This paper presents the expected transmission count metric (ETX), which finds high-throughput paths on multi-hop wireless networks. ETX minimizes the expected total number of packet transmissions (including retransmissions) required to successfully deliver a packet to the ultimate destination. The ETX metric incorporates the effects of link loss ratios, asymmetry in the loss ratios between the two directions of each link, and interference among the successive links of a path. In contrast, the minimum hop-count metric chooses arbitrarily among the different paths of the same minimum length, regardless of the often large differences in throughput among those paths, and ignoring the possibility that a longer path might offer higher throughput.This paper describes the design and implementation of ETX as a metric for the DSDV and DSR routing protocols, as well as modifications to DSDV and DSR which allow them to use ETX. Measurements taken from a 29-node 802.11b test-bed demonstrate the poor performance of minimum hop-count, illustrate the causes of that poor performance, and confirm that ETX improves performance. For long paths the throughput improvement is often a factor of two or more, suggesting that ETX will become more useful as networks grow larger and paths become longer.

This paper presents the expected transmission count metric (ETX), which finds high-throughput paths on multi-hop wireless networks. ETX minimizes the expected total number of packet transmissions (including retransmissions) required to successfully deliver a packet to the ultimate destination. The ETX metric incorporates the effects of link loss ratios, asymmetry in the loss ratios between the two directions of each link, and interference among the successive links of a path. In contrast, the minimum hop-count metric chooses arbitrarily among the different paths of the same minimum length, regardless of the often large differences in throughput among those paths, and ignoring the possibility that a longer path might offer higher throughput. This paper describes the design and implementation of ETX as a metric for the DSDV and DSR routing protocols, as well as modifications to DSDV and DSR which allow them to use ETX. Measurements taken from a 29node 802.11b test-bed demonstrate the poor performance of minimum hopcount, illustrate the causes of that poor performance, and confirm that ETX improves performance. For long paths the throughput improvement is often a factor of two or more, suggesting that ETX will become more useful as networks grow larger and paths become longer.

No abstract

No abstract

Existing wireless ad hoc routing protocols typically find routes with the minimum hop-count. This paper presents experimental evidence from two wireless test-beds which shows that there are usually multiple minimum hop-count paths, many of which have poor throughput. As a result, minimum-hop-count routing often chooses routes that have significantly less capacity than the best paths that exist in the network. Much of the reason for this is that many of the radio links between nodes have loss rates low enough that the routing protocol is willing to use them, but high enough that much of the capacity is consumed by retransmissions. These observations suggest that more attention be paid to link quality when choosing ad hoc routes; the paper presents measured link characteristics likely to be useful in devising a better path quality metric.