Infertility has become more common, with an increased exposure to toxic compounds including heavy metals (HM). Follicular fluid (FF) surrounds the developing oocyte in the ovary and can be analysed to assess metal content. The levels of twenty-two metals were measured in the FF of ninety-three females in a reproduction unit, and their influence on assisted reproduction technique (ART), were examined. The metals were determined by optical emission spectrophotometry. Low values of copper, zinc, aluminium, and calcium favour polycystic ovary syndrome. The relationships between the number of oocytes and metals: iron (rs=0.303; p=0.003) and calcium (rs=−0.276; p=0.007) are significant, as well as between the number of mature oocytes with iron (rs=0.319; p=0.002), calcium (rs=−0.307; p=0.003) and sodium (rs=−0.215; p=0.039) and are near to significance in the case of aluminium (rs=−0.198; p=0.057). In the group with a fertilisation rate ≤ 75%, 36% of the women presented calcium >176.62 mg/kg compared to the group with a fertilisation rate ≥ 75% where this percentage was only 10% (p=0.011). An excess of iron and calcium reduces the good quality embryo rate, and an excess of potassium impairs the blastocyst rate. If potassium is above 237.18 mg/kg and calcium is below 147.32 mg/kg, these conditions favour embryo implantation. Pregnancy is influenced by high potassium and low copper levels. Controlling exposure to toxic elements is recommended for all couples with reduced fertility or receiving an ART.

Sports nutrition supplementation is a widespread practice. Whey protein supplements contribute not only to protein intake but also to dietary exposure to minerals. The labelling present provides the percentage of protein and rarely refers to other components, such as potentially toxic elements such as B, Cu, Mo, Zn, and V that present tolerable upper intake levels set by the European Food Safety Authority. The percentage of protein declared on supplement labelling was checked using the Kjeldahl method, and the levels of Ca, Mg, K, Na, Ba, B, Co, Cu, Cr, Sr, Fe, Li, Mn, Mo, Ni, V, Zn, and Al were analyzed by ICP-OES with the aim of characterizing the protein and mineral contents of isolate and concentrate whey protein supplements representative of the European market. The protein content was 70.9% (18–92.3%) and statistically significant differences were observed between the declared and real protein percentages. Among the minerals, K (4689.10 mg/kg) and Ca (3811.27 mg/kg) presented the highest levels, whereas Co (0.07 mg/kg) and V (0.04 mg/kg) showed the lowest levels. It was concluded that the quality and safety of these products needs to be monitored and regulated. A high degree of non-compliance with labelling claims was detected. Furthermore, the contributions to the recommended and tolerable intakes among regular consumers need to be assessed.

Baby food from jars is made of meat, vegetables or fruits, and might be a valuable source of essential elements such as Na or K. However, these infant products could also be a source of toxic elements such as Al or Cd, which are dangerous to infants. In total, 45 samples of various kinds of baby food in jars (meat, vegetables, fruit and mixed) were analyzed using inductively coupled plasma spectrometry (ICP OES) with the aim of evaluating the daily intake of essential elements (K, Na, Ca, Mg, Fe, Zn, Cu, Co, Mo, Mn) and dietary exposure to toxic elements (Al, Cd, Pb, B, Ba, V, Sr, Li, Ni). Mixed jars registered the highest concentrations of Na, Ca, Zn, Fe. Al (8.22 ± 8.97 mg/kg wet weight) stands out in vegetable jars. In total, 130 g/day of mixed jars fulfills daily Zn and Ca requirements. These consumption scenarios (130 g/day, 250 g/day) supposed high Mn intakes (40 times higher than the recommended value), which could pose a risk to infants’ health. Pb, Ni, Cd and Al intakes exceed the maximum values. It is recommended to avoid the daily consumption of these products since it can pose a risk to the health of infants. Chemical compounds studied in this article: Nitric acid (PubChem: CID 944).

The Canary Islands, located in the Atlantic Ocean, are an archipelago of volcanic origin which, for decades, has been affected by natural fluoride contamination in the water supply of some of its islands, mainly the island of Tenerife. In addition, recent volcanic eruptions in the archipelago and the increased demand for water supply have led to an increase in the fluoride content in other areas which, historically, were not affected. Fluoride content was determined in 274 water supply samples from the most populated islands of the Canary Islands (Tenerife and Gran Canaria) collected during the months of June 2021 to May 2022. The samples were analysed by fluoride ion selective potentiometry. The highest concentrations in Tenerife were found in the municipalities of Sauzal (7.00 mg/L) and Tegueste (5.39 mg/L), both water samples are over the parametric value of 1.5 mg/L set in the supply water legislation. In the Gran Canaria Island, the highest fluoride levels were found in Valsequillo and Mogán with 1.44 mg/L in both locations, but under the parametric fluoride value abovementioned. Consumption of just 1 L of water per day in the El Sauzal area would result in a contribution rate of 77% for adults and children over 15 years of age (Upper Level value of 7 mg/day) and 108% for children 9–14 years of age (UL value of 5 mg/day). The contribution rates increase considerably, reaching or exceeding 100% of the reference value (UL) with increasing consumption of 1 to 2 L of water per day. Therefore, it is considered that there is a health risk of overexposure to fluoride on the island of Tenerife. In the case of the island of Gran Canaria, it has been shown that even the consumption of 2 litres of water per day does not confer contribution rates that pose a health risk.

Fluoride is present in various foods ingested daily. It has been demonstrated that the intake of high concentrations of fluoride, both in adults and children, can cause pathologies, among which dental fluorosis, osteoporosis and damage to the central nervous system stand out. The objective of this study was to determine the fluoride concentrations in 60 samples of ready-to-drink cold brewed coffee of different brands and types (expresso, cappuccino, macchiato and decaffeinated) by the fluoride ion-selective potentiometric method. A statistical analysis was also performed to discern the existence of differences between these categories. The highest fluoride concentration (1.465 mg/L) was found in espresso coffee followed by Macchiato (1.254 mg/L). Decaffeinated coffee is the one that presented the lowest fluoride concentration with 0.845 mg/L. The risk assessment was conducted considering different consumption scenarios (250, 500 and 750 mL/day). The UL (upper level) established by the EFSA (European Food Safety Authority) at 7 mg/day was used. The consumption of three servings poses no health risk; however, it confers a significant value of fluoride contribution to the diet.