The aim of the present study was to establish the influence of high-temperature heating on the composition and thermal behavior of coffee oils obtained from Arabica green and roasted coffee beans, respectively. Morphological studies performed using scanning electron microscopy revealed the oil bodies uniformly distributed within the cells in both types of coffee beans analyzed. The obtained oils have a fatty acid composition rich in linoleic acid, palmitic acid, oleic acid, stearic acid, arachidic acid and linolenic acid. The total content of saturated fatty acids of investigated oils was 49.38 and 46.55%, the others being unsaturated fatty acids. The thermal behavior and thermo-oxidative stability of coffee oils extracted from green coffee beans and roasted coffee beans, the coffee oil high-temperature heated up to 200 °C, were investigated using simultaneous thermal analysis TG/DTG/DTA, in an oxidizing atmosphere. The data obtained for the analyzed samples depend mainly on the nature and compositions of fatty acids, and to a lesser extent on the roasting process of the coffee beans and the high-temperature heating process of the extracted oil. The chromatographic and TG/DTG/DTA data suggest that Arabica coffee oil has great potential for use in technological processes which require high-temperature heating (e.g. food industry or pastries).

The coffee oil has a promising potential to be used in food industry, but an efficient use, especially in products that required high-temperature heating, depends on its chemical composition and the changes induced by processing. Since there is little information on this topic, the aim of our study was to investigate the crude green and roasted coffee oil (GCO, RCO) and heated (HGCO, HRCO) for 1 h at 200°C, by Fourier Transform Infrared (FTIR) spectroscopy and in terms of antioxidant and antimicrobial properties. The results of FTIR spectroscopy revealed that no statistically significant differences (one-way ANOVA, p>0.05) in the oxidative status of GCO and RCO were found. The coffee oils heating induced significant spectral changes in the regions 3100–3600 cm–1, 2800–3050 cm–1 and 1680–1780 cm–1 proved by the differences in the absorbance ratios A 3009 cm−1/A 2922 cm−1, A 3009 cm−1/A 2853 cm−1, A 3009 cm−1/A 1744 cm−1, A 1744 cm−1/A 2922 cm−1. These alterations were related to the reduction of the unsaturation degree due to primary and secondary oxidation processes of the lipid fraction. The radical scavenging ability of oils investigated by 2,2-diphenyl-1-picrylhydrazyl (DPPH) assay revealed that the IC50 value of GCO was significantly lower than of RCO (p<0.05). The IC50 values of crude coffee oils were lower than those of heated samples. The antioxidant activity of oils was attributed to both antioxidant compounds with free-radical scavenging capacity and to lipids oxidation products generated by heating. In the first 6 h of incubation, the inhibitory activity of crude oils against E. coli and E. faecalis was not significantly different to the control (p>0.05). Also, HGCO and HRCO showed significantly different inhibitory potential related to the control (p<0.05). The heating induced statistically significant decreases in the effectiveness of coffee oils against the tested bacteria. GCO proved to be the most effective among investigated coffee oils against the tested bacteria.

The main purpose of this work was to assess the potential of chili pepper seed oil (CPSO) and sweet pepper seed oil (SPSO) to inhibit or retard the thermo-oxidative processes undergoing in sunflower oil (SFO) when subjected to high-temperature heating for 4 and 8 h in simulated frying conditions. The effects of high-temperature treatment for 4 and 8 h on the fatty acid composition and the lipid oxidation degree of the investigated oil samples were evaluated using the peroxide value (PV), the p-anisidine value (p-AV) and the thiobarbituric acid test (TBA). All determinations were performed before and after sample heating in order to evaluate the changes in lipid oxidation as well as in the chemical composition. In all studied samples, both after 4 h and 8 h of high-temperature heating, there was an increase of the saturated fatty acid content. This increase is lower in the case of SFO samples supplemented with CPSO and SPSO when compared with SFO. A 41.67% increase was recorded for the SFO sample supplemented with 300 ppm CPSO, and a 36.76% increase was recorded for the SFO supplemented with 300 ppm SPSO, compared to the 44.97% increase recorded for the SFO. Heating the samples supplemented with CPSO and SPSO with a concentration of 300 ppm for 8 h led to the much lower values of the investigated parameters in relation to the control sample, as follows: PV (12.95 ± 0.17 meq/kg oil for SFO + 300 ppm CPSO and 13.45 ± 0.32 meq/kg oil for SFO + 300 ppm SPSO, compared with 16.4 + 0.17 meq/kg oil for SFO), p-AV (63.445 ± 1.259 ppm oil for SFO + 300 ppm CPSO and 64.122 ± 1.208 ppm oil for SFO + 300 ppm SPSO, compared with 72.493 + 1.340 ppm oil for SFO), CD (45%; 30%), TOTOX (88.374 for SFO + 300 ppm CPSO and 101.366 for SFO + 300 ppm SPSO compared with 105.347 ppm for SFO) and TBA (98.92 ± 2.49 µg MDA/g oil for SFO + 300 ppm CPSO and 114.24 ± 3.51 µg MDA/g oil for SFO + 300 ppm SPSO, compared with 180.08 + 5.82 µg MDA/g oil for SFO). Regarding the lipid oxidation process occurring during the heat treatment, we observed the reduction of lipid oxidation by the addition of CPSO and SPSO and recommend these seed oils as potential natural antioxidants in order to improve the oxidative stability of SFO during heat treatment.

