Matrix-assisted laser desorption/ionization (MALDI) mass spectrometry is an important technique to characterize many different materials, including synthetic polymers. MALDI mass spectral data can be used to determine the polymer average molecular weights, repeat units, and end groups. One of the key issues in traditional MALDI sample preparation is making good solutions of the analyte and the matrix. Solvent-free sample preparation methods have been developed to address these issues. Previous results of solvent-free or dry prepared samples show some advantages over traditional wet sample preparation methods. Although the results of the published solvent-free sample preparation methods produced excellent mass spectra, we found the method to be very time-consuming, with significant tool cleaning, which presents a significant possibility of cross contamination. To address these issues, we developed an extension of the solvent-free method that replaces the mortar and pestle grinding with ball milling the sample in a glass vial with two small steel balls. This new method generates mass spectra with equal quality of the previous methods, but has significant advantages in productivity, eliminates cross contamination, and is applicable to liquid and soft or waxy analytes. (J Am Soc Mass Spectrom 2005, 16, 90 -93)
The results of fast atom bombardment (FAB), time-of-flight secondary ion mass spectrometry (ToF-SIMS), matrix-assisted laser desorption/ionization (MALD/I), electrospray ionization (ESI), and field desorption (FD) analyses of ethoxylated oligomers of 2,4,7,9-tetramethyl-5-decyne-4,7-diol (Surfynol(®) 104) were compared.Each of these desorption mass spectrometry (MS) techniques can produce spectra of unfragmented cationized oligomers. From the observed ion series we calculate average molecular weight information. We have compared the results of mass spectrometric analyses of a series of ethoxylated Surfynol surfactants. Our data indicate that FAB, ToF-SIMS, MALDI/I, and ESI produce similar results for the lower molecular weight species, but that as the average molecular weight increases FAB and SIMS produce slightly lower results than MALD/I and FD. This could be due to increased fragmentation. ESI produced a result similar to FAB and SIMS for the highest average molecular weight material. Further experiments compare the mass spectral results with gas chromatographic quantitative data. Although gas chromatography is not expected to accurately analyze the higher mass oligomers, we observe significant differences in intensities of the short-chain oligomers (especially the 0- and 1-mers) when compared to the desorption mass spectrometer results. These differences may reflect poor cationization efficiency for very short oligomer chains in the mass spectrometric analyses.
Matrix-assisted laser desorption/ionization (MALDI) mass spectrometry has become an important technique to characterize the chemical structure of industrial polymer materials. MALDI methods have been developed to address a broad variety of different polymer materials containing different chemistries. One of the key aspects of the typical MALDI experiment is the generation of intact ions. The development of Atmospheric Pressure (AP) MALDI quadrupole ion trap (QIT) instruments has opened another channel to obtaining MS/MS experiments for polymer samples. These experiments provide a new method to obtain chemical structure information from MALDI experiments. Collision-Induced Dissociation (CID) provides an improved MALDI MS/MS experiment that can be done on readily available mass spectrometers. AP MALDI QIT techniques have been successfully applied to a variety of synthetic polymers. This work explores the applicability of AP MALDI QIT methods to relatively low molecular weight ethoxylated surfactants. In these experiments we show the CID fragmentation mass spectra on some ethoxylated surfactants, and demonstrate the existence of analyte matrix clusters. [5][6][7]. MALDI can generate important data on the telomer repeat units, end groups, and average molecular weights of these materials. MALDI methods have been developed to address a broad variety of different polymer materials containing different chemistries. One of the key aspects of the typical MALDI experiment is the generation of intact ions. MALDI mass spectra generally show little fragmentation. The production of intact ions is vital for the quantitation of average molecular weights, but limits the amount of chemical structural information that can be obtained from the data.The development of MALDI post-source decay (PSD) techniques has opened a new method to obtain chemical structure information from MALDI experiments [8 -10]. Unfortunately, PSD experiments are relatively crude MS/MS experiments. The range of masses submitted for the fragmentation is broad, the mass resolution and mass accuracy of the fragment spectra is not as good as the MALDI data, and there is very limited control of the energy deposition into the fragmentation process.The development of atmospheric pressure (AP) MALDI instruments has enabled the utilization of different mass analyzers for MALDI [11,12]., One of the key benefits to changing the mass analyzer in a MALDI experiment is to significantly improve the MS/MS capability. A quadrupole ion trap (QIT) mass spectrometer is an excellent choice in this regard. Some early work showed examples of high quality MS/MS experiments on MALDI generated peptides [13][14][15][16]. The ability to analyze synthetic polymers using AP MALDI methods on a QIT have also been demonstrated [17].With a QIT mass spectrometer we can accomplish high quality collision-induced dissociation (CID) MS/ MS. The instrument is capable of selecting an individual ion from the mass spectrum for fragmentation. The fragmentation gas and relative energy can be controlled...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.