We measured resin flow of longleaf (Pirzus palustris Mill.) pines in red-cockaded woodpecker (Picoides borealis Vieillot) clusters in the Angelina National Forest in Texas, and the Apalachicola National Forest in Florida. Sample trees were categorized as active cavity trees, inactive cavity trees and control trees. Sample trees were further categorized by stand position as either edge or interior trees. Longleaf cavity trees in Texas and Florida had similar resin flow characteristics. Active cavity trees on forest edges had the highest resin flow, whereas active cavity trees in forest interiors had the lowest. Trees experiencing both low and high levels of red-cockaded woodpecker activity and comptition from other trees had low resin flow, whereas intermediate stress typically resulted in high resin flow. Results from this study indicate that the best active red-cockaded woodpecker cavity trees, from a resin flow perspective, are on or near forest edges. This may explain the woodpecker's observed tendency to excavate new cavities near edges even when interior basal area has been reduced and midstory has been controlled. Our results suggest that pines managed as potential cavity trees should be experiencing minimal competition, and that a mosaic of patches in red-cockaded woodpecker habitat may be preferable to more uniform conditions.

Over a 13-year period we examined the mortality of cavity trees (n = 453) used by red-cockaded woodpeckers (Picoides borealis) on national forests in eastern Texas. Bark beetles (53%), wind snap (30%), and fire (7%) were the major causes of cavity tree mortality. Bark beetles were the major cause of mortality in loblolly (Pinus taeda) and shortleaf (P. echinata) pines, whereas fire was the major cause in longleaf pines (P. palustris). Cavity trees on the Angelina National Forest (NF) were dying at a higher rate than new, complete cavities were being excavated. Cavity enlargement by pileated woodpeckers (Dryocopus pileatus) on the Angelina NF was substantial, with 20% (49/ 249) of the cavity trees being enlarged over 7 years. To reduce cavity tree mortality, site disturbances in cluster areas (e.g., midstory control, prescribed burning, thinning) should be minimized during years when southern pine beetle (Dendroctonus frontalis) populations are elevated. Careful planning of timber cutting to avoid funneling wind into cluster areas might reduce wind damage to cavity trees.

The third-stage dispersal juvenile (JIII) is the stage for survival and dispersal in the winter of the pine wood nematode, Bursaphelenchus xylophilus. Through investigations at different temperatures, we found two kinds of growth-arrested development, including the adult longevity extension and JIII formation induced by low temperature. They showed similar characters: densely packed lipid droplets and extended longevity. We considered that there were four stages in the formation of growth-arrested stages: induction, growth-arrested pathway, growth-arrested development and cold-tolerance duration. Moreover, at 4 • C there were significant changes in secondary metabolites, which may be related to signal communication and metabolism associated with the formation of growth-arrested stages. The results suggested that low temperature was necessary for the dispersal of pine wood nematode and influenced distribution and intensity of pine wilt.

The advancement of drones has revolutionized the production of aerial imagery. Using a drone with its associated flight control and image processing applications, a high resolution orthorectified mosaic from multiple individual aerial images can be produced within just a few hours. However, the positional precision and accuracy of any orthomosaic produced should not be overlooked. In this project, we flew a DJI Phantom drone once a month over a seven-month period over Oak Grove Cemetery in Nacogdoches, Texas, USA resulting in seven orthomosaics of the same location. We identified 30 ground control points (GCPs) based on permanent features in the cemetery and recorded the geographic coordinates of each GCP on each of the seven orthomosaics. Analyzing the cluster of each GCP containing seven coincident positions depicts the positional precision of the orthomosaics. Our analysis is an attempt to answer the fundamental question, “Are we obtaining the same geographic coordinates for the same feature found on every aerial image mosaic captured by a drone over time?” The results showed that the positional precision was higher at the center of the orthomosaic compared to the edge areas. In addition, the positional precision was lower parallel to the direction of the drone flight.

