This paper presents a comparative study of the AC and MFDC resistance spot welding process. Both experiments and finite element simulation were conducted to compare the weld size and energy consumption. The experiments were performed on two identical spot welding machines, one with a single phase ac and the other with a mid-frequency DC weld control. The machines were instrumented such that both the primary and secondary voltage and current signals could be collected for energy calculation. The finite element simulation model was developed to understand the underlying mechanisms of the difference between the ac and MFDC processes. The effect of the current waveform was investigated by using the actual process measurements as an input to the simulation model. It is shown that the MFDC process generally produces larger welds than the AC process with the same root-mean-square welding current. However, this difference is more prominent when the welding current is relatively low. Overall, the AC welding process consumes more energy to make a same sized weld than the MFDC process. The larger the welding current is used, the less efficient the AC welding process will become. The differences between the two welding processes are caused by the contact resistance behavior and the electrical inductance in the AC welding process.
This paper presents a comparative study of the AC and MFDC resistance spot welding process. Two identical welders were used; one with a single phase AC and the other with a median frequency DC weld control. Both welders were instrumented such that the primary and secondary voltage and current could be collected. A nugget growth experiment was conducted to compare the weld size and energy consumption in the AC and MFDC welding processes. It is found that the MFDC process generally produces larger welds with the same welding current. However, this difference is more prominent when the welding current is low. Overall the AC welding process consumes more energy to make a same size weld. The larger the welding current is used, the less efficient the AC process becomes.
Resistance spot welding is widely used for joining sheet metal materials in the automotive industry. Most of the existing resistance spot welding systems are single-phase AC-based, and with constant current control. The medium frequency DC (MFDC) system with constant heat control (CHC) is new technology in the resistance spot welding industry. This system promises dramatic improvement on the spot weld quality. However, many of the CHC features are still not known and need to be explored. This paper presents an experimental study on a new MFDC/CHC spot welding system. The goal is to characterize the MFDC/CHC welding process in terms of the process parameters, including the target energy level, force, and welding time. Real time process signals such as force, current, and tip voltage were also collected and analyzed to compare with the traditional spot welding process.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.