No abstract

<span>The main components of a Stand-Alone Photovoltaic (SAPV) system consists of PV array, DC-DC converter, load and the maximum power point tracking (MPPT) control algorithm. MPPT algorithm was used for extracting maximum available power from PV module under a particular environmental condition by controlling the duty ratio of DC-DC converter. Based on maximum power transfer theorem, by changing the duty cycle, the load resistance as seen by the source is varied and matched with the internal resistance of PV module at maximum power point (MPP) so as to transfer the maximum power. Under sudden changes in solar irradiance, the selection of MPPT algorithm’s sampling time (T_{S_MPPT}) is very much depends on two main components of the converter circuit namely; inductor and capacitor. As the value of these components increases, the settling time of the transient response for PV voltage and current will also increase linearly. Consequently, T_{S_MPPT}needs to be increased for accurate MPPT and therefore reduce the tracking speed. This work presents a design considerations of DC-DC Boost Converter used in SAPV system for fast and accurate MPPT algorithm. The conventional Hill Climbing (HC) algorithm has been applied to track the MPP when subjected to sudden changes in solar irradiance. By selecting the optimum value of the converter circuit components, a fast and accurate MPPT especially during sudden changes in irradiance has been realized.</span>

Abstract:In this study, electromagnetic field radiation bursts known as chaotic pulse trains (CPTs) and regular pulse trains (RPTs) generated by lightning flashes were analyzed. Through a numerical analysis it was found that a typical CPT could be generated by superimposing several RPTs onto each other. It is suggested that the chaotic pulse trains are created by a superposition of several regular pulse trains. Since regular pulse trains are probably created by dart or dart-stepped leaders or K-changes inside the cloud, chaotic pulse trains are caused by the superposition of electric fields caused by more than one of these leaders or K-changes propagating simultaneously. The hypothesis is supported by the fact that one can find regular pulse trains either in the beginning, middle or later stages of chaotic pulse trains.

No abstract

This paper presents the characteristics of the preliminary breakdown pulses (PBP) in 51 positive ground flashes recorded during 2014 summer thunderstorms in Sweden. Electric field measurements were conducted remotely using a broadband antenna system (up to 100 MHz) for a recording length of 1 s with 200 ms trigger time. In the analysis, PBP trains were observed in 86% of the cases. Based on the number of trains preceding the first return stroke, the PBP were classified into single and multiple train PBP. Characteristics of the first PBP train were determined and based on the initial polarity of the pulses, three types of PBP were identified. Characteristics of the subsequent PBP trains in the multiple train PBP were also analyzed and they were compared with the first PBP train. Based on the conceptual charge cloud configuration, we found that the inverted dipole is consistent with our observation. We also found that PBP in positive ground flashes during summer thunderstorms in Sweden are weak since the average ratios of the PBP peak to the first return stroke peak lie only between 0.21 and 0.26. Possible reasons for no detection of PBP and the different types of PBP observed were also discussed.