Exploring new sources of natural antioxidants is of great interest to edible oil producers, in line with the toxicological problems generated by the use of synthetic antioxidants. This study assesses the potential of lyophilized Pinot Noir grape pomace extract (GPE) to enhance the sunflower oil stability against thermo-oxidative damage compared to BHT during a prolonged exposure to convective heat at 185 °C. Oil thermo-oxidation was monitored based on specific indices such as peroxide value (PV), para-anisidine value (p-AV), inhibition of oil oxidation (IO), total oxidation (TOTOX) value, conjugated dienes and trienes (CDs, CTs), but also by attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FTIR), where absorbance ratios A 3009 cm−1/A 2922 cm−1 (RI), A 3009 cm−1/A 2853 cm−1 (RII), A 3009 cm−1/A 1744 cm−1 (RIII) and RIV = A 1744 cm−1/A 2922 cm−1 (RIV) were investigated. GPE showed a significant inhibitory effect on oil thermo-oxidation and this response was concentration-dependent. Substantial decreases in the investigated indices, compared to the control without added antioxidants, were obtained after 4 h and 8 h of heat exposure of the 800 ppm GPE sample: PV (47%; 42%), p-AV (38%; 33%), IO (54%; 46%), TOTOX (41%; 37%), CDs (46%; 39%), CTs (44%; 29%). Oil exposure to heat resulted in changes in RI–RIV attributed to the reduction in the degree of unsaturation, in response to primary and secondary lipid oxidation. FTIR spectroscopy can be used to differentiate untreated and heat-treated oils based on the absorbance ratios. An inhibitory effect close to that of BHT was achieved by 500 ppm GPE, while a dose of 800 ppm provided greater protection against thermo-oxidation. Our results promote GPE as a natural additive to limit the thermo-oxidative damage of plant oils.

The adoption of sustainable waste management strategies is a challenge faced by most European countries, mainly due to the need to generate less waste and replace landfills with new methods of waste treatment, associated with increases in the separate collection of waste and recycling rates. This paper highlights the significance of environmental legislation regarding waste removal to protect ecosystems. The aim was to predict ecological responses to heavy metals in soil exposed to hazardous waste and to identify environmental hazards in landfills, small illegal waste dumps, and litter, in addition to identifying if heavy metal accumulation in the investigated soil samples showed a single or cumulative risk. This is an innovative method to predict the ecological risk generated by hazardous waste landfills. The assessment of ecological risks was based on the evaluation of a heavy metal soil contamination factor, pollution index of soil loadings, a geo-accumulation index for heavy metals, and potential ecological risk. The current study is also the first to attempt to identify the dimension of risk based on the type of waste deposit (landfill, small illegal waste dump, and litter) and to identify potential patterns. The geological index corresponding to cadmium Igeo(Cd) showed heavy contamination in the soil samples from the landfill and moderate contamination for those from the illegal waste dumps. These findings indicate that soil contamination is influenced by contamination time, anthropogenic processes, and a history of industrial activity, and not only by waste composition and storage. The present study shows that cadmium might be considered a latent fingerprint for waste disposal, which is correlated to the industrialization level and rehabilitation procedures.