No abstract

No abstract

In this study, the effectiveness of prolonged dry-heat treatment (50 degrees C) alone or in combination with chemical treatments (1% oxalic acid, 0.03% phytic acid, 50% ethanol, electrolyzed acidic water, and electrolyzed alkaline water) in eliminating Escherichia coli O157:H7 on laboratory-inoculated alfalfa, radish, broccoli, and mung bean seeds was compared with that of dry-heat treatment in combination with irradiation treatment. Dry-heat treatment for 17 or 24 h alone could reduce E. coli O157:H7 numbers to below detectable levels in radish, broccoli, and alfalfa seeds, but was unable to reduce the pathogen numbers to below the detectable level in mung bean seeds. In addition, dry-heat treatment for 17 h plus sanitizer treatments were effective in greatly reducing pathogen populations on radish, broccoli, and alfalfa seeds, without compromising the quality of the sprouts, but these treatments did not eliminate the pathogen from radish and alfalfa seeds. Seventeen hours of dry heat followed by a 1.0-kGy dose of irradiation completely eliminated E. coli O157:H7 from radish and mung bean seeds, whereas only a minimum radiation dose of 0.25 kGy was required to completely eliminate the pathogen from broccoli and alfalfa seeds. Dry heat in combination with radiation doses of up to 1.0 kGy did not negatively impact the seed germination rate or length of alfalfa, broccoli, and radish seeds or the length of alfalfa, broccoli, and radish sprouts, but did decrease the length of mung bean sprouts.

Vibrations are usually analysed by the fast Fourier transform (FFT) algorithm, and this method is effi cient for analysing frequency characteristics of vibrations during transportation. However, the nature of vibrations during transportation is nonstationary, and the FFT method is not suffi cient for dealing with such a nonstationary, time-dependent data in some cases. In this study, vibration data were analysed for non-stationary events using a wavelet algorithm. Although apparent changes in frequency characteristics of vibrations were not observed, a continuous wavelet transform suffi ciently detected the time dependence of frequency characteristics. When strong shocks were contained in vibration data, wavelet power spectra were signifi cantly increased corresponding to shocks, and the changes were over a wide range of frequencies. The analysis using discrete wavelet transform indicated that shock signals were located in several decomposition levels, and this was dependent on shock direction. Locally amplifi ed detail coeffi cients and a subsequent reconstruction successfully generated shock-added vibration data, considering the frequency characteristics of actual shocks. This procedure is expected to be used as a shock generation method in vibration tests.

Bacterial cellulose gel disintegration in the presence of (1,3)(1,4)--glucan "Nata puree," a novel food material for upgrading vegetable powders, made by bacterial cellulose gel disintegration in the presence of (1,3)(1,4)--glucan

The majority of almond-related foodborne outbreaks have been associated with Salmonella. Therefore, it is necessary to find an effective method to inactivate these organisms on raw almond prior to market distribution. This study was conducted to assess the effectiveness of sanitizers (strong or mild electrolyzed water, ozonated water, and distilled water), dry heat treatment, and hot water treatments followed by catalytic infrared (IR) heat treatment to inactivate Salmonella populations on raw almond. Raw almonds inoculated with four-strain cocktails of Salmonella were treated either by soaking in different chemical sanitizers or with dry heat and/or hot water for various periods of time followed by catalytic IR heat treatment for 70 seconds. The treated seeds were then assessed for the efficacy of the treatment in reducing populations of the pathogens. After inoculation and air-drying, 5.73 +/- 0.12 log colony-forming units (CFU)/g Salmonella were detected in nonselective medium. Sanitizer treatment alone did not show significant reduction in the Salmonella population, but in combination with IR drying it reduced the population to 3.0 log CFU/g. Dry heating at 60 degrees C for 4 days followed by IR drying for 70 seconds reduced the Salmonella population an additional 1.0 log CFU/g. Hot water treatments at 85 degrees C for 40 seconds followed by IR drying for 70 seconds reduced pathogens to an undetectable level by direct plating, but not by enrichment.

The use of a suitable sanitizer can reduce the risk of produce-related foodborne illnesses. We evaluated the effectiveness of several sanitizers to reduce inoculated Escherichia coli O157:H7 on the surface of cherry tomatoes (Solanum lycopersicum var. cerasiform). Depending on the method of inoculation (dipping/spotting), each of 80 g (eight tomatoes) of inoculated cherry tomatoes was washed in 400 mL of sanitizer solutions or 400 mL distilled water for 5 minutes. The effectiveness of sanitizers on spot-inoculated E. coli O157:H7 on tomato surfaces was found higher than on dip-inoculated tomatoes. Washing with water or chlorine water (0.1 g/L as free chlorine) could reduce 1.3 log CFU/g of E. coli O157:H7 in dip-inoculated (6.8 log CFU/g) tomatoes. Washing with lactic acid (LA) solution (1.0 g/L), phytic acid solution (1.0 g/L), calcinated seashells (oyster/sakhalin surf clam), and 1.0 g/L chitosan in 0.5 g/L LA (Chito) did not exhibit a significant higher effectiveness than that of water wash alone (1.0 log CFU/g). Acidified sodium chlorite (ASC) solution prepared from 0.5 g/L of sodium chlorite and 1.0 g/L LA or phytic acid reduced 3.5 log CFU/g of E. coli O157:H7 in dip-inoculated tomato surfaces. ASC (0.5 g/L of sodium chlorite and 1.0 g/L of LA) wash followed by a second wash with LA exhibited an additional sanitary effectiveness compared to a single wash with ASC. However, washing with ASC followed by a second wash with Chito exhibited an additional 1.0 log CFU/g reduction compared to a secondary wash with water. No significant difference of color, taste, and texture was observed among the washed cherry tomatoes.

The majority of the seed sprout-related outbreaks have been associated with Escherichia coli O157:H7 and Salmonella. Therefore, an effective method for inactivating these organisms on the seeds before sprouting is needed. The current pasteurization method for mung beans in Japan (hot water treatment at 85 degrees C for 10 s) was more effective for disinfecting inoculated E. coli O157:H7, Salmonella, and nonpathogenic E. coli on mung bean seeds than was the calcium hypochlorite treatment (20,000 ppm for 20 min) recommended by the U.S. Food and Drug Administration. Hot water treatment at 85 degrees C for 40 s followed by dipping in cold water for 30 s and soaking in chlorine water (2,000 ppm) for 2 h reduced the pathogens to undetectable levels, and no viable pathogens were found in a 25-g enrichment culture and during the sprouting process. Practical tests using a working pasteurization machine with nonpathogenic E. coli as a surrogate produced similar results. The harvest yield of the treated seed was within the acceptable range. These treatments could be a viable alternative to the presently recommended 20,000-ppm chlorine treatment for mung bean seeds.