Electrochemiluminescence (ECL) is a widely used analytical technique with the advantages of high sensitivity and low background signal. The recent and rapid development of electrochemical materials, luminophores, and optical elements significantly increases the ECL signals and, thus, ECL imaging with enhanced spatial and temporal resolutions is realized. Currently, ECL imaging is successfully applied to high-throughput bioanalysis and to visualize the distribution of molecules at single cells. Compared with other optical bioassays, no optical excitation is involved in imaging, so the approach avoids a background signal from illumination and increases the detection sensitivity. This review highlights some of the most exciting developments in this field, including the mechanisms, electrode designs, and the applications of ECL imaging in bioanalysis and at single cells and particles.

Electrochemiluminescence (ECL)-based capacitance microscopy using a square-wave voltage is established unprecedentedly to realize the label-free visualization of species on electrode surfaces and cellular plasma membranes. The drop in the local capacitance upon the binding of species to the surface or to a cellular membrane is derived to induce a relatively larger potential drop (V dl) across the double layer on the local electrode surface, which is utilized to prompt enhanced ECL at the binding position. The square-wave voltage with a frequency of as high as 1.5 kHz is proven to be favorable for the discrimination of the local ECL from the surrounding signal. Using this new detection principle and resultant capacitance microscopy, carcinoembryonic antigens (CEA) at amounts of as low as 1 pg can be visualized. Further application of this approach permits the direct imaging of CEA antigens on single MCF-7 cells through the capacitance change after the formation of the antigen–antibody complex. Successful visualization of the analyte without any ECL tag will allow not only special capacitance microscopy for label-free bioassays but also a novel ECL detection approach for the sensitive detection of biomolecules.

Electrocatalysis is dominated by reaction at the solid–liquid–gas interface; surface properties of electrocatalysts determine the electrochemical behavior. The surface charge of active sites on catalysts modulate adsorption and desorption of intermediates. However, there is no direct evidence to bridge surface charge and catalytic activity of active sites. Defects (active sites) were created on a HOPG (highly oriented pyrolytic graphite) surface that broke the intrinsic sp2‐hybridization of graphite by plasma, inducing localization of surface charge onto defective active sites, as shown by scanning ion conductance microscopy (SICM) and Kelvin probe force microscopy (KPFM). An electrochemical test revealed enhanced intrinsic activity by the localized surface charge. DFT calculations confirmed the relationship between surface charge and catalytic activity. This work correlates surface charge and catalytic activity, providing insights into electrocatalytic behavior and guiding the design of advanced electrocatalysts.

Herein, a single biomolecule is imaged by electrochemiluminescence (ECL) using Ru­(bpy)3 2+-doped silica/Au nanoparticles (RuDSNs/AuNPs) as the ECL nanoemitters. The ECL emission is confined to the local surface of RuDSNs leading to a significant enhancement in the intensity. To prove the concept, a single protein molecule at the electrode is initially visualized using the as-prepared RuDSN/AuNPs nanoemitters. Furthermore, the nanoemitter-labeled antibody is linked at the cellular membrane to image a single membrane protein at one cell, without the interference of current and optical background. The success in single-biomolecule ECL imaging solves the long-lasting task in the ultrasensitive ECL analysis, which should be able to provide more elegant information about the protein in cellular biology.

Resistive-pulse sensing with biological or solid-state nanopores and nanopipettes has been widely employed in detecting single molecules and nanoparticles. The analytical signal in such experiments is the change in ionic current caused by the molecule/particle translocation through the pipet orifice. This paper describes a new version of the resistive-pulse technique based on the use of carbon nanopipettes (CNP). The measured current is produced by electrochemical oxidation/reduction of redox molecules at the carbon surface and responds to the particle translocation. In addition to counting single entities, this technique enables qualitative and quantitative analysis of the electroactive material they contain. Using liposomes as a model system, we demonstrate the capacity of CNPs for (1) conventional resistive-pulse sensing of single liposomes, (2) electrochemical resistive-pulse sensing, and (3) electrochemical identification and quantitation of redox species (e.g., ferrocyanide, dopamine, and nitrite) contained in a single liposome. The small physical size of a CNP suggests the possibility of single-entity measurements in biological systems.

White NM, Jiang D, Burgess JD, Bederman IR, Previs SF, Kelley TJ. Altered cholesterol homeostasis in cultured and in vivo models of cystic fibrosis.

The inside walls of a nanopipette tip are decorated by a Pt deposit that is used as an open bipolar electrochemiluminescence (ECL) device to achieve intracellular wireless electroanalysis. The synergetic actions of nanopipette and of bipolar ECL lead to the spatial confinement of the voltage drop at the level of the Pt deposit, which generates ECL emission from luminol. The porous structure of Pt deposit permits the electrochemical transport of intracellular molecules into the nanopipette that is coupled with enzymatic reactions. Thus, the intracellular concentrations of hydrogen peroxide or glucose are measured in vivo as well as the intracellular sphingomyelinase activity. In comparison with the classic bipolar ECL, the remarkably low potential applied in our approach is restricted inside the nanopipette and it minimizes the potential bias of the voltage on the cellular activity. Accordingly, this wireless ECL approach provides a new direction for analysis of single living cells.

Luminol electrochemiluminescence (ECL) imaging was developed for the parallel measurement of active membrane cholesterol at single living cells, thus establishing a novel electrochemical detection technique for single cells with high analysis throughput and low detection limit. In our strategy, the luminescence generated from luminol and hydrogen peroxide upon the potential was recorded in one image so that hydrogen peroxide at the surface of multiple cells could be simultaneously analyzed. Compared with the classic microelectrode array for the parallel single-cell analysis, the plat electrode only was needed in our ECL imaging, avoiding the complexity of electrode fabrication. The optimized ECL imaging system showed that hydrogen peroxide as low as 10 μM was visible and the efflux of hydrogen peroxide from cells could be determined. Coupled with the reaction between active membrane cholesterol and cholesterol oxidase to generate hydrogen peroxide, active membrane cholesterol at cells on the electrode was analyzed at single-cell level. The luminescence intensity was correlated with the amount of active membrane cholesterol, validating our system for single-cell cholesterol analysis. The relative high standard deviation on the luminescence suggested high cellular heterogeneities on hydrogen peroxide efflux and active membrane cholesterol, which exhibited the significance of single-cell analysis. This success in ECL imaging for single-cell analysis opens a new field in the parallel measurement of surface molecules at single cells.