A one-dimensional dissipative magnetohydrodynamics code is used to investigate the discharge dynamics of a waveguide for high-intensity laser pulses: the gas-filled capillary discharge waveguide. Simulations are performed for the conditions of a recent experimental measurement of the electron density profile in hydrogen-filled capillaries [D. J. Spence et al., Phys. Rev. E 63, 015401 (R) (2001)], and are found to be in good agreement with those results. The evolution of the discharge in this device is found to be substantially different to that found in Z-pinch capillary discharges, owing to the fact that the plasma pressure is always much higher than the magnetic pressure. Three stages of the capillary discharge are identified. During the last of these the distribution of plasma inside the capillary is determined by the balance between ohmic heating, and cooling due to electron heat conduction. A simple analytical model of the discharge during the final stage is presented, and shown to be in good agreement with the magnetohydrodynamic simulations.

A hydrogen plasma waveguide for high-intensity laser pulses is described. The guiding channel is formed by a small-scale discharge in a hydrogen-filled capillary. The measured lifetime of the capillary is inferred to be greater than 10(6) shots. The results of interferometric measurements of the electron density in the capillary are presented. The guiding channel is found to be highly ionized with an axial electron density of 2.7x10(18) cm(-3), and parabolic, the curvature corresponding to a matched spot-size of 37.5 microm.

We report both theoretical and experimental results of a slit beam shaping configuration for fabricating photonic waveguides by use of femtosecond laser pulses. Most importantly we show the method supports focusing objectives with a long depth of field and allows the direct-writing of microstructures with circular cross-sections whilst employing a perpendicular writing scheme. We applied this technique to write low loss (0.39 dB/cm), single mode waveguides in phosphate glass.

We report guiding of laser pulses with peak input intensities greater than 10(17) W cm(-2) in 30 mm and 50 mm long H2-filled capillary discharge waveguides. Under conditions producing good guiding the coupling and propagation losses of the waveguide were <4% and (7+/-1) m(-1), respectively. The spectra of the transmitted pulses were not broadened significantly, but were shifted to shorter wavelength. It is concluded that this shift is not associated with significant temporal distortion of the laser pulse.

No abstract