We describe a method for quantifying the contractile forces that tumor spheroids collectively exert on highly nonlinear three-dimensional collagen networks. While three-dimensional traction force microscopy for single cells in a nonlinear matrix is computationally complex due to the variable cell shape, here we exploit the spherical symmetry of tumor spheroids to derive a scale-invariant relationship between spheroid contractility and the surrounding matrix deformations. This relationship allows us to directly translate the magnitude of matrix deformations to the total contractility of arbitrarily sized spheroids. We show that our method is accurate up to strains of 50% and remains valid even for irregularly shaped tissue samples when considering only the deformations in the far field. Finally, we demonstrate that collective forces of tumor spheroids reflect the contractility of individual cells for up to 1 hr after seeding, while collective forces on longer timescales are guided by mechanical feedback from the extracellular matrix.

ABSTRACTWe describe a method for quantifying the contractile forces that tumor spheroids collectively exert on highly nonlinear three-dimensional collagen networks. While three-dimensional traction force microscopy for single cells in a nonlinear matrix is computationally complex due to the variable cell shape, here we exploit the spherical symmetry of tumor spheroids to derive a scale-invariant relationship between spheroid contractility and the surrounding matrix deformations. This relationship allows us to directly translate the magnitude of matrix deformations to the total contractility of arbitrarily sized spheroids. We show that collective forces of tumor spheroids reflect the contractility of individual cells for up to 1h after seeding, while collective forces on longer time-scales are guided by mechanical feedback from the extracellular matrix.

Immune cells such as natural killer (NK) cells migrate with high speeds of several μm/min through dense tissue, but the traction forces are unknown. We present a method to measure dynamic traction forces of fast migrating cells in non-linear biopolymer matrices. We find that NK cells display bursts of large traction forces that increase with matrix stiffness and facilitate migration through tight constrictions.

No abstract

We describe a technique for simultaneous quantification of the contractile forces and cytosolic calcium dynamics of muscle fibers embedded in three-dimensional biopolymer gels. We derive a scaling law for linear elastic matrices such as basement membrane extract hydrogels (Matrigel) that allows us to measure contractile force from the shape of the relaxed and contracted muscle cell and the Young's modulus of the matrix, without further knowledge of the matrix deformations surrounding the cell and without performing computationally intensive inverse force reconstruction algorithms. We apply our method to isolated mouse flexor digitorum brevis (FDB) fibers that are embedded in 10 mg/ml Matrigel. Upon electrical stimulation, individual FDB fibers show twitch forces of 0.37 µN ± 0.15 µN and tetanic forces (100 Hz stimulation frequency) of 2.38 µN ± 0.71 µN, corresponding to a tension of 0.44 kPa ± 0.25 kPa and 2.53 kPa ± 1.17 kPa, respectively. Contractile forces of FDB fibers increase in response to caffeine and the troponin-calcium-stabilizer Tirasemtiv, similar to responses measured in whole muscle.From simultaneous high-speed measurements of cell length changes and cytosolic calcium concentration using confocal line scanning at a frequency of 2048 Hz, we show that twitch and tetanic force responses to electric pulses follow the low-pass filtered calcium signal. In summary, we present a technically simple high speed and high throughput method for measuring contractile forces and cytosolic calcium dynamics of single muscle fibers. We expect that our method will help to reduce preparation time, costs, and the number of sacrificed animals needed for experiments such as drug testing. Statement of significanceWe describe a high speed, high throughput method for the simultaneous measurement of contractile force and cytoplasmic calcium dynamics following electrical pulse stimulation of muscle fibers embedded in a 3-dimensional biopolymer matrix. In contrast to the classical approach of attaching muscle fibers to a force-transducer, our method allows for a highly efficient, parallel analysis of large numbers of fibers under different treatment conditions.

We describe a technique for simultaneous quantification of the contractile forces and cytosolic calcium dynamics of muscle fibers embedded in three-dimensional biopolymer gels under auxotonic loading conditions. We derive a scaling law for linear elastic matrices such as basement membrane extract hydrogels (Matrigel) that allows us to measure contractile force from the shape of the relaxed and contracted muscle cell and the Young's modulus of the matrix without further knowledge of the matrix deformations surrounding the cell and without performing computationally intensive inverse force reconstruction algorithms. We apply our method to isolated mouse flexor digitorum brevis (FDB) fibers that are embedded in 10 mg/mL Matrigel. Upon electrical stimulation, individual FDB fibers show twitch forces of 0.37 5 0.15 mN and tetanic forces (100-Hz stimulation frequency) of 2.38 5 0.71 mN, corresponding to a tension of 0.44 5 0.25 kPa and 2.53 5 1.17 kPa, respectively. Contractile forces of FDB fibers increase in response to caffeine and the troponin-calcium stabilizer tirasemtiv, similar to responses measured in whole muscle. From simultaneous high-speed measurements of cell length changes and cytosolic calcium concentration using confocal line scanning at a frequency of 2048 Hz, we show that twitch and tetanic force responses to electric pulses follow the low-pass filtered calcium signal. In summary, we present a technically simple high-speed method for measuring contractile forces and cytosolic calcium dynamics of single muscle fibers. We expect that our method will help to reduce preparation time, costs, and the number of sacrificed animals needed for experiments such as drug testing.

Mucus consistency affects voice physiology and is connected to voice disorders. Nevertheless, the rheological characteristics of human laryngeal mucus from the vocal folds remain unknown. Knowledge about mucus viscoelasticity enables fabrication of artificial mucus with natural properties, more realistic ex-vivo experiments and promotes a better understanding and improved treatment of dysphonia with regard to mucus consistency. We studied human laryngeal mucus samples from the vocal folds with two complementary approaches: 19 samples were successfully applied to particle tracking microrheology (PTM) and five additional samples to oscillatory shear rheology (OSR). Mucus was collected by experienced laryngologists from patients together with demographic data. The analysis of the viscoelasticity revealed diversity among the investigated mucus samples according to their rigidity (absolute G’ and G”). Moreover some samples revealed throughout solid-like character (G’ > G”), whereas some underwent a change from solid-like to liquid-like (G’ < G”). This led to a subdivision into three groups. We assume that the reason for the differences is a variation in the hydration level of the mucus, which affects the mucin concentration and network formation factors of the mucin mesh. The demographic data could not be correlated to the differences, except for the smoking behavior. Mucus of predominant liquid-like character was associated with current smokers.

Wetting of solid surfaces is crucial for biological and industrial processes but is also associated with several harmful phenomena such as biofouling and corrosion that limit the effectiveness of various technologies in aquatic environments. Despite extensive research, these challenges remain critical today. Recently, we have developed a facile UVgrafting technique to covalently attach silicone-based coatings to solid substrates. In this study, the grafting process was evaluated as a function of UV exposure time on aluminum substrates. While short-time exposure to UV light results in the formation of lubricantinfused slippery surfaces (LISS), a flat, nonporous variant of slippery liquid-infused porous surfaces, longer exposure leads to the formation of semi-rigid cross-linked polydimethylsiloxane (PDMS) coatings, both covalently bound to the substrate. These coatings were exposed to aquatic media to evaluate their resistance to corrosion and biofouling. While the UV-grafted cross-linked PDMS coating effectively inhibits aluminum corrosion in aquatic environments and allows organisms to grow on the surface, the LISS coating demonstrates improved corrosion resistance but inhibits biofilm adhesion. The synergy between facile and low-cost fabrication, rapid binding kinetics, eco-friendliness, and nontoxicity of the applied materials to aquatic life combined with excellent wetting-repellent characteristics make this technology applicable for implementation in aquatic environments.