The influence of elastic properties on finite-element analysis was investigated using a finite-element model of a Macaca fascicularis skull. Four finite-element analyses were performed in which the model was assigned different sets of elastic properties. In analysis 1, elastic properties were modeled isotropically using published data obtained from human limb bones. Analyses 2-4 used data obtained from skulls of a closely allied species, M. mulatta, but varied as to how those data were incorporated into the model. In analysis 2, the model was assigned a single set of isotropic elastic properties. In analysis 3, each region within the model was assigned its own set of isotropic elastic properties. Finally, in analysis 4, each region received its own set of orthotropic elastic properties. Although a qualitative assessment indicates that the locations of strain concentrations across the model are broadly similar in all analyses, a quantitative assessment of strain indicates some differences between the analyses. When strain data from the finite-element analyses were compared to strain data derived from in vivo experiments, it was found that the model deformed most realistically using the orthotropic elastic properties employed in analysis 4. Results suggest that finite-element analyses can be adversely affected when elastic properties are modeled imprecisely, and that modelers should attempt to obtain elastic properties data about the species and skeletal elements that are the subjects of their analyses.

The African Plio-Pleistocene hominins known as australopiths evolved a distinctive craniofacial morphology that traditionally has been viewed as a dietary adaptation for feeding on either small, hard objects or on large volumes of food. A historically influential interpretation of this morphology hypothesizes that loads applied to the premolars during feeding had a profound influence on the evolution of australopith craniofacial form. Here, we test this hypothesis using finite element analysis in conjunction with comparative, imaging, and experimental methods. We find that the facial skeleton of the Australopithecus type species, A. africanus, is well suited to withstand premolar loads. However, we suggest that the mastication of either small objects or large volumes of food is unlikely to fully explain the evolution of facial form in this species. Rather, key aspects of australopith craniofacial morphology are more likely to be related to the ingestion and initial preparation of large, mechanically protected food objects like large nuts and seeds. These foods may have broadened the diet of these hominins, possibly by being critical resources that australopiths relied on during periods when their preferred dietary items were in short supply. Our analysis reconciles apparent discrepancies between dietary reconstructions based on biomechanics, tooth morphology, and dental microwear.evolution ͉ face ͉ finite element analysis ͉ hominin ͉ diet

The wear of teeth is a major factor limiting mammalian lifespans in the wild. One method of describing worn surfaces, dental microwear texture analysis, has proved powerful for reconstructing the diets of extinct vertebrates, but has yielded unexpected results in early hominins. In particular, although australopiths exhibit derived craniodental features interpreted as adaptations for eating hard foods, most do not exhibit microwear signals indicative of this diet. However, no experiments have yet demonstrated the fundamental mechanisms and causes of this wear. Here, we report nanowear experiments where individual dust particles, phytoliths and enamel chips were slid across a flat enamel surface. Microwear features produced were influenced strongly by interacting mechanical properties and particle geometry. Quartz dust was a rigid abrasive, capable of fracturing and removing enamel pieces. By contrast, phytoliths and enamel chips deformed during sliding, forming U-shaped grooves or flat troughs in enamel, without tissue loss. Other plant tissues seem too soft to mark enamel, acting as particle transporters. We conclude that dust has overwhelming importance as a wear agent and that dietary signals preserved in dental microwear are indirect. Nanowear studies should resolve controversies over adaptive trends in mammals like enamel thickening or hypsodonty that delay functional dental loss.

No abstract

No abstract