No abstract

Water-saturation porosity and dye-penetration permeability measurements of Round Top Mountain rhyolite confirm that a ½-inch (13-mm) crush size would permit efficient acid heap leaching of yttrium and heavy rare earth elements (YHREEs) hosted in yttrofluorite, a YHREE-substituted variety of fluorite. Laboratory acid leaching has extracted up to 90% of the YHREEs. The bulk insoluble gangue mineralogy of the rhyolite, 90% to 95% quartz and feldspars, assures low acid consumption. Different crush sizes were weighed, soaked in water, and reweighed over time to determine water-penetration estimated porosity. Typical porosities were 1% to 2% for gray and 3% to 8% for pink varieties of Round Top rhyolite. The same samples were re-tested after soaking in dilute sulfuric to simulate heap leaching effects. Post-leach porosity favorably increased 15% in pink and 50% in gray varieties, due to internal mineral dissolution. Next, drops of water-based writing ink were placed on rhyolite slabs up to~10 mm thick, and monitored over time for visual dye breakthrough to the lower side. Ink penetration through 0.5 to 2.5-mm-thick slabs was rapid, with breakthrough in minutes to a few hours. Pink rhyolite breakthrough was faster than gray. Thicker slabs, 4 to 10 mm, took hours to three days for breakthrough. Porosity and permeability of the Round Top rhyolite and acid solubility of the yttrofluorite host should permit liberation of YHREEs from the bulk rock by inexpensive heap leaching at a coarse and inexpensive nominal ½-inch (13-mm) crush size. The rate-limiting step in heap leach extraction would be diffusion of acid into, and back-diffusion of dissolution products out of, the crushed particles. The exceptional porosity and permeability that we document at Round Top suggest that there may be other crystalline rock deposits that economically can be exploited by a coarse-crush bulk heap leach approach.

The electron microprobe maps the spatial distribution of elements in a rock at a sub-mineral-grain scale to provide a basis for understanding mineralization processes and to determine optimal strategies for extraction of valuable target elements. Round Top Mountain (near the town of Sierra Blanca, Hudspeth County, west Texas, USA) is a peraluminous rhyolite laccolith that is homogeneously mineralized at over 500 ppm rare earths, more than 70% of which are yttrium and heavy rare earths (YHREEs). The massive deposit is exposed at the surface as a mountain some 2 km in diameter and 375 m in height. Round Top Mountain also contains Li, Be, U, Th, Nb, Ta, Ga, Rb, Cs, Sn, and F. The valuable YHREEs are hosted in yttrofluorite, which is soluble in dilute sulfuric acid. Texas Mineral Resources Corporation proposes to surface mine, crush, and heap leach the deposit. The distribution of YHREEs, and that of other trace elements, is remarkably homogeneous at outcrop drill hole scale. Here we document that YHREE mineralization appears pervasive through the rhyolite at a millimeter scale. Back scattered electron (BSE) and characteristic X-ray maps reveal the fine grain size and apparently random and dispersed spatial distribution of the yttrofluorite that hosts Round Top's valuable YHREEs. The yttrofluorite grains do not appear to cluster at special mineralized locations, e.g., in pores or along cracks in the rhyolite. The same is apparently true of such other potentially valuable minerals as cassiterite and uranium species. These findings confirm that the distribution of YHREEs in Round Top Mountain rhyolite is homogeneous through different orders of magnitude of scale, i.e., from outcrop (as seen in the companion work in this volume) to sub-thin section. The material thus is ideal for a heap leach operation where homogeneous feedstock is crucial to consistent and economic operation. The findings also confirm and explain why mechanical separation would prove very difficult and expensive due to the astronomical number of yttrofluorite grains in even a golf-ball-size piece of Round Top rhyolite.How to cite this paper: Pingitore

The peraluminous rhyolite that forms Round Top Mountain (approximately 375 m high × nearly 2 km in diameter), near Sierra Blanca, Hudspeth County, west Texas, USA, is enriched in yttrium and heavy rare earth elements (YHREEs), as well as Li, Be, U, Th, Sn, F, Rb, Cs, Nb, and Ta. Texas Mineral Resources Corp. (USA) proposes to release the YHREEs from their unique yttrofluorite host via heap leaching with dilute sulfuric acid. The inexpensive process also releases portions of valuable byproduct Be, Li, and U from accessory minerals amid the insoluble feldspars and quartz that comprise 90% -95% of the surface-exposed rhyolite mountain. The objective of this study is to determine the consistency of mineralization grade, an important consideration in mine planning and preliminary economic analysis. The method is to plot elemental analyses of Y, Dy, Ho, Tm, Yb, Ce, Pr, Nd, Eu, Gd, Tb, U, and Nb from more than 1400 reverse circulation cuttings taken from 64 exploration drill holes against sample depth. The result of inspection of the plots reveals a remarkably homogeneous distribution of minor and trace elements throughout the sampled portion of the massive, 1.6-billion-tonne laccolith. The plots drive the conclusion that Round Top mine feedstock should remain constant for the life of the mine (multiple decades). Thus mining mechanics could be optimized at the start of operations and not require expensive later changes. The physical and chemical design of the heap leach and recovery and purification of target elements from pregnant leach solution also could be perfected during early development.

