Nominally anhydrous minerals formed deep in the mantle and transported to the Earth’s surface contain tens to hundreds of ppm wt H2O, providing evidence for the presence of dissolved water in the Earth’s interior. Even at these low concentrations, H2O greatly affects the physico-chemical properties of mantle materials, governing planetary dynamics and evolution. The diffusion of hydrogen (H) controls the transport of H2O in the Earth’s upper mantle, but is not fully understood for olivine ((Mg, Fe)2SiO4) the most abundant mineral in this region. Here we present new hydrogen self-diffusion coefficients in natural olivine single crystals that were determined at upper mantle conditions (2 GPa and 750–900 °C). Hydrogen self-diffusion is highly anisotropic, with values at 900 °C of 10−10.9, 10−12.8 and 10−11.9 m2/s along [100], [010] and [001] directions, respectively. Combined with the Nernst-Einstein relation, these diffusion results constrain the contribution of H to the electrical conductivity of olivine to be σH = 102.12S/m·CH2O·exp−187kJ/mol/(RT). Comparisons between the model presented in this study and magnetotelluric measurements suggest that plausible H2O concentrations in the upper mantle (≤250 ppm wt) can account for high electrical conductivity values (10−2–10−1 S/m) observed in the asthenosphere.
Hydrous wadsleyite, ringwoodite, and phase D have been synthesized in the MgO-SiO 2-H 2 O and MgO-FeO-SiO 2-H 2 O systems at mantle transition zone conditions (15-21 GPa and 1,100-1,700 • C) to investigate their water incorporation using Elastic Recoil Detection Analysis (ERDA), which is an absolute quantitative method. Wadsleyite and ringwoodite water contents vary from 0.1 to 3.2 wt% H 2 O and for ringwoodite containing up to 1.16 wt% H 2 O we observe that the (Mg+Fe)/Si ratio vs. water content follows the same trend as for wadsleyite, indicating that H is substituting for Mg as for wadsleyite. We also measured, for the first time, the water content of phase D and observed that it varies from 6.7 to 11.2 wt% H 2 O, up to twice less than estimated from electron microprobe analysis totals. Using these experiments, we were able to determine the absorptivity coefficient for OH infrared absorption bands in four wadsleyite and five ringwoodite samples. The average for the two iron-free wadsleyite samples leads to an absorptivity of 69,000 ± 7,000 L/moles H 2 O/cm 2 , in very good agreement with previous determinations. The wadsleyite with 8 mole% Fe displays an absorptivity of 67,000 ± 5,000 L/moles H 2 O/cm 2. The absorptivity values vary from 118,500 ± 5,000 for Fefree ringwoodite to ±135,000 ± 9,000 for Fe-bearing ringwoodite (10% mole Fe). Our results show that absorptivity coefficient for OH infrared absorption of ringwoodite do not drastically change with Fe content and that the frequency-based calibration of Paterson (1982) underestimates its water determinations by 50%. This is very important to know when comparing data from different studies where different extinction coefficients have been used.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.