Intermolecular additions of the O-H bonds of phenols and alcohols and the N-H bonds of sulfonamides and benzamide to olefins catalyzed by 1 mol % of triflic acid and studies to define the relationship between these reactions and those catalyzed by metal triflates are reported. Cyclization of an alcohol containing pendant monosubstituted and trisubstituted olefins catalyzed by either triflic acid or metal triflates form products from addition to the more substituted olefin, and additions of tosylamide catalyzed by triflic acid or metal triflates form indistinguishable ratios of the two N-alkyl sulfonamides.

A new generation of Ni-Sn-O, Ni-Ti-O, and Ni-W-O catalysts has been prepared by a solid state grinding method. In each case the doping metal varied from 2.5% to 20%. These catalysts exhibited higher activity and selectivity for ethane oxidative dehydrogenation (ODH) than conventionally prepared mixed oxides. Detailed characterisation was achieved using XRD, N 2 adsorption, H 2-TPR, SEM, TEM, and HAADF-STEM in order to study the detailed atomic structure and textural properties of the synthesized catalysts. Two kinds of typical structures are found in these mixed oxides, which are (major) "Ni x M y O" (M = Sn, Ti or W) solid solution phases (NiO crystalline structure with doping atom incorporated in the lattice) and (minor) secondary phases (SnO 2 , TiO 2 or WO 3). The secondary phase exists as a thin layer around small "Ni x M y O" particles, lowering the aggregation of nanoparticles during the synthesis. DFT calculations on the formation energies of M-doped NiO structures (M = Sn, Ti, W) clearly confirm the thermodynamic feasibility of incorporating these doping metals into NiO struture. The incorporation of doping metals into the NiO lattice decreases the number of holes (h +) localized on lattice oxygen (O 2-+ h + O • • • •-), which is the main reason for the improved catalytic performance (O • • • •is known to favor complete ethane oxidation to CO 2). The high efficiency of ethylene production achieved in these particularly prepared mixed oxide catalysts indicates that the solid grinding method could serve as a general and practical approach for the preparation of doped NiO based catalysts.

Sequential treatment at low temperatures of Cp*W(NO)Cl2 in THF with 1 equiv of a binary magnesium allyl reagent, followed by an excess of LiBH4, affords three new Cp*W(NO)(H)(η(3)-allyl) complexes, namely, Cp*W(NO)(H)(η(3)-CH2CHCMe2) (1), Cp*W(NO)(H)(η(3)-CH2CHCHPh) (2), and Cp*W(NO)(H)(η(3)-CH2CHCHMe) (3). Complexes 1-3 are isolable as air-stable, analytically pure yellow solids in good to moderate yields by chromatography or fractional crystallization. In solutions, complex 1 exists as two coordination isomers in an 83:17 ratio differing with respect to the endo/exo orientation of the allyl ligand. In contrast, complexes 2 and 3 each exist as four coordination isomers, all differing by the orientation of their allyl ligands which can have either an endo or an exo orientation with the phenyl or methyl groups being either proximal or distal to the nitrosyl ligand. A DFT computational analysis using the major isomer of Cp*W(NO)(H)(η(3)-CH2CHCHMe) (3a) as the model complex has revealed that its lowest-energy thermal-decomposition pathway involves the intramolecular isomerization of 3a to the 16e η(2)-alkene complex, Cp*W(NO)(η(2)-CH2═CHCH2Me). Such η(2)-alkene complexes are isolable as their 18e PMe3 adducts when compounds 1-3 are thermolyzed in neat PMe3, the other organometallic products formed during these thermolyses being Cp*W(NO)(PMe3)2 (5) and, occasionally, Cp*W(NO)(H)(η(1)-allyl)(PMe3). All new complexes have been characterized by conventional spectroscopic and analytical methods, and the solid-state molecular structures of most of them have been established by single-crystal X-ray crystallographic analyses.

No abstract

No abstract

The straightforward solid-state grinding of a mixture of Ni nitrate and Nb oxalate crystals led to, after mild calcination (T<400 °C), nanostructured Ni-Nb oxide composites. These new materials efficiently catalyzed the oxidative dehydrogenation (ODH) of ethane to ethylene at a relatively low temperature (T<300 °C). These catalysts appear to be much more stable than the corresponding composites prepared by other chemical methods; more than 90 % of their original intrinsic activity was retained after 50 h with time on-stream. Furthermore, the stability was much less affected by the Nb content than in composites prepared by classical "wet" syntheses. These materials, obtained in a solvent-free way, are thus promising green and sustainable alternatives to the current Ni-Nb candidates for the low-temperature ODH of ethane.

