Bioactive nanomaterials, namely, gallium oxyhydroxide GaO(OH), also surface-conjugated GaO(OH) with a giant sugar molecule β-cyclodextrin (CD), have been prepared through a simple wet chemical route such that the same could be suitably used in biomedical diagnostics as well as therapeutic applications. Several physical methods were used for their characterization: powder X-ray diffraction pattern of GaO(OH) NPs for their grain size determination, optical spectroscopic absorption (UV-vis and FT-IR), and fluorescence properties of these NPs to ascertain surface conjugation and also their wide band-gap properties. Besides these, morphological properties of these NPs were studied by transmission electron microscopic (TEM) investigation, justifying the elemental constitution through energy dispersive X-ray analysis (EDX). Further, biological cellular uptake of these nanoparticles have been demonstrated on cancerous HeLa cells and reported with total fetal effect after 72 h, with CD templated GaO(OH) nanoparticles, a fact that has not been reported so far.

We report a fully-correlated multi-mode pumping architecture optimized for dramatic noise reduction of a class-A dual-frequency Vertical External Cavity Surface Emitting Laser (VECSEL). Thanks to amplitude division of a laser diode, the two orthogonally polarized modes emitted by the VECSEL oscillating at 852 nm are separately pumped by two beams exhibiting fully in-phase correlated intensity noises. This is shown to lead to very strong and in-phase correlations between the two lasing modes intensities. As a result, the phase noise power spectral density of the RF beat note generated by the two modes undergoes a drastic reduction of about 10 to 20 dB throughout the whole frequency range from 10 kHz to 20 MHz and falls below the detection floor above a few MHz. A good agreement is found with a model which uses the framework of rate equations coupled by cross-saturation. The remaining phase noise is attributed to thermal effects and additional technical noises and lies mainly within the bandwidth of a phase-locked-loop.

We experimentally investigate the evolution of the direct detection noise figure of a non degenerate phase sensitive amplifier based on nonlinear fiber, as a function of the relative phase between the signal, idler, and pump, all other parameters remaining fixed. The use of a fiber with a high stimulated Brillouin scattering threshold permits to investigate the full range of phase sensitive gain and noise figure without pump dithering. Good agreement is found with theory, both for signal only and combined signal and idler direct detections. arXiv:1812.03708v1 [physics.optics]

A semi-classical 7-wave model is developed to investigate the noise performances of a degenerate dual-pump phase sensitive amplifier. This approach takes into account the transfer to the signal, through multiple four-wave mixing processes, of the vacuum fluctuations injected in the high-order waves. This effect leads to a degradation of the noise figure of the amplifier with respect to the 0 dB value predicted by the usual 3-wave model. However, it is proved that a careful choice of the fiber dispersion allows to use the high-order waves to enhance the signal gain without degrading the noise figure above 1 dB.

We numerically simulate the distortion of an analog signal carried in a microwave photonics link containing a phase sensitive amplifier (PSA), focusing mainly on amplitude modulation format. The numerical model is validated by comparison with experimental measurements. By using the well known two-tone test, we compare the situations in which a standard intensity modulator is used with the one where a perfectly linear modulator would be employed. We also investigate the role of gain saturation on the nonlinearity of the PSA. Finally, we establish the conditions, in which the signal nonlinearity introduced by the PSA itself can be extremely small.

No abstract

Phase sensitive amplifiers (PSA), contrary to usual phase insensitive amplifiers (PIA), are in principle capable to achieve noiseless amplification, i.e. exhibit a quantum-limited noise figure (NF) of 0 db. When implemented using four-wave mixing (FWM) in a non-linear fibre, extra waves can be generated by undesired FWM processes, which may introduce extra input ports for vacuum fluctuations, thus potentially degrading the NF. In this situation, we give here a general analytical quantum derivation of the PSA NF, valid for an arbitrary number of nonlinearly coupled modes. This expression is usable as soon as a linear input-output relation can be found for the annihilation and creation operators of the involved modes. It predicts that the noise level depends on the number of interacting waves. We illustrate the usefulness of this expression in the case of six waves, corresponding to four interacting quantum modes. In this example the signal NF is degraded by 0.4 db, compared to 10 db obtained for PIA operation of the same scheme.

Propagation of two pumps and degenerate signal in a dispersion oscillating fiber (DOF) is investigated analytically and numerically. Unlike the single-pump case, the gain side-bands are found to be influenced by the generated high-order pumps.