LOFAR, the LOw-Frequency ARray, is a new-generation radio interferometer constructed in the north of the Netherlands and across europe. Utilizing a novel phased-array design, LOFAR covers the largely unexplored low-frequency range from 10-240 MHz and provides a number of unique observing capabilities. Spreading out from a core located near the village of Exloo in the northeast of the Netherlands, a total of 40 LOFAR stations are nearing completion. A further five stations have been deployed throughout Germany, and one station has been built in each of France, Sweden, and the UK. Digital beam-forming techniques make the LOFAR system agile and allow for rapid repointing of the telescope as well as the potential for multiple simultaneous observations. With its dense core array and long interferometric baselines, LOFAR achieves unparalleled sensitivity and angular resolution in the low-frequency radio regime. The LOFAR facilities are jointly operated by the International LOFAR Telescope (ILT) foundation, as an observatory open to the global astronomical community. LOFAR is one of the first radio observatories to feature automated processing pipelines to deliver fully calibrated science products to its user community. LOFAR's new capabilities, techniques and modus operandi make it an important pathfinder for the Square Kilometre Array (SKA). We give an overview of the LOFAR instrument, its major hardware and software components, and the core science objectives that have driven its design. In addition, we present a selection of new results from the commissioning phase of this new radio observatory.

Future high-redshift 21-cm experiments will suffer from a high degree of contamination, due both to astrophysical foregrounds and to non-astrophysical and instrumental effects. In order to reliably extract the cosmological signal from the observed data, it is essential to understand very well all data components and their influence on the extracted signal. Here we present simulated astrophysical foregrounds data cubes and discuss their possible statistical effects on the data. The foreground maps are produced assuming 5 • × 5 • windows that match those expected to be observed by the LOFAR epoch of reionization (EoR) key science project. We show that with the expected LOFAR-EoR sky and receiver noise levels, which amount to ≈52 mK at 150 MHz after 400 h of total observing time, a simple polynomial fit allows a statistical reconstruction of the signal. We also show that the polynomial fitting will work for maps with realistic yet idealized instrument response, i.e. a response that includes only a uniform uv coverage as a function of frequency and ignores many other uncertainties. Polarized Galactic synchrotron maps that include internal polarization and a number of Faraday screens along the line of sight are also simulated. The importance of these stems from the fact that the LOFAR instrument, in common with all current interferometric EoR experiments, has an instrumentally polarized response. 5 We assume a Lambda cold dark matter ( CDM) universe with b = 0.04, m = 0.26, = 0.738 and H 0 = 70.8 k ms −1 Mpc −1 .

We describe and compare several post-correlation radio frequency interference classification methods. As data sizes of observations grow with new and improved telescopes, the need for completely automated, robust methods for radio frequency interference mitigation is pressing. We investigated several classification methods and find that, for the data sets we used, the most accurate among them is the SumThreshold method. This is a new method formed from a combination of existing techniques, including a new way of thresholding. This iterative method estimates the astronomical signal by carrying out a surface fit in the time-frequency plane. With a theoretical accuracy of 95% recognition and an approximately 0.1% false probability rate in simple simulated cases, the method is in practice as good as the human eye in finding RFI. In addition it is fast, robust, does not need a data model before it can be executed and works in almost all configurations with its default parameters. The method has been compared using simulated data with several other mitigation techniques, including one based upon the singular value decomposition of the time-frequency matrix, and has shown better results than the rest.Comment: 14 pages, 12 figures (11 in colour). The software that was used in the article can be downloaded from http://www.astro.rug.nl/rfi-software

We introduce a new implementation of the fastica algorithm on simulated Low Frequency Array Epoch of Reionization data with the aim of accurately removing the foregrounds and extracting the 21‐cm reionization signal. We find that the method successfully removes the foregrounds with an average fitting error of 0.5 per cent and that the 2D and 3D power spectra are recovered across the frequency range. We find that for scales above several point spread function scales, the 21‐cm variance is successfully recovered though there is evidence of noise leakage into the reconstructed foreground components. We find that this blind independent component analysis technique provides encouraging results without the danger of prior foreground assumptions.

Radio astronomy is entering a new era with new and future radio observatories such as the Low Frequency Array and the Square Kilometer Array. We describe in detail an automated flagging pipeline and evaluate its performance. With only a fraction of the computational cost of correlation and its use of the previously introduced SumThreshold method, it is found to be both fast and unrivalled in its high accuracy. The LOFAR radio environment is analysed with the help of this pipeline. The high time and spectral resolution of LOFAR have resulted in an observatory where only a few percent of the data is lost due to RFI.

Experiments designed to measure the redshifted 21‐cm line from the epoch of reionization (EoR) are challenged by strong astrophysical foreground contamination, ionospheric distortions, complex instrumental response and other different types of noise (e.g. radio frequency interference). The astrophysical foregrounds are dominated by diffuse synchrotron emission from our Galaxy. Here we present a simulation of the Galactic emission used as a foreground module for the Low Frequency Array (LOFAR)‐EoR key science project end‐to‐end simulations. The simulation produces total and polarized intensity over 10°× 10° maps of the Galactic synchrotron and free–free emission, including all observed characteristics of the emission: spatial fluctuations of amplitude and spectral index of the synchrotron emission, together with Faraday rotation effects. The importance of these simulations arises from the fact that the Galactic polarized emission could behave in a manner similar to the EoR signal along the frequency direction. As a consequence, an improper instrumental calibration will give rise to leakages of the polarized to the total signal and mask the desired EoR signal. In this paper, we address this for the first time through realistic simulations.

On August 24 (UT) the Palomar Transient Factory (PTF) discovered PTF11kly (SN 2011fe), the youngest and most nearby type Ia supernova (SN Ia) in decades. We followed this event up in the radio (centimeter and millimeter bands) and X-ray bands, starting about a day after the estimated explosion time. We present our analysis of the radio and X-ray observations, yielding the tightest constraints yet placed on the pre-explosion mass-loss rate from the progenitor system of this supernova. We find a robust limit ofṀ ∼ < 10 −8 (w/100 km s −1 ) M ⊙ yr −1 from sensitive X-ray non-detections, as well as a similar limit from radio data, which depends, however, on assumptions about microphysical parameters. We discuss our results in the context of single-degenerate models for SNe Ia and find that our observations modestly disfavor symbiotic progenitor models involving a red giant donor, but cannot constrain systems accreting from mainsequence or sub-giant stars, including the popular supersoft channel. In view of the proximity of PTF11kly and the sensitivity of our prompt observations we would have to wait for a long time (decade or longer) in order to more meaningfully probe the circumstellar matter of Ia supernovae.

We report on the discovery of a source that exhibits over 300% amplitude changes in radio flux density on the period of hours. This source, J1819+3845, is the most extremely variable extragalactic source known in the radio sky. We believe these properties are due to interstellar scintillation and show that the source must emit at least 55% of its flux density within a radius of fewer than 16 µas at 5 GHz. The apparent brightness temperature is greater than 5x1012 K, and the source may be explained by a relativistically moving source with a Doppler factor of approximately 15. The scattering occurs predominantly in material only a few tens of parsecs from the Earth, which explains its unusually rapid variability. If the source PKS 0405-385 is similarly affected by local scattering material, Doppler factors of approximately 1000 are not required to explain this source. The discovery of a second source whose properties are well modeled by interstellar scintillation strengthens the argument for this as the cause for much of the variation seen in intraday variables.