A sensor array based on heterojunctions between semiconducting organic layers and single walled carbon nanotube (SWCNT) films was produced to explore applications in breathomics, the molecular analysis of exhaled breath. The array was exposed to gas/volatiles relevant to specific diseases (ammonia, ethanol, acetone, 2-propanol, sodium hypochlorite, benzene, hydrogen sulfide, and nitrogen dioxide). Then, to evaluate its capability to operate with real relevant biological samples the array was exposed to human breath exhaled from healthy subjects. Finally, to provide a proof of concept of its diagnostic potential, the array was exposed to exhaled breath samples collected from subjects with chronic obstructive pulmonary disease (COPD), an airway chronic inflammatory disease not yet investigated with CNT-based sensor arrays, and the results were compared to those from of healthy subjects breathprints. Principal component analysis showed that the sensor array was able to detect various target gas/volatiles with a clear fingerprint on a 2D subspace, was suitable for breath profiling in exhaled human breath, and was able to distinguish subjects with COPD from healthy subjects based on their breathprints. This classification ability was further improved by selecting the most responsive sensors to nitrogen dioxide, which has been proposed as a biomarker of COPD.

Electrically conductive hydrogels (ECHs) are attracting much interest in the field of biomaterials science because of their unique properties. However, effective incorporation and dispersion of conductive materials in the matrices of polymeric hydrogels for improved conductivity remains a great challenge. Here, we demonstrate highly transparent, electrically conductive, stretchable tough hydrogels modified by single-walled carbon nanotubes (SWCNTs). Two different approaches for the fabrication of SWCNT/hydrogel structures are examined: a simple SWCNT film transfer onto the as-prepared hydrogel and the film deposition onto the pre-stretched hydrogel. Functionality of our method is confirmed by scanning electron microscopy along with optical and electrical measurements of our structures while subjecting them to different strains. Since the hydrogel-based structures are intrinsically soft, stretchable, wet, and sticky, they conform well to a human skin. We demonstrate applications of our material as skin-like passive electrodes and active finger-mounted joint motion sensors. Our technique shows promise to accelerate the development of biointegrated wearable electronics.

Soft, flexible, and stretchable electronic devices provide novel integration opportunities for wearable and implantable technologies. Despite the existing efforts to endow electronics with the capability of large deformation, the main technological challenge is still in the absence of suitable materials for the manufacturing of stretchable electronic circuits and devices with active (sensitive) and passive (stable) components. Here, we present a universal material, based on single-walled carbon nanotube (SWCNT) films deposited on a polydimethylsiloxane (PDMS) substrate, which can act as a material being both sensitive and insensitive to strain. The diverse performance of SWCNT/PDMS structures was achieved by two simple dry-transfer fabrication approaches: SWCNT film deposition onto the as-prepared PDMS and on the prestretched PDMS surface. The correlation between applied strain, microstructural evolution, and electro-optical properties is discussed on the basis of both experimental and computational results. The SWCNT/PDMS material with the mechanically tunable performance has a small relative resistance change from 0.05 to 0.07, while being stretched from 10 to 40% (stable electrode applications). A high sensitivity of 20.1 of the SWCNT/ PDMS structures at a 100% strain was achieved (strain sensing applications). Our SWCNT/PDMS structures have superior transparency and conductivity compared to the ones reported previously, including the SWCNT/PDMS structures, obtained by wet processes.

Materials with electrically tunable optical properties offer a wide range of opportunities for photonic applications. The optical properties of the single-walled carbon nanotubes (SWCNTs) can be significantly altered in the near-infrared region by means of electrochemical doping. The states’ filling, which is responsible for the optical absorption suppression under doping, also alters the nonlinear optical response of the material. Here, for the first time we report that the electrochemical doping can tailor the nonlinear optical absorption of SWCNT films and demonstrate its application to control pulsed fiber laser generation. With a pump–probe technique, we show that under an applied voltage below 2 V the photobleaching of the material can be gradually reduced and even turned to photoinduced absorption. Furthermore, we integrated a carbon nanotube electrochemical cell on a side-polished fiber to tune the absorption saturation and implemented it into the fully polarization-maintaining fiber laser. We show that the pulse generation regime can be reversibly switched between femtosecond mode-locking and microsecond Q-switching using different gate voltages. This approach paves the road toward carbon nanotube optical devices with tunable nonlinearity.

We theoretically investigate intersubband plasmon excitations in doped single wall carbon nanotubes (SWNTs) by examining the dependence of plasmon frequency on the nanotube diameter, chirality, and Fermi energy. The intersubband plasmons can be excited by light with polarization perpendicular to the nanotube axis and thus the plasmon excitations corresponds to optical transitions between the two different subbands, which are sensitive to the Fermi energy. In every SWNT, this mechanism leads to the emergence of the optical absorption peak at the plasmon frequency for a given Fermi energy, EF . The plasmon frequencies calculated for many SWNTs with diameter dt < 2 nm exhibit a dependence on (1/dt) 0.7 and the frequencies are further affected by Fermi energy as E 0.25 F . With this knowledge, it is possible to develop a map of intersubband plasmon excitations in doped SWNTs that could be useful to quickly estimate the doping level and also be an alternative way to characterize nanotube chirality.