Linear octenes were produced in high (70–85%) selectivity from oligomerization of liquid 1-butene using carbon-supported cobalt oxide catalysts in a continuous flow reactor. The liquid products were characterized by two-dimensional gas chromatography–mass spectrometry. Above 95% of the oligomers were C8 olefins, with the other products primarily being branched C12 olefins. The linear octene products at a conversion of 9.77% decreased in selectivity according to 3-octene > trans-2-octene > cis-2-octene > 4-octene. Methyl-heptenes including trans/cis-5-methyl-2-heptene > trans/cis-5-methyl-3-heptene > trans-3-methyl-2-heptene (at the lowest conversion) were the other major products summing to 15.6%. The selectivity of linear octenes decreased from 84 to 78% as the conversion increased from 10% to 29%. The product distribution suggests the reaction pathway involves a head-to-head coupling of two 1-butene molecules to form internal linear octenes. Head-to-tail coupling of two 1-butene molecules or a coupling between 1-butene and 2-butene forms the observed methyl-heptenes. The rate of head-to-head coupling is higher than the rate of head-to-tail or the rate of 1-butene to 2-butene coupling as indicated by the higher selectivity of linear octenes. The activated catalyst contained both Co3O4 and CoO as confirmed by X-ray diffraction (XRD), in situ Raman spectroscopy, and X-ray absorption spectroscopy. The cobalt oxide particle size was estimated to be between 5 and 10 nm by high-resolution transmission electron microscopy and XRD. The Co3O4/CoO ratio decreased with increasing pretreatment temperature. Metallic cobalt, which has a low catalytic activity, formed at 550 °C.

Treatment of (DME)Cl2Mo(=NR)2 (R=tBu, (1-tBu), tAmyl (1-tAmyl)) with 2 equiv of tBu3SiOH (siloxH) and 1 equiv of HCl produced (silox)2Cl2Mo=NR (R=tBu, (3-tBu), tAmyl (3-tAmyl)); subsequent reduction by Na/Hg afforded the Mo(V) chloride, (silox)2ClMo=NtBu (4-tBu), and the Mo(IV) mercury derivatives, [(silox)2Mo=NR]2Hg (R=tBu ((5-tBu)2Hg), tAmyl ((5-tAmyl)2Hg)). Reductions of 3-tBu and 3-tAmyl in the presence of L (L=PMe3, pyridine, 4-picoline) led to the isolation of adducts (silox)2(Me3P)Mo=NR (R=tBu (6-tBu), tAmyl (6-tAmyl)) and (silox)2L2Mo=NtBu (L=py (7-py), 4-pic (7-4-pic)). Single-crystal X-ray structural investigations of pseudo-tetrahedral 4-tBu, Hg-capped, pseudo-trigonal planar (5-tBu)2Hg, pseudo-tetrahedral 6-tBu, and trigonal bipyramidal 7-4-pic reveal that all possess a closed O-Mo-O angle when compared to the N=Mo-O angles. A molecular orbital rationale and supporting calculations suggest that this is a manifestation of the greater pi-donating ability of the imido relative to that of the siloxides. While the D(Mo-Hg) of [(HO)2Mo=NH]2Hg ((5')2Hg) was calculated to be 22.4 kcal/mol, (5-R)2Hg (R=tBu, tAmyl) are remarkably stable; (5-tBu)2Hg degraded in a first-order fashion with DeltaG=31.9(1) kcal/mol. In the presence of strong (L=PMe, pyridine, S8) or weak (L=2-butyne, ethylene, N2O, 1,4,7,10-tetrathiacyclododecane, 1,4,7,10,13,16-hexathiacyclooctadecane) nucleophiles, an enhanced rate of Mo-Hg bond cleavage was noted, with some of the former group generating adducts in <5 min; the products were 6-tBu, 7-py, (silox)2(S)Mo=NtBu (10-tBu), (silox)2Mo=NtBu(C2Me2) (8-tBu), (silox)2(C2H4)Mo=NtBu (11-tBu), (silox)2(O)Mo=NtBu (9-tBu), and a mixture of 10-tBu and 11-tBu, respectively. Some of these were independently prepared via substitution of 6-tBu. According to calculations and a molecular orbital rationale, dissociation of the Mo-Hg bond in (5-R)2Hg (R=tBu, tAmyl) is orbitally forbidden, and the addition of a nucleophile to the terminus of the Mo-Hg-Mo linkage mitigates the symmetry requirements. The mechanism of thermal degradation was studied with mixed success. NMR spectroscopy revealed imido exchange between (5-tBu)2Hg and (5-tAmyl)2Hg during an initial induction period and a subsequent rapid exchange period that implicated free 5-R (R=tBu, tAmyl). Further crossover studies revealed siloxide exchange as an additional complication.