Solar Photovoltaic is a very promising solution that can greatly contribute in solving the increasing global energy demand. In both rural and urban areas, photovoltaic modules are in some instances installed close to telecommunication antennas or voltage transformers which generate important magnetic fields in their vicinity. The question is whether or not these magnetic fields affect the performances of the photovoltaic installations. This article presents a modelling study of external magnetic field effect on the electrical parameters of a photovoltaic module. The photocurrent, the photovoltage, the electric power, the series and the shunt resistances of the photovoltaic module, made up of ideal cells, are deduced from those of a silicon solar cell. Then, the I-V and P-V curves are plotted and the theoretical values of the electrical parameters of the photovoltaic module are deduced. The series and shunt resistances of the photovoltaic module are calculated using well known equations and the previous electrical parameters. The results show the negative effect of magnetic field on the performance of a solar photovoltaic module.
Aside from the terrestrial magnetic field that is generated from the earth core, power transmission, and distribution lines, transformers and other equipment do produce a certain amount of magnetic field that could interfere with the performance of photovoltaic modules. This study conducted an experiment and investigated the performance of a silicon photovoltaic module subjected to a magnetic field. The current-voltage and power-voltage characteristics were plotted in the same axis system and allowed us to find, as a function of the magnetic field, the electrical parameters of the photovoltaic module such as maximum electric power, fill factor, conversion efficiency, and charge resistance at the maximum power point. These electrical parameters were then used to calculate the series and shunt resistances of the equivalent circuit of the photovoltaic module. The results have shown that the efficiency of a solar module is affected by the presence of magnetic fields. However, the magnitude of ambient magnetic field generated by power transmissions lines and other equipment is extremely low (in the order of 10−2 mT or less) as compared to the values of the magnetic field used in this study. That made it difficult to conclude as to the impact of such field on solar photovoltaic installations.
The aim of this work is to investigate, with a three-dimensional steady-state approach, the effect of the incidence angle of a magnetic field on the performance of a polycrystalline silicon solar cell under multispectral illumination. The magneto-transport and continuity equations of excess minority carriers are solved to find the expression of the density of excess minority carriers and the related electrical parameters, such as the photocurrent density, the photovoltage and the electric power, of a grain of the polycrystalline silicon solar cell. The influence of the incidence angle of the magnetic field on the diffusion coefficient, the short-circuit photocurrent density, the open-circuit photovoltage and the electric power-photovoltage is studied. Then, the curves of the electric power-photovoltage is used to find the maximum electric power allowing to calculate, according to the incidence angle of the magnetic field, the fill factor and the conversion efficiency. The study has shown that the increase of the incidence angle of the magnetic field from 0 rad to π/2 rad, can reduce the degradation of the performance of solar cells.
In earlier studies, we have shown theoretically and experimentally that magnetic fields (MFs) have negative impact on silicon PV module (photovoltaic module). A noticeable decline in photocurrent with a slight increase in photovoltage was observed. Also, how those fields affected other key module’s parameters was also studied. These studies concluded that an increase in the magnitude of the MF resulted in the decrease of the efficiency of the silicon PV module. The previous experimental studies assumed that the MF vector formed zero angle of inclination with respect to the photosensitive face of the module. They did not factor in any effect that could be observed when the field vector is inclined. The present experimental work is an attempt to fill that gap. The characteristic curves of the PV module were plotted in the same system of axis for different values of the inclination angle of the MF vector. Correspondingly, the characteristic values ( P max , I max , V max , I sc , and V oc ) of the PV module were also determined. These parameters then allowed the calculation of the efficiency of the module, its fill factor, and the equivalent circuit series and shunt resistances. It is observed that the module efficiency increases with the inclination of the MF vector, indicating that the effect of the MF on the PV module is reduced when its vector aligns towards a direction that is perpendicular to the base of the module. For example, when α moves from 0 to 90°, the power output and consequently the efficiency of the PV module relatively increase of 14%.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.