When a rugby coach provides tackling instructions to players, it is advantageous to have information about the kinematics of different types of tackles.
The objectives of this study were to investigate middle finger movements and dynamics of ball movements around the instant of ball release during baseball pitching. Baseball pitching from an indoor mound among 14 semi-professional pitchers was captured using a motion capture system with 16 high-speed cameras (1,000 Hz). Kinematics of middle finger joints, ball rotation, and force applied to the ball were calculated. The proximal and distal interphalangeal joints continued to extend until the instant of ball release, then abruptly flexed. The abrupt flexion lasted for only several milliseconds, followed by a short extension phase. The finger made a quick double cycle of extension-flexion movement, suggesting that it attained high stiffness resulting from co-contraction. The ball began to roll up to the tip of the finger 8 ± 1 ms before ball release owing to the start of extension or the increased angular velocity of extension for the proximal interphalangeal joint. A mean force of 195 ± 27 N was applied in the proximal direction of the hand at the same time as the beginning of ball rolling, and a mean force of 109 ± 22 N was applied to the throwing direction just before ball release.
This study aimed to determine whether covariations among joint movements are utilized to stabilize hand orientation and movement and to determine which of the upper or lower extremities make effective use of the covariation. Joint angles during pitching were measured in 12 skilled baseball pitchers, using a motion capture system. The joint angles in 10 successful trials were used for the reconstructed motions. The reconstructed motion in the first condition was the same as for the measured motion. In the second condition, the reconstructed motion was generated with joint angles that were pseudo-randomly selected to artificially break off covariation in the measured joint-angle combination. In the third and fourth conditions, the reconstructed motions were generated with the same joint-angle combinations as the measured angles in the throwing arm and the stride leg, respectively, but pseudo-randomly selected in the other joint angles. Ten reconstructed motions were generated for each condition. Standard deviations (SDs) of hand orientation and movement direction were calculated and compared among the conditions. All SDs for the first condition were the smallest among the conditions, indicating that the movements in the measured condition used the covariation in joint angles to make the hand movement stable. The results also illustrated that some SDs in the fourth condition were smaller than those in the third condition, suggesting that the lower extremity made effective use of the covariation. These results imply that it is necessary not only to reduce variability in each joint but also to regulate joint movements to stabilize hand orientation and movement.
This study was conducted to determine whether a supination phase of the forearm exists around ball release (BRL), and, if present, to determine whether this supination is explained by a reaction force or by the body configuration required for this task. A 16-camera motion analysis system with a sampling frequency of 1,000 Hz recorded 20 healthy male semi-professional pitchers pitching from an indoor pitching mound. A short supination phase around BRL was confirmed for all participants in the current study. Correlation analyses revealed that the supination angle at BRL had significant relationships with several measurements of shoulder movement kinematics. Mechanical work analysis of the forearm's longitudinal axis revealed several variations in joint power curve and various patterns of mechanical work among the participants, suggesting that a reaction force originating from accelerating a ball might not be the main cause of supination. The raw data also were down-sampled to a sampling frequency of 250 Hz, to match previous studies and to investigate the discrepancy among previous studies concerning the existence of the supination phase. The experience of participants and methodological differences, such as the definition of BRL and the time-normalisation technique, influenced whether the supination phase was observed.
Abstract:The purpose of this study was to quantify the functional roles of the whole-body's joint torques including fingers' joints in the generation of ball speed and spin during baseball fast-ball pitching motion. The dynamic contributions of joint torque term, gravitational term, and motion-dependent term (MDT) consisting of centrifugal force and Coriolis force, to the generation of the ball variables were calculated using two types of models. Motion and ground reaction forces of a baseball pitcher, who was instructed to throw a fastball into the target, were measured with a motion capture system with two force platforms. The results showed (1) the MDT is the largest contributor to ball speed (e.g., about 31 m/s prior to ball release) when using 16-segment model, and (2) the horizontal adduction torque of pitching-side shoulder joint plays a crucial role in generating ball speed with conversion of the MDT into other terms using a recurrence formula.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.