Este trabajo propone un sistema de medición de riesgo en zonas de desprendimiento de tierra con tecnología SDRadar. El prototipo fue desarrollado en un ambiente de laboratorio en la ESPOCH de Ecuador, con la utilización de una USRP B210 que trabaja a 5 GHz, se ha incluido dos amplificadores ZJL6G+ en cascada con 20dB de ganancia total para mejorar la potencia total del sistema. En la etapa de mediciones, se usaron 3 muestras de distinto material con diferentes niveles de humedad para determinar el riesgo en diversas condiciones. Estos materiales fueron macadam, tierra y arena. En dependencia de sus niveles de humedad, los riesgos oscilan entre valores máximos y mínimos, dónde una alta humedad conlleva a un alto riesgo y viceversa. El macadam fue el mejor material para un área de derrumbe debido a que presenta un menor índice de permitividad, esto da como resultado el menor riesgo. Los resultados fueron procesados para obtener los valores de reflexión y permitividad de los materiales y fueron guardados en una base de datos para analizar y determinar los niveles de riesgo, mediante simulaciones de desprendimientos de tierras como función del nivel de humedad.
Abstract-This paper analyzes the universal software radio peripherical (USRP) B210 limitations and characteristics to develop applications on Software Defined Radar (SDRadar). The developed algorithm uses a frequency modulated constant wave (FMCW) which implement a chirp signal, taking considering that 25 MHz is the maximum bandwidth that the USRP can provide with a maximum resolution of 6 meters. The method improves the resolution through several signals transmitted with different bandwidths obtaining different resolutions, which were stored in a simple matrix and analyzed. After simulations, it is determined that the 14 measurements done with bandwidth spacing of 0.5 MHz between every signal is the best way to improve the resolution. Finally, two scenarios are described for the optimization procedure, the first scenario is limited with a measurement error less than 1 meter and the second scenario is limited by measurement error between 1 and 2 meters getting a better effectiveness of the measurement under the first scenario with 69.15% of detected objectives compared with the 30.85% of effectiveness of the second one. This paper demonstrates that the algorithm used is useful on SDRadar applications to detect objectives, for topographic applications or SAR systems. Index Terms-USRP B210, algorithm, SDRadar, FMCW, resolutionResumen-En este documento se analizan las limitaciones y características que tiene la tarjeta USRP (Universal Software Radio Peripheral) B210 para desarrollar aplicaciones de radar definidos por software (SDRadar). Para el desarrollo del algoritmo se utilizó un radar de onda continua modulada en frecuencia (FMCW) que implementa una señal chirp, al considerar que 25 MHz es el máximo ancho de banda que la tarjeta puede proporcionar se obtiene como resultado una resolución de 6 metros. El método utilizado para optimizar la resolución de la tarjeta fue transmitir un determinado número de señales con distintos anchos de banda, lo que resulta en una resolución diferente, al detectar y almacenar el objetivo en una matriz. Después de las pruebas correspondientes el algoritmo estableció que con 14 mediciones con variaciones de ancho de banda de 0.5 MHz, entre cada señal, se obtiene la mayor optimización para mejorar la resolución de la tarjeta. Se obtuvo finalmente dos zonas de optimización, donde la primera zona está limitada por un error de medición menor a 1 metro, y en la segunda zona con un error de medición entre 1 y 2 metros con 69.15% y 30.85% de objetivos detectados respectivamente, lo que determina su efectividad y confiabilidad. Este trabajo ha demostrado que el algoritmo utilizado es útil en aplicaciones SDRadar para detectar objetivos para aplicaciones topográficas o sistemas SAR. Uno de los inconvenientes de la tecnología SDR, es el ancho de banda que proporcionan para ser aplicados en sistemas SDRadar, que es una característica importante que depende de la capacidad de detección de dos objetivos o blancos en el rango, lo que es mejor conocida como resolución. Palabras Claves-USRPDesarro...
En la actualidad existen varias técnicas para evaluar la conducta ansiolítica en animales de laboratorio, debido a que su comportamiento es muy similar al del ser humano, dichas técnicas incluyen métodos manuales y visuales, donde el evaluador debe observar atentamente todo el experimento y documentar cada uno de los eventos de interés realizados por el ratón, o a su vez adquirir equipos electrónicos que cumplan esta función, sin embargo, esta alternativa podría ser demasiado costosa. El presente artículo plantea el diseño e implementación de dos equipos evaluadores de ansiedad de bajo costo (Laberinto en Cruz Elevada y Cuarto Claro Obscuro) mediante procesamiento digital de imágenes, los mismos que después de la validación del funcionamiento entrega resultados de manera automática a través de una aplicación desarrollada en Matlab. Los resultados brindados por la aplicación coinciden con aquellos que un observador obtendría de forma manual y visual, lo que facilita las labores del evaluador y reduce notablemente los posibles errores humanos y de ambigüedad existentes en las pruebas manuales.
El presente artículo ofrece un análisis comparativo de los modelos de propagación Hata Extendido, SUI con factor de corrección de frecuencia y Ericsson 9999, en los sistemas de telefonía móvil que operan en la banda de 1900 MHz (LTE) a través de mediciones de campo eléctrico con la finalidad de establecer una recomendación de un modelo de propagación existente que se ajuste a las características del casco urbano de la ciudad de Ambato. Inicialmente se ubicaron cinco estaciones base, luego se escogieron dos estaciones base que trabajan en la banda y tecnología antes mencionada. Posteriormente se trazaron 4 limites radiales en los alrededores de las estaciones base y se realizaron 4 campañas de mediciones de campo eléctrico con el equipo Narda SRM-3006 en un total de 48 puntos por 6 minutos por punto. Además, se determinó las coordenadas de los puntos de medición mediante el equipo Spectra Precision Mobile Mapper 50 donde se obtiene las distancias y alturas de terreno con gran precisión, con los datos recolectados se realizó el cálculo de las pérdidas de propagación para la obtención del campo eléctrico teórico de cada modelo de propagación. Para evaluar qué modelo se ajusta más a las mediciones se realizó una comparación de valores de campo eléctrico medido con respecto a los valores de campo eléctrico teórico de cada modelo, mediante una comparación del RMSE. Finalmente se concluyó que el modelo SUI con factor de corrección de frecuencia es el que tiene mejor ajuste al entorno urbano de la ciudad de Ambato.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.