We evaluated selection of nest sites by male Red-cockaded Woodpeckers (Picoides borealis) in Texas relative to the age of the cavity when only cavities excavated by the woodpeckers were available and when both naturally excavated cavities and artificial cavities were available. We also evaluated nest-cavity selection relative to the ability of naturally excavated cavity trees to produce resin, which is used by the woodpeckers to maintain a barrier against predation by rat snakes (Elaphe spp.). Longleaf pines (Pinus palustris) selected by breeding males as nest trees produced significantly greater resin yields at 2, 8, and 24 h post-wounding than cavity trees used for roosting by other group members. This preference was observed in loblolly pine (P. taeda) and shortleaf pine (P. echinata) cavity trees only at the 2-h resin-sampling period. When only naturally excavated cavities were available, Red-cockaded Woodpeckers in both longleaf pine and loblolly-shortleaf pine habitat selected the newest cavities available for their nest sites, possibly as a means to reduce parasite loads. When both naturally excavated and artificial cavity inserts were available, Red-cockaded Woodpeckers continued to select the newest cavity for nesting in loblolly-shortleaf pine habitat but not in longleaf pine habitat. Resin production in existing longleaf pine nest trees remained sufficient for continued use, whereas resin production in loblolly pine and shortleaf pine nest trees decreased through time, probably because of woodpecker activity at resin wells. For these latter tree species, breeding males switched to newer cavities and/or cavity trees with higher resin yields.

Undergraduate students pursuing a Bachelor of Science in Forestry (BSF) degree at Stephen F. Austin State University (SFA) attend an intensive 6-week residential hands-on instruction in applied field methods. For students pursuing the BSF degree knowing the exact location, length, or area of a forestland is crucial to the understanding and proper management of any related natural resource. The intensive 6-week instruction includes teaching how to use the Global Positioning System (GPS) to accurately record the true spatial location of an earth's surface feature. After receiving hands-on instructions during the summer of 2013, students were taken to the field to collect real-world locations and area measurements. Upon returning from the field students were instructed how to assess the accuracy of their GPS collected waypoints by deriving the Root Mean Square Error (RMSE) comparing their GPS collected locations, derived perimeter and area assessments with the actual location, length and area respectively. Overall objective was to assess the effectiveness of GPS hands-on instruction methodology within a field-based setting. Since accurate quantitative data are crucial in any natural resource management plan, a student being able to accurately assess the real-world location and derived GPS perimeter and area measurements is essential.

Taxodium distichum (L.) Rich. var. distichum [baldcypress (BC)], Taxodium distichum var. mexicanum Gordon [Montezuma cypress (MC)], and a Taxodium hybrid (‘Nanjing Beauty’: BC × MC cross, T302) were evaluated for salt tolerance in 2006 at Nacogdoches, TX. Plants were irrigated weekly with four levels of salinity [0, 1, 3.5, and 6 ppt (0, 17, 60, and 102 mol·m−3)] for 13 weeks and then 0, 2, 7, and 12 ppt (0, 34, 120, and 204 mol·m−3) for another 12 weeks. Salinity treatments did not have a significant effect on growth rate; however, there were significant differences in growth rate among the three genotypes. Genotype T302 produced the greatest wet weight, whereas MC had stronger apical dominance and exhibited the greatest increase in height over the course of study. As expected, sodium (Na) concentration in Taxodium leaves increased as sea salt concentrations increased but did not tilt Na/potassium (K) ratios to stressful disproportions. Of the three genotypes, BC exhibited the highest leaf content of Na, calcium (Ca), sulfur (S), and iron (Fe); MC had the lowest leaf content of Na, Ca, S, and Fe; and T302 was intermediate. The benefits of using a hybrid cross (T302) that maintains greater biomass than BC or MC across a range of salinities must be weighed against the potential additional pruning and training necessary for cutting-grown clones relative to BC and MC propagated from seed and flood tolerance relative to BC. Still, combining the best characteristics of different varieties of T. distichum should facilitate the production of favorable genotypes tolerant to a number of soil physical and chemical property fluctuations for arboricultural operations.

Forestry and environmental science students enrolled in a one credit hour freshman seminar course participated in a land management evaluation and water quality sampling excursion using canoes and water sampling equipment. The purpose of this assessment was to engage students with hands-on, field based education in order to foster connections to their chosen profession and natural resources. This culminated in a poster symposium of the experience. Broad competency areas for high impact practices in natural resource management were emphasized for learning. Students were engaged in the exercise and some commented that the project helped them develop a sense of place and forming connections within their peer group. Based on numerous other studies and this qualitative assessment, the use of water quality sampling and collection of real-world data can enhance student's perception of the teaching a learning effectiveness in natural resources management course.