We report on highly efficient gas diffusion barriers for organic light emitting diodes (OLEDs). Nanolaminate (NL) structures composed of alternating Al2O3 and ZrO2 sublayers grown by atomic layer deposition at 80 °C are used to realize long-term stable OLED devices. While the brightness of phosphorescent p-i-n OLEDs sealed by a single Al2O3 layer drops to 85% of the initial luminance of 1000 cd/m2 after 1000 h of continuous operation, OLEDs encapsulated with the NL retain more than 95% of their brightness. An extrapolated device lifetime substantially in excess of 10 000 h can be achieved, clearly proving the suitability of the NLs as highly dense and reliable thin film encapsulation of sensitive organic electronic devices.

We report the design and characterization of three heteroleptic orange-red phosphorescent iridium(III) complexes bearing two 2-(4-fluorophenyl)-3-methyl-quinoxaline (fpmqx) cyclometalated ligands combined with three different ancillary ligands, triazolylpyridine (trz), picolinate (pic), and acetylacetonate (acac). All of these complexes emit an orange to red color in the spectral range of 605-628 nm in dichloromethane. Strong spin-orbit coupling of the iridium atom allows the formally forbidden mixing of singlet and triplet states. Because of the structureless phosphorescent line shapes and low Stokes shifts between triplet metal-to-ligand charge-transfer ((3)MLCT) absorption and phosphorescent emission, we propose that emission originates predominantly from the (3)MLCT state with a lesser admixture of totally ligand-based (3)(pi-pi*) states. The influence of 5d-electron densities of the iridium center on highest occupied molecular orbitals leads to high emission quantum yields in toluene (Phi(p) = 0.39-0.42) and to short triplet lifetimes. Cyclovoltammetry measurements show reversible oxidation peaks from 0.74 to 0.92 V and reversible reduction waves with potentials ranging from -1.58 to -2.05 V versus Cp(2)Fe/Cp(2)Fe(+). All complexes have been applied in simple test devices and also in stable, long-living devices to evaluate their electroluminescent device performances, for which we especially report the influence of the chosen ancillary ligands on emission colors, efficiencies, and device lifetimes. We obtained narrowband emission ranging from 613 to 630 nm with a full width at half-maximum of 64-71 nm, and a maximum in power efficiency of eta(p) = 14.6 lm/W at a current density of J = 0.01 mA/cm(2) for [(fpmqx)(2)Ir(pic)]. The operating lifetimes of [(fpmqx)(2)Ir(trz)] in both neat and mixed matrixes were longer than that of the established stable tris(1-phenylisoquinolinato)iridium(III) [Ir(piq)(3)]. From the lifetime measurements, it becomes clear that the stability is strongly correlated to the type of ancillary ligand. An extrapolated lifetime of 58 000 h with an initial brightness of 1000 cd/m(2), together with a very low voltage increase of 0.2 V over a time period of 1000 h (starting voltage of 4.1 V), was achieved. Such a high device lifetime is attributed to the chemical stability of all materials toward both charge carriers and excitons.

A series of novel styrene functionalized monomers with phenylbenzo[d]imidazole units and the corresponding homopolymers are prepared. These side‐chain polymers show high glass‐transition temperatures that even exceed the corresponding value for the common electron‐transporting material 1,3,5‐tris(1‐phenyl‐1H‐benzo[d]imidazol‐2‐yl)benzene (TPBI). Similar electronic behavior between the polymers and TPBI is shown. The polymers are used as matrices for phosphorescent dopants. The fabricated devices exhibit current efficiencies up to 38.5 cd A−1 at 100 cd m−2 and maximum luminances of 7400 cd m−2 at 10 V with a minimum turn‐on voltage as low as 2.70 V in single‐layer devices with an ITO/PEDOT:PSS anode (ITO = indium tin oxide, PEDOT:PSS = poly(3,4‐ethylenedioxythiophene) doped with poly(styrenesulfonate)) and a CsF/Ca/Ag cathode.

Gas diffusion barriers based on nanolaminates of alternating Al2O3/ZrO2 layers prepared by atomic layer deposition at 80 °C are presented. Water vapor permeation rates as low as 4.7×10−5g/(m2 day) are determined (at 70 °C and 70 % rh). Compared to single Al2O3 encapsulation layers, a reduced density of statistical defects is found. The reliable nanolaminate encapsulation is demonstrated by OLED lifetime measurements.

No abstract