No abstract

No abstract

No abstract

We have investigated the phonon spectra of pulsed laser deposited Sr2CoO4 thin film and its evolution with temperature using Raman spectroscopy. The magnetic measurement reveals magnetic transition at temperature TC = 255 K. No structural phase transition is observed in the investigated temperature range (100-300 K). Close correlation between the frequency shift and the magnetization across TC establishes that the anomaly in the vicinity of TC is owing to spin-phonon coupling in the material. Using two different approaches, we have calculated spin-phonon coupling strength to be in the range of 2-3.5 cm−1.

Microchannels formed in non-conductive substrates like fused silica, glass and quartz, etc, have wide applications in the field of micro-fluidic and lab-on-chip applications due to their optical transparency, chemical inertness, and biocompatible nature. Electrochemical discharge machining (ECDM) has emerged as a potential low-cost fabrication method to fabricate microfeatures in these materials, compared to conventional laser etching techniques. In this paper, numerical simulation and experimental fabrication of microchannels in a glass substrate using the ECDM based micromilling technique is demonstrated. Stainless steel needle as tool electrode is used in alkaline electrolyte medium. The effects of process parameters viz. tool feed rate, pulse frequency and machining voltage on material removal rate (MRR) and surface roughness (SR) of the microchannels were analysed. The experimental results showed that the MRR and SR increases with an increase in machining voltage and tool feed rate but reduces with an increase in the pulse frequency. Simulations using FEM-based model showed similar trends in MRR with that of experiments. A comparison between the cross-section profiles obtained by the experimental work and predicted profile by the numerical simulation showed some deviation between them due to the Gaussian heat flux assumption in the numerical model. Optical images showed that KOH performance is comparatively better than NaOH with respect to thermal damage and width of cut. Further, multi-objective optimization was performed using utility theory coupled with Taguchi’s method to optimize the process parameters. Moreover, the capability of the ECDM process was demonstrated in fabricating various other micro-features such as sinusoidal channel, letter engraving, etc in a glass substrate, which can be extended to other brittle materials like quartz, fused silica, ceramic, etc.

No abstract

No abstract

No abstract