Rare earth elements (REEs), especially heavy rare earth elements (HREEs), are in demand for their current and emerging applications in advanced technologies. Here we perform computer-driven micro-mapping at the millimeter scale of the minerals that comprise Round Top Mountain, in west Texas, USA. This large rhyolite deposit is enriched in HREEs and such other critical elements as Li, Be, and U. Electron probe microanalysis of 2 × 2 mm areas of thin sections of the rhyolite produced individual maps of 16 elements. These were superimposed to generate a 16-element composition at each pixel. Principal components analysis of elements at each pixel identified the specific mineral at that site. The pixels were then relabeled as the appropriate minerals, thereby producing a single mineral map. The overall mineral composition of the 7 studied samples compared favorably with prior analyses of the Round Top deposit available in the literature. Likewise the range of porosity in the maps was consistent with that of previous direct measurements by water saturation. This new statistical and GIS-based technique provides a robust and unbiased approach to electron microprobe mapping. The study further showed that the high-value yttrofluorite grains exhibited little tendency to cluster with other late-stage trace minerals and that the samples extended the previously documented overall homogeneity of the deposit at field scale to this microscopic scale.

Separation of target elements or minerals from their host rock or ore is essential to successful mining operation. The inevitable loss of a portion of the desired material that accompanies each step in the extraction process must be documented to develop the operational protocol. Superposition of the characteristic X-ray fluorescence spectra of head (crushed rock ore particles, pre-processing) and tail (post-processing particles) samples provides a direct visual comparison of relative peak sizes, and thereby the relative concentrations, of elements of interest. If the head and tail peaks are identical, none of the element was recovered in the extraction process. At the other extreme if the tail peak "flat lines", i.e., there is no peak, there was

Critical and rare earth elements are in high demand for their increasing incorporation in modern technological devices for applications in the military, industrial, commercial, and consumer sectors. Round Top Mountain, a rhyolite laccolith in Sierra Blanca, west Texas, U.S.A. is a unique mineral deposit that offers opportunity for development of rare earth elements, especially the heavy rare earths, as well as associated critical elements. The main objective here is to evaluate the distances between accessory minerals of potential economic value (yttrofluorite, cryolite, uraninite, thorite, cassiterite, and columbite), and to major (potassium feldspar, albite, and quartz) and minor minerals (annite mica, magnetite, and zircon). In this study we explore the proximity and clustering of these minor and accessory minerals, at the micron-to-millimeter scale, from mineral maps constructed in a previous application of ArcGIS™ tools to electron probe microanalysis (EPMA) element maps. Our goal is to determine whether specific minerals cluster spatially and, if so, at what distances. We noted that the high-value target yttrofluorite grains often neighbor potassium feldspar and quartz grains, but less commonly magnetite and mica grains. With regard to cluster analysis, most minor and accessory minerals were found to group together at small scales (low micrometer) and were dispersed or random at larger (up to 1 mm) distances.

This study demonstrated using yttrium (Y) as an indicator to estimate the total rare earth element and Y contents (REY) in coal-associated samples and to facilitate selection of samples with high REY assays in a fast and inexpensive manner. More than 10 anthracite-associated samples were collected from each of three Pennsylvanian sites (sites B, J and C) based on Thorium gamma ray logging suggesting high REY content. Several samples from each site were analyzed by ICP-MS to determine the rare earth distribution patterns and to establish the site-specific linear equations of Y and REY. The Y contents of the remaining samples were measured by a portable X-ray fluorescence analyzer, and the REY values were estimated based on the site-specific linear equation developed earlier. R-squared values above 0.70 were obtained for all the estimation equations from all three sites on both a whole sample basis and an ash basis. Previously, ash content has been widely used as an indicator of high REY content. This may not be applicable for a specific site. Site B in this study is an example where ash contents could not be statistically correlated with REY, so using Y for estimation is more applicable. The demonstrated sample screening process is suitable for samples from sites that share more similar distribution patterns (either MREY or LREY or HREY) as well as for samples from sites that share multiple distribution patterns (LREY/ MREY/HREY) depending on the desirable accuracy. The demonstrated process lowers the analytical cost from $70 to 80 dollars per sample to $10-15 per sample while significantly reducing the processing time and acid consumption for ICP digestion. This is particularly true when a relatively large sample size is involved, for example, 100 samples from one site analyzed by ICP-MS/OES.