Objective. To evaluate the sequence of changes in articular cartilage, trabecular bone, and subchondral plate in dogs with osteoarthritis (OA), 3 months, 18 months, and 54 months after anterior cruciate ligament transection (ACLT).Methods. Specimens of the medial tibial plateau Submitted for publication May 5 , 1992; accepted in revised form February 9, 1993. were analyzed with microscopic computed tomography (micro-CT) at a resolution of 60 pm, and biochemical and morphologic changes in the femoral articular cartilage were assessed.Results. At 3 months and 18 months after ACLT, the articular cartilage in the unstable knee showed histologic changes typical of early OA and increased water content and uronic acid concentration; by 54 months, full-thickness ulceration had developed. Micro-CT analysis showed a loss of trabecular bone in the unstable knee, compared with the contralateral knee, at all time points. Al. both 18 and 54 months, the differences in trabecular thickness and surface-tovolume ratio were greater than at 3 months. Although the mean subchondral plale thickness, especially in the medial aspect of the medial tibial plateau, was greater in the OA knee than in the contralateral knee 18 months and 54 months after ACLI', these differences were not statistically significant; however, the difference was significantly greater at 54 months than at 3 months.Conclusion. Thickening of the subchondral bone is not required for the development of cartilage changes of OA in this model. The bony changes that develop after ACLT, however, could result in abnormal transmission of stress to the overlying cartilage and thereby contribute to the progression of cartilage degeneration.In the pathogenesis of osteoarthritis (OA), interactions among all the major joint tissues, including the articular cartilage, synovium, and subchondral bone, have been implicated (1). While a large body of work has focused on the alterations in the articular cartilage in OA in humans and experimental animal

No abstract

No abstract

Osteoarthritis (OA) is a common disease which affects nearly 50% of people over age 60. Histologic evaluation suggests that fibrillations approximately 20-150 microns are among the earliest changes in the articular cartilage. We propose a technique to quantify these surface fibrillatory changes in osteoarthritic articular cartilage by considering the angular distribution of the envelope-detected backscattered pressure field from an incident 30-MHz focused transducer. The angular distribution of the scattered acoustic field from an inosonifying source will directly relate to the distribution of surface fibrillatory changes. Data are presented for three different grades (400, 500 and 600 grit) of commercially available emory paper and three samples of osteoarthritic femoral head articular cartilage, which were visually assessed as having smooth, intermediate and rough surfaces, respectively. Our preliminary results indicate a probable monotonic relationship between articular cartilage roughening and the degree of broadening in the angle-dependent pressure amplitude. When applied to the emory paper, the technique indicates sensitivity to differences as small as approximately 5-10 microns in mean roughness. This procedure may provide an extremely sensitive and reproducible means of quantifying and following the cartilage changes observed in early osteoarthritis.

We have previously described a technique to quantify surface fibrillatory changes in osteoarthritic articular cartilage. In that study, the angular distribution of the scattered acoustic field from an insonifying source directly related to the distribution of surface fibrillatory changes. In the current study, we demonstrate a more sensitive method to quantify surface roughness, the effect of global surface curvature in estimating surface roughness and the utility of using focused transducers in circumventing this potential problem for in vivo work. Phantoms composed of acrylic rods with and without sandpaper grit (about 15 to 72 microns, mean particle size) applied to the surface were scanned. A more robust angular scattering technique to measure the angle dependent data was employed, in which the integrated squared pressure amplitude over a finite time window (mean power) was measured as a function of incident acoustic angle for varying surface roughnesses and radii of curvature. We show that the potential dynamic range for making roughness discriminations diminishes with decreasing radius of curvature of the acrylic rod phantoms using an unfocused transducer. This effect is minimized with use of a focused transducer. Roughness effects are most evident at sufficiently large angles where incoherent scattering dominates. We conclude that the roughness of cylindrically curved surfaces can be quantitatively assessed using a focused ultrasound beam at sufficiently large incident angles, given that the focal spot size is sufficiently smaller than the radius of curvature of the surface.

No abstract

No abstract

No abstract