In view of the Hydrogen Economy and its endless possibilities, this work studies the hydrogen production using solar photovoltaic energy. With increasing global energy consumption, new methods of energy production have got to be taken into consideration, as hydrogen that it is an energy carrier with low environmental impact. On the other hand, fossil fuel reserves will not be able to meet this demand in the long term and its continuous use produces side effects such as pollution that threatens human health and greenhouse gases which are associated with climate change. For Brazilian energy context, electrolysis combined with renewable power source and fuel cell power generation would be a good basis to improve the distributed energy supply. It is proposed in this paper, to produce hydrogen by a direct coupling of a PV array with an experimental alkaline electrolyzer designed locally. It seeks to understand the inherent characteristics of the interaction of these energy forms, find the efficiencies of each step of the assembled system, as well as the global efficiency, acquiring a more precise notion and practice of the use of solar photovoltaic coupled with an electrolyzer. The experimental results showed that the transfer of energy from the PV array to the electrolyzer depends heavily on instant climatic conditions and how they are connected. The interdependence between variables was reproduced by the investigations, considering especially: current density, electric potential, solar irradiance, concentration of electrolyte, the electrode area and size of the electrolytic cell. The electrolyzer achieved an efficiency of 21%, approximately one-third of a commercial electrolyser efficiency. The overall efficiency (sol-hydrogen) was 2%. The present study gives subsidies to design an electrolyser-PV generator system based on a given electrolytic cell seeking low losses.

KNOB, D. Evaluation of impurities of the Brazilian solar grade silicon and LeTID investigations in p-type multi-Si. 2019. 119 p. Thesis (Doctorate in Nuclear Technology-Materials)-Instituto de Pesquisas Energéticas e Nucleares-IPEN-CNEN/SP. São Paulo The cost reductions and the environmental benefits aligned with global concerns about climate change have made solar photovoltaic technology the most installed source of energy in the power sector worldwide. Brazil has the largest know reserves of silicon in the world. Therefore, there is a huge potential for developing a national technology for purifying and manufacturing silicon wafers within an increasingly competitive and efficient photovoltaic industry. The IPEN initiative of investigating the production of metallic silicon and metallurgical route purification required a characterization of samples in different stages of production from quartz to wafer and understanding the characterization methods for silicon wafers taking into account the main defect mechanisms such as light-induced degradation. Metalic silicon is produced in IPEN via magnesiothermal reduction through acid leaching to form a metallurgical grade silicon with relatively low impurities. One more acid leaching step resulted in a specific ultrametallurgical grade silicon. The same acid leaching was processed in a commercially available Brazilian-made metallurgical grade silicon produced via carbothermal reduction. All samples impurities was measured by ICP-OES. The result is a material with ultra-metallurgical grade silicon content with excess of B and P. While wafer characterization was studied, an extensive investigation was taken on LeTID, which causes remain unknown, at Institute for Energy Technology, Norway. Neighboring high performance mc-Si p-type wafers were tested in different firing process conditions. The effects was investigated in terms of defects activation and a corresponding lifetime degradation and recovery at illuminated annealing. A sample with almost fully suppressed LeTID is shown. A new method have been proposed to separate Boron Oxygen-Light Induced Degradation effects of LeTID, enabling to measure even where it was thought to be fully suppressed. New models for LeTID defect formation and suppression are proposed. Both silicon purification and light-induced degradation characterization in mc-Si studies shows a wide range of research on new production routes that may require tailored processes of crystallization and solar cell manufacturing such as gettering and firing.