BackgroundHeat transfer enhancement technology concerns with the aim of developing more efficient systems to satisfy the increasing demands of many applications in the fields of automotive, aerospace, electronic and process industry. A solution for obtaining efficient cooling systems is represented by the use of confined or unconfined impinging jets. Moreover, the possibility of increasing the thermal performances of the working fluids can be taken into account, and the introduction of nanoparticles in a base fluid can be considered.ResultsIn this article, a numerical investigation on confined impinging slot jet working with a mixture of water and Al2O3 nanoparticles is described. The flow is turbulent and a constant temperature is applied on the impinging. A single-phase model approach has been adopted. Different geometric ratios, particle volume concentrations and Reynolds number have been considered to study the behavior of the system in terms of average and local Nusselt number, convective heat transfer coefficient and required pumping power profiles, temperature fields and stream function contours.ConclusionsThe dimensionless stream function contours show that the intensity and size of the vortex structures depend on the confining effects, given by H/W ratio, Reynolds number and particle concentrations. Furthermore, for increasing concentrations, nanofluids realize increasing fluid bulk temperature, as a result of the elevated thermal conductivity of mixtures. The local Nusselt number profiles show the highest values at the stagnation point, and the lowest at the end of the heated plate. The average Nusselt number increases for increasing particle concentrations and Reynolds numbers; moreover, the highest values are observed for H/W = 10, and a maximum increase of 18% is detected at a concentration equal to 6%. The required pumping power as well as Reynolds number increases and particle concentrations grow, which is almost 4.8 times greater than the values calculated in the case of base fluid.List of symbols
Rat liver ultrastructure was investigated after partial hepatectomy (PH), by scanning and transmission electron microscopy. Portal pressure was monitored before and after PH and, after killing performed at 6, 12, 24, 48 h and 10 d, regenerating livers were fixed by portal vein perfusion under haemodynamic conditions identical to those existing in vivo. An early and persistent increase in portal pressure after PH was found (P 0.01 for normal vs sham-operated controls). Ultrastructural study showed sinusoid dilatation and disappearance of the sieve-plate arrangement of small endothelial pores, thus leaving the parenchymal liver cell surface directly exposed to portal blood. Widening of sinusoids, endothelial fenestrations, intercellular spaces and spaces of Disse, was accompanied by dilatation of bile canaliculi. At 10 d, liver ultrastructure had returned to normal. Our observations suggest that a rise in portal pressure, as a consequence of PH, may be related to the observed ultrastructural changes in the liver.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.