Even in these challenging times, cardboard packaging industry is increasing its revenue with stable annual increase prediction, but customers are increasing demands on the packaging with respect to environmental protection, attractiveness, and branding. This article aims to determine the influence of image processing in terms of gray component replacement and overprint varnishing on the color reproduction on a cardboard packaging material. A test chart with tertiary colors was defined and modified by different gray component replacement levels. It was printed in accordance with ISO norm on coated and uncoated cardboard and finished by overprinting water based, offset, and UV varnish. The prepared samples were evaluated by measuring surface coverage, tone value increase (dot gain) of primary colors and calculating ΔE00 of defined tertiary colors. The results showed that gray component replacement application reduces ink consumption. Higher gray component replacement applied results in lower ink surface coverage, but the decrease is also dependent on the image content. The TVI (dot gain) is significantly influenced only by applying UV varnish, resulting with higher TVI. The color differences of the tertiary colors showed that increased level of the gray component replacement applied did not cause significant color differences, even decreased color difference in some cases. Additionally, applying gray component replacement decreased color differences in “reddish” part of the gamut. This research proved that lowering the ink consumption due to the gray component replacement will not cause significant differences in the color reproduction. Furthermore, varnishing with commercial offset or water‐based varnish will not cause higher deviations in color reproduction, but use of the UV varnish would.

No abstract

In this study, the surface modification of thin ink films with added nanoparticles was used to improve the functional properties of ink applied on paperboard substrates. The surface modification was performed by additional exposure of the samples to xenon radiation. Anatase TiO2, rutile TiO2 and ZnO were added to the base ink. The effect of surface modification on the surface, structural, and mechanical properties of the printed ink films was determined by FTIR-ATR spectroscopy, calculating the surface free energy and adhesion parameters, performing the rub resistance test of the printed samples, and by measuring the resistance to bending. Color measurements on the ink films were performed in order to observe the optical properties of unmodified and modified samples. The results showed that surface modification significantly improved the adhesion properties of the thin ink films and the mechanical properties of the samples. The results obtained on uncoated and coated paperboard showed that the addition of rutile TiO2 and ZnO nanoparticles had the greatest effect on the rub resistance of the ink films. The results of the color analysis showed that the addition of nanoparticles did not change the optical properties of the modified ink films and that rutile TiO2 and ZnO nanoparticles improved the lightfastness of the applied ink films.

No abstract

Output devices in print production can be characterized by different characterization methods. One commonly used method of color device characterization is least squares fitting. In essence, the least squares fitting is used to determine the coefficients of a predetermined polynomial, such that the sum of squared differences between the values predicted by the model and the empirical data is minimal. The choice of the polynomial order and the cross product terms which best describe the behavior of a certain device is not obvious. This paper is a part of a larger study which investigates the criteria in the measurement data which can be used for optimal model selection. The part of the study covered in this paper addresses the data over fitting problem. It is investigated by comparing the performance of models of different polynomial orders on two different domains.