Croatia produced 21,366 tonnes of dry matter (DM) sewage sludge (SS) in 2016, a quantity expected to surpass 100,000 tonnes DM by 2024. Annual production rates for future wastewater treatment plants (WWTP) in Croatia are estimated at 5.8–7.3 Nm3/people equivalent (PE) for biogas and 20–25 kgDM/PE of sewage sludge. Biogas can be converted into 12–16 kWhel/PE of electricity and 19–24 kWhth/PE of heat, which is sufficient for 30–40% of electrical and 80–100% of thermal autonomy. The WWTP autonomy can be increased using energy recovery from sewage sludge incineration by 60% for electricity and 100% of thermal energy (10–13 kWhel/PE and 30–38 kWhth/PE). However, energy for sewage sludge drying exceeds energy recovery, unless solar drying is performed. The annual solar drying potential is estimated between 450–750 kgDM/m2 of solar drying surface. The lower heating value of dried sewage sludge is 2–3 kWh/kgDM and this energy can be used for assisting sludge drying or for energy generation and supply to WWTPs. Sewage sludge can be considered a renewable energy source and its incineration generates substantially lower greenhouse gases emissions than energy generation from fossil fuels. For the same amount of energy, sewage sludge emits 58% fewer emissions than natural gas and 80% less than hard coal and fuel oil. Moreover, this paper analysed the feasibility of sludge disposal practices by analysing three scenarios (landfilling, co-incineration, and mono-incineration). The analysis revealed that the most cost-effective sewage sludge disposal method is landfilling for 60% and co-incineration for 40% of the observed WWTPs in Croatia. The lowest CO2 emissions are obtained with landfilling and mono-incineration in 53% and 38% of the cases, respectively.

Sewage sludge management has gained significance in the last several years, due to its nutrient and energy content. However, technology selection is one of the greater challenges because it is not possible to implement a technology that covers all the requirements of the considered environments. Consequently, this paper shows an example of the utilization of an analytical hierarchy process, as a decision-making tool in terms of technology selection, for sewage sludge management in Rijeka, Croatia. The criteria structuring and evaluation process with the description of several possible alternatives for thermal treatment technologies are defined within this research. For the case of Rijeka, the best and most suitable technology for sewage sludge treatment is gasification, which coincides with the results obtained from the analysis of the literature review. According to the results in this paper, the possibilities of the use of this scientific method on the national level for the selection of sewage sludge treatment technology should be considered, due to the simplicity of its use and capability of its adaptation to various situations and areas.

No abstract

No abstract