because of the lack of information on its abundance, population structure, biological traits, level of establishment, and competition with native fish species. Materials and methods. Within 2013-2015 studies were carried out on the population structure of P. disjunctivus, its food habits, reproductive biology, and initial impacts in the wetlands through monthly and seasonal collection of samples, examination of food items, reproductive parameters, catch data, and gathering fishers experience. Results. The length (TL) and weight of the specimens ranged from 10 to 55 cm and from 120 to 1250 g, respectively. Major food items of the catfish were detrital matter (%IRI 56), unidentified plant matter (%IRI 11), fish eggs (%IRI 11), polychaete worms (%IRI 5), and other minor items (%IRI 0.3 to 4). At 50% similarity, the food items of P. disjunctivus overlapped with that of Macrognathus pancalus, Channa punctata, Nandus nandus, Anabas testudineus, Clarias batrachus, Oreochromis niloticus, Cirrhinus mrigala, and Cyprinus carpio while at 80% it overlapped with that of C. mrigala and C. carpio. The fecundity of P. disjunctivus, in the wetlands, was the highest recorded for the species. Females attained the first maturity at 24 cm TL and reproduced multiple times within July-November. The breeding period of the species overlapped with 13 native fish species, of which it seriously overlapped with that of Gudusia chapra, Amblypharyngodon mola, Pethia conchonius, P. ticto, N. nandus, C. punctata, and A. testudineus. The sailfin catfish has established reproducing populations in the wetlands and reached 'invasive' proportions constituting 4.83% (300.04 t • year-1) of the mean annual fish catch (6203.85 t • year-1) from the wetlands. The invasive risk assessment showed a high risk of the species in the current scenario and probable climate change scenarios in future in the region. Conclusions. Pterygoplichthys disjunctivus has successfully colonized the sensitive East Kolkata Wetlands, which might easily spread to neighbouring water bodies including the sensitive Ganga River and Sundarban mangroves and cause ecological and economic disturbance unless preventive measures are taken as the species has high invasive risk in the region.

No abstract