Passive vane–type vortex generators (VGs) are commonly used on wind turbine blades to mitigate the effects of flow separation. However, significant uncertainty surrounds VG design guidelines. Understanding the influence of VG parameters on airfoil performance requires a systematic approach targeting wind energy‐specific airfoils. Thus, the 30%‐thick DU97‐W‐300 airfoil was equipped with numerous VG designs, and its performance was evaluated in the Delft University Low Turbulence Wind Tunnel at a chord‐based Reynolds number of 2×106. Oil‐flow visualizations confirmed the suppression of separation as a result of the vortex‐induced mixing. Further investigation of the oil streaks demonstrated a method to determine the vortex strength. The airfoil performance sensitivity to 41 different VG designs was explored by analysing model and wake pressures. The chordwise positioning, array configuration, and vane height were of prime importance. The sensitivity to vane length, inclination angle, vane shape, and array packing density proved secondary. The VGs were also able to delay stall with simulated airfoil surface roughness. The use of the VG mounting strip was detrimental to the airfoil's performance, highlighting the aerodynamic cost of the commonly used mounting technique. Time‐averaged pressure distributions and the lift standard deviation revealed that the presence of VGs increases load fluctuations in the stalling regime, compared with the uncontrolled case.

Two new engineering models are presented for the aerodynamic induction of a wind turbine under dynamic thrust. The models are developed using the differential form of Duhamel integrals of indicial responses of actuator disc type vortex models. The time constants of the indicial functions are obtained by the indicial responses of a linear and a nonlinear actuator disc model. The new dynamic‐inflow engineering models are verified against the results of a Computational Fluid Dynamics (CFD) model and compared against the dynamic‐inflow engineering models of Pitt‐Peters, Øye, and Energy Research Center of the Netherlands (ECN), for several load cases. Comparisons of all models show that two time constants are necessary to predict the dynamic induction. The amplitude and phase delay of the velocity distribution shows a strong radial dependency. Verifying the models against results from the CFD model shows that the model based on the linear actuator disc vortex model predicts a similar performance as the Øye model. The model based on the nonlinear actuator disc vortex model predicts the dynamic induction better than the other models concerning both phase delay and amplitude, especially at high load.

No abstract

No abstract

To advance the design of a multimegawatt vertical‐axis wind turbine (VAWT), application‐specific airfoils need to be developed. In this research, airfoils are tailored for a VAWT with variable pitch. A genetic algorithm is used to optimise the airfoil shape considering a balance between the aerodynamic and structural performance of airfoils. At rotor scale, the aerodynamic objective aims to create the required optimal loading while minimising losses. The structural objective focusses on maximising the bending stiffness. Three airfoils from the Pareto front are selected and analysed using the actuator cylinder model and a prescribed‐wake vortex code. The optimal pitch schedule is determined, and the loadings and power performance are studied for different tip‐speed ratios and solidities. The comparison of the optimised airfoils with similar airfoils from the first generation shows a significant improvement in performance, and this proves the necessity to properly select the airfoil shape.